Adaptive Nonlinear RF Cancellation for Improved Isolation in Simultaneous Transmit-Receive Systems

This paper proposes an active radio frequency (RF) cancellation solution to suppress the transmitter (TX) passband leakage signal in radio transceivers supporting simultaneous transmission and reception. The proposed technique is based on creating an opposite-phase baseband equivalent replica of the TX leakage signal in the transceiver digital front-end through adaptive nonlinear filtering of the known transmit data, to facilitate highly accurate cancellation under a nonlinear TX power amplifier (PA). The active RF cancellation is then accomplished by employing an auxiliary transmitter chain, to generate the actual RF cancellation signal, and combining it with the received signal at the receiver (RX) low noise amplifier (LNA) input. A closed-loop parameter learning approach, based on the decorrelation principle, is also developed to efficiently estimate the coefficients of the nonlinear cancellation filter in the presence of a nonlinear TX PA with memory, finite passive isolation, and a nonlinear RX LNA. The performance of the proposed cancellation technique is evaluated through comprehensive RF measurements adopting commercial LTE-Advanced transceiver hardware components. The results show that the proposed technique can provide an additional suppression of up to 54 dB for the TX passband leakage signal at the RX LNA input, even at considerably high transmit power levels and with wide transmission bandwidths. Such novel cancellation solution can therefore substantially improve the TX-RX isolation, hence reducing the requirements on passive isolation and RF component linearity, as well as increasing the efficiency and flexibility of the RF spectrum use in the emerging 5G radio networks.Comment: accepted to IEE

Novel High Isolation Antennas for Simultaneous Transmit and Receive (STAR) Applications

Radio frequency (RF) spectrum congestion is a major challenge for the growing need of wireless bandwidth. Notably, in 2015, the Federal Communications Commission (FCC) auctioned just 65 MHz (a bandwidth smaller than that used for WiFi) for more than $40 billion, indicating the high value of the microwave spectrum. Current radios use one-half of their bandwidth resource for transmission, and the other half for reception. Therefore, by enabling radios to transmit and receive across their entire bandwidth allocation, spectral efficiency is doubled. Concurrently, data rates for wireless links also double. This technology leads to a new class of radios and RF frontends. Current full-duplex techniques resort to either time- or frequency-division duplexing (TDD and FDD respectively) to partition the transmit and receive functions across time and frequency, respectively, to avoid self-interference. But these approaches do not translate to spectral efficiency. Simultaneous transmit and receive (STAR) radios must isolate the transmitter from the receiver to avoid self-interference (SI). This SI prevents reception and must therefore be cancelled. Self-interference may be cancelled with one or more stages involving the antenna, RF or analog circuits, or digital filters. With this in mind, the antenna stage is the most critical to reduce the SI level and avoid circuit saturation and total system failure. This dissertation presents techniques for achieving STAR radios. The initial sections of the dissertation provide the general approach of stage to stage cancellation to achieve as much as 100 dB isolation between the receiver and transmitter. The subsequent chapters focus on different antennas to achieve strong transmit/receive isolation. As much as 35 dB isolation is shown using a new spiral antenna array with operation across a 2:1 bandwidth. Also, a new antenna feed is presented showing 42 dB isolation across a 250 MHz bandwidth. Reflections in the presence of a dynamic environment are also considered

Full-Duplex Systems Using Multi-Reconfigurable Antennas

Full-duplex systems are expected to achieve 100% rate improvement over half-duplex systems if the self-interference signal can be significantly mitigated. In this paper, we propose the first full-duplex system utilizing Multi-Reconfigurable Antenna (MRA) with ?90% rate improvement compared to half-duplex systems. MRA is a dynamically reconfigurable antenna structure, that is capable of changing its properties according to certain input configurations. A comprehensive experimental analysis is conducted to characterize the system performance in typical indoor environments. The experiments are performed using a fabricated MRA that has 4096 configurable radiation patterns. The achieved MRA-based passive self-interference suppression is investigated, with detailed analysis for the MRA training overhead. In addition, a heuristic-based approach is proposed to reduce the MRA training overhead. The results show that at 1% training overhead, a total of 95dB self-interference cancellation is achieved in typical indoor environments. The 95dB self-interference cancellation is experimentally shown to be sufficient for 90% full-duplex rate improvement compared to half-duplex systems.Comment: Submitted to IEEE Transactions on Wireless Communication

