Experimental Performance Analysis of Routing Metrics in Wireless Mesh Networks

International audienceThis paper provides a description of a wireless mesh network testbed setup and a measurement-based performance evaluation of the Optimized Link State Routing (OLSR) protocol [7] under three different routing metrics. The considered metrics include hop-count, ETX and ETT. The network performances are evaluated in an indoor testbed formed by heterogeneous MIMO devices. A part of our tests was about the impact of 802.11n features on the network performances showing the importance of lower layers consideration. Our measurements point out the shortcoming of each metric and eventual optimizations towards a more efficient routing. Experimental results show that OLSRETT outperforms OLSR-ETX and OLSR-hopcount significantly in terms of packet loss, end-to-end delay, and efficiency

Implementation and evaluation of a simulation system based on particle swarm optimisation for node placement problem in wireless mesh networks

With the fast development of wireless technologies, wireless mesh networks (WMNs) are becoming an important networking infrastructure due to their low cost and increased high speed wireless internet connectivity. This paper implements a simulation system based on particle swarm optimisation (PSO) in order to solve the problem of mesh router placement in WMNs. Four replacement methods of mesh routers are considered: constriction method (CM), random inertia weight method (RIWM), linearly decreasing Vmax method (LDVM) and linearly decreasing inertia weight method (LDIWM). Simulation results are provided, showing that the CM converges very fast, but has the worst performance among the methods. The considered performance metrics are the size of giant component (SGC) and the number of covered mesh clients (NCMC). The RIWM converges fast and the performance is good. The LDIWM is a combination of RIWM and LDVM. The LDVM converges after 170 number of phases but has a good performance.Peer ReviewedPostprint (author's final draft

A GA-based simulation system for WMNs: comparison analysis for different number of flows, client distributions, DCF and EDCA functions

In this paper, we compare the performance of Distributed Coordination Function (DCF) and Enhanced Distributed Channel Access (EDCA) for normal and uniform distributions of mesh clients considering two Wireless Mesh Network (WMN) architectures. As evaluation metrics, we consider throughput, delay, jitter and fairness index metrics. For simulations, we used WMN-GA simulation system, ns-3 and Optimized Link State Routing. The simulation results show that for normal distribution, the throughput of I/B WMN is higher than Hybrid WMN architecture. For uniform distribution, in case of I/B WMN, the throughput of EDCA is a little bit higher than Hybrid WMN. However, for Hybrid WMN, the throughput of DCF is higher than EDCA. For normal distribution, the delay and jitter of Hybrid WMN are lower compared with I/B WMN. For uniform distribution, the delay and jitter of both architectures are almost the same. However, in the case of DCF for 20 flows, the delay and jitter of I/B WMN are lower compared with Hybrid WMN. For I/B architecture, in case of normal distribution the fairness index of DCF is higher than EDCA. However, for Hybrid WMN, the fairness index of EDCA is higher than DCF. For uniform distribution, the fairness index of few flows is higher than others for both WMN architectures.Peer ReviewedPostprint (author's final draft

Predicting topology propagation messages in mobile ad hoc networks: The value of history

This research was funded by the Spanish Government under contracts TIN2016-77836-C2-1-R,TIN2016-77836-C2-2-R, and DPI2016-77415-R, and by the Generalitat de Catalunya as Consolidated ResearchGroups 2017-SGR-688 and 2017-SGR-990.The mobile ad hoc communication in highly dynamic scenarios, like urban evacuations or search-and-rescue processes, plays a key role in coordinating the activities performed by the participants. Particularly, counting on message routing enhances the communication capability among these actors. Given the high dynamism of these networks and their low bandwidth, having mechanisms to predict the network topology offers several potential advantages; e.g., to reduce the number of topology propagation messages delivered through the network, the consumption of resources in the nodes and the amount of redundant retransmissions. Most strategies reported in the literature to perform these predictions are limited to support high mobility, consume a large amount of resources or require training. In order to contribute towards addressing that challenge, this paper presents a history-based predictor (HBP), which is a prediction strategy based on the assumption that some topological changes in these networks have happened before in the past, therefore, the predictor can take advantage of these patterns following a simple and low-cost approach. The article extends a previous proposal of the authors and evaluates its impact in highly mobile scenarios through the implementation of a real predictor for the optimized link state routing (OLSR) protocol. The use of this predictor, named OLSR-HBP, shows a reduction of 40–55% of topology propagation messages compared to the regular OLSR protocol. Moreover, the use of this predictor has a low cost in terms of CPU and memory consumption, and it can also be used with other routing protocols.Peer ReviewedPostprint (published version

Near Optimal Channel Assignment for Interference Mitigation in Wireless Mesh Networks

In multi-radio multi-channel (MRMC) WMNs, interference alleviation is affected through several network design techniques e.g., channel assignment (CA), link scheduling, routing etc., intelligent CA schemes being the most effective tool for interference mitigation. CA in WMNs is an NP-Hard problem, and makes optimality a desired yet elusive goal in real-time deployments which are characterized by fast transmission and switching times and minimal end-to-end latency. The trade-off between optimal performance and minimal response times is often achieved through CA schemes that employ heuristics to propose efficient solutions. WMN configuration and physical layout are also crucial factors which decide network performance, and it has been demonstrated in numerous research works that rectangular/square grid WMNs outperform random or unplanned WMN deployments in terms of network capacity, latency, and network resilience. In this work, we propose a smart heuristic approach to devise a near-optimal CA algorithm for grid WMNs (NOCAG). We demonstrate the efficacy of NOCAG by evaluating its performance against the minimal-interference CA generated through a rudimentary brute-force technique (BFCA), for the same WMN configuration. We assess its ability to mitigate interference both, theoretically (through interference estimation metrics) and experimentally (by running rigorous simulations in NS-3). We demonstrate that the performance of NOCAG is almost as good as the BFCA, at a minimal computational overhead of O(n) compared to the exponential of BFCA

A testbed for MANETs: Implementation, experiences and learned lessons

In this paper, we present the implementation, experiences and lessons learned of our tesbed for Ad-hoc networks and Mobile Ad hoc Networks (MANETs). We used OLSR protocol for real experimental evaluation. We investigate the effect of mobility and topology changing in the throughput of a MANET. We study the impact of best-effort traffic for Mesh Topology and Linear Topology. In this work, we consider eight experimental models and we assess the performance of our testbed in terms of throughput, round trip time and packet loss. We found that some of the OLSR's problems can be solved, for instance the routing loop, but this protocol still has the self-interference problem. Also, there is an intricate interdependence between MAC layer and routing layer. We carried out the experiments considering stationary nodes of an Ad-hoc network and the node mobility of MANETs. We found that throughput of TCP was improved by reducing Link Quality Window Size (LQWS). For TCP data flow, we got better results when the LQWS value was 10. Moreover, we found that the node join and leave operations increase the packet loss. The OLSR protocol has a good performance when the source node is moving. However, the performance is not good when the relay nodes are moving.Peer ReviewedPostprint (published version