1,054 research outputs found
Hardware Impairments Aware Transceiver Design for Full-Duplex Amplify-and-Forward MIMO Relaying
In this work we study the behavior of a full-duplex (FD) and
amplify-and-forward (AF) relay with multiple antennas, where hardware
impairments of the FD relay transceiver is taken into account. Due to the
inter-dependency of the transmit relay power on each antenna and the residual
self-interference in an FD-AF relay, we observe a distortion loop that degrades
the system performance when the relay dynamic range is not high. In this
regard, we analyze the relay function in presence of the hardware inaccuracies
and an optimization problem is formulated to maximize the signal to
distortion-plus-noise ratio (SDNR), under relay and source transmit power
constraints. Due to the problem complexity, we propose a
gradient-projection-based (GP) algorithm to obtain an optimal solution.
Moreover, a nonalternating sub-optimal solution is proposed by assuming a
rank-1 relay amplification matrix, and separating the design of the relay
process into multiple stages (MuStR1). The proposed MuStR1 method is then
enhanced by introducing an alternating update over the optimization variables,
denoted as AltMuStR1 algorithm. It is observed that compared to GP, (Alt)MuStR1
algorithms significantly reduce the required computational complexity at the
expense of a slight performance degradation. Finally, the proposed methods are
evaluated under various system conditions, and compared with the methods
available in the current literature. In particular, it is observed that as the
hardware impairments increase, or for a system with a high transmit power, the
impact of applying a distortion-aware design is significant.Comment: Submitted to IEEE Transactions on Wireless Communication
Nuts and Bolts of a Realistic Stochastic Geometric Analysis of mmWave HetNets: Hardware Impairments and Channel Aging
© 2019 IEEE.Motivated by heterogeneous network (HetNet) design in improving coverage and by millimeter-wave (mmWave) transmission offering an abundance of extra spectrum, we present a general analytical framework shedding light on the downlink of realistic mmWave HetNets consisting of K tiers of randomly located base stations. Specifically, we model, by virtue of stochastic geometry tools, the multi-Tier multi-user (MU) multiple-input multiple-output (MIMO) mmWave network degraded by the inevitable residual additive transceiver hardware impairments (RATHIs) and channel aging. Given this setting, we derive the coverage probability and the area spectral efficiency (ASE), and we subsequently evaluate the impact of residual transceiver hardware impairments and channel aging on these metrics. Different path-loss laws for line-of-sight and non-line-of-sight are accounted for the analysis, which are among the distinguishing features of mmWave systems. Among the findings, we show that the RATHIs have a meaningful impact at the high-signal-To-noise-ratio regime, while the transmit additive distortion degrades further than the receive distortion the system performance. Moreover, serving fewer users proves to be preferable, and the more directive the mmWaves are, the higher the ASE becomes.Peer reviewedFinal Accepted Versio
A Survey of Physical Layer Security Techniques for 5G Wireless Networks and Challenges Ahead
Physical layer security which safeguards data confidentiality based on the
information-theoretic approaches has received significant research interest
recently. The key idea behind physical layer security is to utilize the
intrinsic randomness of the transmission channel to guarantee the security in
physical layer. The evolution towards 5G wireless communications poses new
challenges for physical layer security research. This paper provides a latest
survey of the physical layer security research on various promising 5G
technologies, including physical layer security coding, massive multiple-input
multiple-output, millimeter wave communications, heterogeneous networks,
non-orthogonal multiple access, full duplex technology, etc. Technical
challenges which remain unresolved at the time of writing are summarized and
the future trends of physical layer security in 5G and beyond are discussed.Comment: To appear in IEEE Journal on Selected Areas in Communication
Towards a Realistic Assessment of Multiple Antenna HCNs: Residual Additive Transceiver Hardware Impairments and Channel Aging
Given the critical dependence of broadcast channels by the accuracy of
channel state information at the transmitter (CSIT), we develop a general
downlink model with zero-forcing (ZF) precoding, applied in realistic
heterogeneous cellular systems with multiple antenna base stations (BSs).