Techniques for Achieving High Isolation in RF Domain for Simultaneous Transmit and Receive

With the growth of wireless data traffic, additional spectrum is required to meet consumer demands. Consequently, innovative approaches are needed for efficient management of the available limited spectrum. To double the achievable spectral efficiency, a transceiver can be designed to receive and transmit signals simultaneously (STAR) across the same frequency band. However, due to the coupling of the high power transmitted signal into the collocated receiver, the receiver\u27s performance is degraded. For successful STAR realization, the coupled high-power transmit (Tx) signal should be suppressed by 100-120 dB over the entire operational bandwidth. So far, most STAR implementations are narrowband, and not useful for ultra wideband (UWB) communications. In this paper, we present a review of novel approaches employed to achieve improved cancellation across wide bandwidths in RF and propagation domains. Both single and multi-antenna systems are considered. Measurements show an average cancellation of 50 dB using two stages of RF signal cancellation

Antenna/Propagation Domain Self-Interference Cancellation (SIC) for In-Band Full-Duplex Wireless Communication Systems.

In-band full duplex (IBFD) is regarded as one of the most significant technologies for addressing the issue of spectrum scarcity in 5G and beyond systems. In the realization of practical IBFD systems, self-interference, i.e., the interference that the transmitter causes to the collocated receiver, poses a major challenge to antenna designers; it is a prerequisite for applying other self-interference cancellation (SIC) techniques in the analog and digital domains. In this paper, a comprehensive survey on SIC techniques in the antenna/propagation (AP) domain is provided and the pros and cons of each technique are studied. Opportunities and challenges of employing IBFD antennas in future wireless communications networks are discussed

Design of RF Self-interference Cancellation Circuit for 100-W Full-Duplex Radio at 225-400 MHz

The full-duplex (FD) technology enables future military radios to simultaneously transmit and receive (STAR) on the same and adjacent frequencies. This enhances spectral efficiency and makes simultaneous integrated tactical communications and electronic warfare operations possible as opposed to the current time- or frequency-division radios used in military applications. The main challenge in implementing full-duplex radios is the strong self-interference (SI) between the transmitter and the receiver requiring solutions how to cancel the coupling, which has been largely resolved at higher ultra high frequency (UHF) bands for low power transmission. This paper presents a radio-frequency SI cancellation circuit suitable especially for very high-power military applications at military-relevant lower UHF band (225-400 MHz). The circuit couples power from the transmitter and tunes the phase and amplitude of the signal to destructively combine with the received SI, and thus isolates the receiver and transmitter. The paper introduces a concept consisting of a 90° vector modulator and switchable delay lines for a low-loss and high-power-handling cancellation circuit that enables operation with very-high transmit powers of even up to 1 kW.acceptedVersionPeer reviewe

RF self-interference canceller prototype for 100-W full-duplex operation at 225-400 MHz

Military applications require more and different characteristics from in-band full-duplex radio technology than what the research prototypes developed for civil/commercial applications can offer. While the challenge of cancelling the strong transmit-receive coupling, i.e., self-interference (SI), in a full-duplex radio has been largely resolved at higher ultra high frequency (UHF) bands for low-power transmission, tactical communication and electronic warfare applications require major research efforts toward supporting lower military-relevant frequencies and significantly higher transmission power levels. In this paper, we present a prototype of a radio-frequency SI cancellation circuit for the lower UHF band at 225-400 MHz and transmit power of up to 100-200 W. The experimental results demonstrate that the canceller can suppress SI by 40-50 dB depending on the operation frequency within the band. It is targeted for the military application of simultaneous full-duplex jamming and interception of communications, where we can estimate that a 5-W signal-of-interest could be intercepted from 10 km away when simultaneously jamming with 100 W power.publishedVersionPeer reviewe