A QoS-Driven ISP Selection Mechanism for IPv6 Multi-homed Sites

A global solution for the provision of QoS in IPng sites must include ISP selection based on per-application requirements. In this article we present a new site-local architecture for QoS-driven ISP selection in multi-homed domains, performed in a per application basis. This architecture proposes the novel use of existent network services, a new type of routing header, and the modification of address selection mechanisms to take into account QoS requirements. This proposal is an evolution of current technology, and therefore precludes the addition of new protocols, enabling fast deployment. The sitelocal scope of the proposed solution results in ISP transparency and thus in ISP independency.This research was supported by the LONG (Laboratories Over the Next Generation Networks) project IST-1999-20393.Publicad

Preserving Established Communications in IPv6 Multi-homed Sites with MEX

This research was supported by the SAM (Advanced Mobility Services) project, funded by the Spanish National R&D Programme under contract MCYT TIC2002-04531-C04-03.A proper support for multimedia communications transport has to provide fault tolerance capabilities such as the preservation of established connections in case of failures. While multi-homing addresses this issue, the currently available solution based in massive BGP route injection presents serious scalability limitations, since it contributes to the exponential growth of the BGP table size. Alternative solutions proposed for IPv6 fail to provide equivalent facilities to the current BGP based solution. In this paper we present MEX (Muti-homing through EXtension header) a novel proposal for the provision of IPv6 multi-homing capabilities. MEX preserves overall scalability by storing alternative route information in end-hosts while at the same time reduces packet loss by allowing routers to re-route in-course packets. This behavior is enabled by conveying alternative route information within packets inside a newly defined Extension Header. The resulting system provides fault tolerance capabilities and preserves scalability, while the incurred costs, namely deployment and packet overhead, are only imposed to those that benefit from it. An implementation of the MEX host and router components is also presented.Publicad

Traffic engineering in multihomed sites

It is expected that IPv6 multihomed sites will obtain as many global prefixes as direct providers they have, so traffic engineering techniques currently used in IPv4 multihomed sites is no longer suitable. However, traffic engineering is required for several reasons, and in particular, for being able to properly support multimedia communications. In this paper we present a framework for traffic engineering in IPv6 multihomed sites with multiple global prefixes. Within this framework, we have included several tools such as DNS record manipulation and proper configuration of the policy table defined in RFC 3484. To provide automation in the management of traffic engineering, we analyzed the usage of two mechanisms to configure the policy table.This work has been partly supported by the European Union under the E-Next Project FP6-506869 and by the OPTINET6 project TIC-2003-09042-C03-01.Publicad

End-Site Routing Support for IPv6 Multihoming

Multihoming is currently widely used to provide fault tolerance and traffic engineering capabilities. It is expected that, as telecommunication costs decrease, its adoption will become more and more prevalent. Current multihoming support is not designed to scale up to the expected number of multihomed sites, so alternative solutions are required, especially for IPv6. In order to preserve interdomain routing scalability, the new multihoming solution has to be compatible with Provider Aggregatable addressing. However, such addressing scheme imposes the configuration of multiple prefixes in multihomed sites, which in turn causes several operational difficulties within those sites that may even result in communication failures when all the ISPs are working properly. In this paper we propose the adoption of Source Address Dependent routing within the multihomed site to overcome the identified difficulties.Publicad

Multi-homing tunnel broker

A proper support for communications has to provide fault tolerance capabilities such as the preservation of established connections in case of failures. Multihoming addresses this issue, but the currently available solution based in massive BGP route injection presents serious scalability limitations, since it contributes to the exponential growth of the BGP table size. An alternative solution based on the configuration of tunnels between the multihomed site exit routers and the ISP border routers has been proposed for IPv6 in RFC 3178. However, the amount of manual configuration imposed by this solution on the ISP side prevents its wide adoption. In particular, this solution requires at the ISP the manual configuration of a tunnel endpoint per each multihomed client that it serves. We present a multihoming tunnel broker (MHTB) that provides automatic creation of the tunnel endpoint at the ISP side.This work was supported by the SAM (Advanced Servers with Mobility)project, funded by the Spanish National research and Development Programme as TIC2002-04531-C04-03.Publicad

Network layer access control for context-aware IPv6 applications

As part of the Lancaster GUIDE II project, we have developed a novel wireless access point protocol designed to support the development of next generation mobile context-aware applications in our local environs. Once deployed, this architecture will allow ordinary citizens secure, accountable and convenient access to a set of tailored applications including location, multimedia and context based services, and the public Internet. Our architecture utilises packet marking and network level packet filtering techniques within a modified Mobile IPv6 protocol stack to perform access control over a range of wireless network technologies. In this paper, we describe the rationale for, and components of, our architecture and contrast our approach with other state-of-the- art systems. The paper also contains details of our current implementation work, including preliminary performance measurements

Towards a reliable seamless mobility support in heterogeneous IP networks

This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.Next Generation networks (3G and beyond) are evolving towards all IP based systems with the aim to provide global coverage. For Mobility in IP based networks, Mobile IPv6 is considered as a standard by both industry and research community, but this mobility protocol has some reliability issues. There are a number of elements that can interrupt the communication between Mobile Node (MN) and Corresponding Node (CN), however the scope of this research is limited to the following issues only: • Reliability of Mobility Protocol • Home Agent Management • Handovers • Path failures between MN and CN First entity that can disrupt Mobile IPv6 based communication is the Mobility Anchor point itself, i.e. Home Agent. Reliability of Home Agent is addressed first because if this mobility agent is not reliable there would be no reliability of mobile communication. Next scenario where mobile communication can get disrupted is created by MN itself and it is due to its mobility. When a MN moves around, at some point it will be out of range of its active base station and at the same time it may enter the coverage area of another base station. In such a situation, the MN should perform a handover, which is a very slow process. This handover delay is reduced by introducing a “make before break” style handover in IP network. Another situation in which the Mobile IPv6 based communication can fail is when there is a path failure between MN and CN. This situation can be addressed by utilizing multiple interfaces of MN at the same time. One such protocol which can utilize multiple interfaces is SHIM6 but it was not designed to work on mobile node. It was designed for core networks but after some modification in the protocol , it can be deployed on mobile nodes. In this thesis, these issues related to reliability of IPv6 based mobile communication have been addressed