Specifically, we take into consideration imperfect CSIT due to pilot
contamination, channel aging due to users relative movement, and unavoidable
residual additive transceiver hardware impairments (RATHIs). Assuming that the
BSs are Poisson distributed, the main contributions focus on the derivations of
the upper bound of the coverage probability and the achievable user rate for
this general model. We show that both the coverage probability and the user
rate are dependent on the imperfect CSIT and RATHIs. More concretely, we
quantify the resultant performance loss of the network due to these effects. We
depict that the uplink RATHIs have equal impact, but the downlink transmit BS
distortion has a greater impact than the receive hardware impairment of the
user. Thus, the transmit BS hardware should be of better quality than user's
receive hardware. Furthermore, we characterise both the coverage probability
and user rate in terms of the time variation of the channel. It is shown that
both of them decrease with increasing user mobility, but after a specific value
of the normalised Doppler shift, they increase again. Actually, the time
variation, following the Jakes autocorrelation function, mirrors this effect on
coverage probability and user rate. Finally, we consider space division
multiple access (SDMA), single user beamforming (SU-BF), and baseline
single-input single-output (SISO) transmission. A comparison among these
schemes reveals that the coverage by means of SU-BF outperforms SDMA in terms
of coverage.Comment: accepted in IEEE TV
Massive MIMO Full-Duplex Relaying with Optimal Power Allocation for Independent Multipairs
With the help of an in-band full-duplex relay station, it is possible to
simultaneously transmit and receive signals from multiple users. The
performance of such system can be greatly increased when the relay station is
equipped with a large number of antennas on both transmitter and receiver
sides. In this paper, we exploit the use of massive arrays to effectively
suppress the loopback interference (LI) of a decode-and-forward relay (DF) and
evaluate the performance of the end-to-end (e2e) transmission. This paper
assumes imperfect channel state information is available at the relay and
designs a minimum mean-square error (MMSE) filter to mitigate the interference.
Subsequently, we adopt zero-forcing (ZF) filters for both detection and
beamforming. The performance of such system is evaluated in terms of bit error
rate (BER) at both relay and destinations, and an optimal choice for the
transmission power at the relay is shown. We then propose a complexity
efficient optimal power allocation (OPA) algorithm that, using the channel
statistics, computes the minimum power that satisfies the rate constraints of
each pair. The results obtained via simulation show that when both MMSE
filtering and OPA method are used, better values for the energy efficiency are
attained.Comment: Accepted to the 16th IEEE International Workshop on Signal Processing
Advances in Wireless Communications - SPAWC, Stockholm, Sweden 201
Hardware Impairments Aware Transceiver Design for Bidirectional Full-Duplex MIMO OFDM Systems
In this paper we address the linear precoding and decoding design problem for
a bidirectional orthogonal frequencydivision multiplexing (OFDM) communication
system, between two multiple-input multiple-output (MIMO) full-duplex (FD)
nodes. The effects of hardware distortion as well as the channel state
information error are taken into account. In the first step, we transform the
available time-domain characterization of the hardware distortions for FD MIMO
transceivers to the frequency domain, via a linear Fourier transformation. As a
result, the explicit impact of hardware inaccuracies on the residual
selfinterference (RSI) and inter-carrier leakage (ICL) is formulated in
relation to the intended transmit/received signals. Afterwards, linear
precoding and decoding designs are proposed to enhance the system performance
following the minimum-mean-squarederror (MMSE) and sum rate maximization
strategies, assuming the availability of perfect or erroneous CSI. The proposed
designs are based on the application of alternating optimization over the
system parameters, leading to a necessary convergence. Numerical results
indicate that the application of a distortionaware design is essential for a
system with a high hardware distortion, or for a system with a low thermal
noise variance.Comment: Submitted to IEEE for publicatio
- …