Miniaturized spectrometer radiometer based on MMIC technology for tropospheric water vapor profiling, A

Includes bibliographical references.The fabrication of a miniaturized ground-based water vapor profiling radiometer demonstrates the capability of monolithic microwave and millimeter-wave integrated circuit technology to reduce the mass and volume of microwave remote sensing instrumentation and to reduce substantially the necessary operational power consumption and size of the radiofrequency and intermediate-frequency sections. Since those sections comprise much of the mass and volume of current microwave receivers, the fabrication of this system represents an important contribution to the design of microwave radiometers. This miniaturized radiometer implementation is particularly well suited to benefit from the cost savings associated with mass production. The small size of the radiometer (24 × 18 × 16 cm) reduces the power required by the temperature control system and allows a rapid warm-up to the temperature set point as well as maintenance of a highly stable internal temperature. Exhibiting very similar statistical properties, the four channels of the radiometer have measured Allan times of greater than 40 s. Measurement results demonstrate that the instrument achieves a sensitivity of better than 0.2 K for 3 s of integration time. Preliminary comparisons of measured brightness temperatures with simulation results based on radiosonde data show good agreement, which are consistent with previously reported results.This work was supported by the National Science Foundation under Grant ATM-0456270 to Colorado State University and Grant ATM-0239722 to the University of Massachusetts Amherst

Atmospheric Instrument Systems and Technology in the Goddard Earth Sciences Division

Studies of the Earths atmosphere require a comprehensive set of observations that rely on instruments flown on spacecraft, aircraft, and balloons as well as those deployed on the surface. Within NASAs Goddard Space Flight Center (GSFC) Earth Sciences Division-Atmospheres, laboratories and offices maintain an active program of instrument system development and observational studies that provide: 1) information leading to a basic understanding of atmospheric processes and their relationships with the Earths climate system, 2) prototypes for future flight instruments, 3) instruments to serve as calibration references for satellite missions, and 4) instruments for future field validation campaigns that support ongoing space missions. Our scientists participate in all aspects of instrument activity, including component and system design, calibration techniques, retrieval algorithm development, and data processing systems. The Atmospheres Program has well-equipped labs and test equipment to support the development and testing of instrument systems, such as a radiometric calibration and development facility to support the calibration of ultraviolet and visible (UV/VIS), space-borne solar backscatter instruments. This document summarizes the features and characteristics of 46 instrument systems that currently exist or are under development. The report is organized according to active, passive, or in situ remote sensing across the electromagnetic spectrum. Most of the systems are considered operational in that they have demonstrated performance in the field and are capable of being deployed on relatively short notice. Other systems are under study or of low technical readiness level (TRL). The systems described herein are designed mainly for surface or airborne platforms. However, two Cubesat systems also have been developed through collaborative efforts. The Solar Disk Sextant (SDS) is the single balloon-borne instrument. The lidar systems described herein are designed to retrieve clouds, aerosols, methane, water vapor pressure, temperature, and winds. Most of the lasers operate at some wavelength combination of 355, 532, and 1064 nm. The various systems provide high sensitivity measurements based on returns from backscatter or Raman scattering including intensity and polarization. Measurements of the frequency (Doppler) shift of light scattered from various atmospheric constitutes can also be made. Microwave sensors consist of both active (radar) and passive (radiometer) systems. These systems are important for studying processes involving water in various forms. The dielectric properties of water affect microwave brightness temperatures, which are used to retrieve atmospheric parameters such as rainfall rate and other key elements of the hydrological cycle. Atmosphere radar systems operate in the range from 9.6 GHz to 94 GHz and have measurement accuracies from -5 to 1 dBZ; radiometers operate in the 50 GHz to 874 GHz range with accuracies from 0.5 to 1 degree K; conical and cross-track scan modes are used. Our passive optical sensors, consisting of radiometers and spectrometers, collectively operate from the UV into the infrared. These systems measure energy fluxes and atmospheric parameters such as trace gases, aerosols, cloud properties, or altitude profiles of various species. Imager spatial resolution varies from 37 m to 400 m depending on altitude; spectral resolution is as small as 0.5 nm. Many of the airborne systems have been developed to fly on multiple aircraft

High-Resolution Radiometer for Remote Sensing of Solar Flare Activity from Low Earth Orbit Satellites

This article has been withdrawn at the request of the author(s) and/or editor. The Publisher apologizes for any inconvenience this may cause.For this Article Withdrawal Statement, please click on: https://ojs.bilpublishing.com/index.php/jasr/article/view/621Abstract: Solar flares, intense bursts of radiation, can disrupt the atmosphere and potentially affect communication, navigation and electrical systems. A newly developed miniaturised microwave radiometer used on a space-borne platform should offer astronomers unprecedented understanding of the largest explosive phenomena in our solar system. In this paper the activity and results of the EU funded research project FLARES are presented. Objective of FLARES has been the study, analysis and design of millimetre-wave (mm-wave) system-on-chip (SoC) radiometer for space-borne detection of solar flares. The proposed approach has contributed to reduce significantly the power consumption and weight with respect to the existing instruments for the observation and study of solar flares. In particular, the proposed SoC Dicke radiometer can achieve one order of magnitude improvement in terms of resolution, so allowing the detection of solar flares with relatively low intensity, i.e. about 100 times lower than those currently detected by the existing systems, owing to space-borne operations and the microchip-level miniaturization through silicon technology under space qualification

Millimeter and sub-millimeter wave radiometers for atmospheric remote sensing from CubeSat platforms

2018 Fall.Includes bibliographical references.To view the abstract, please see the full text of the document

Design, fabrication, and demonstration of low-mass, low-power, small-volume, direct detection millimeter-wave radiometers at 92 and 130 GHz

2012 Spring.Includes bibliographical references.Advances in future ocean satellite altimetry missions are needed to meet oceanographic and hydrological objectives. These needs include accurately determining the sea surface height (SSH) on spatial scales of 10 km and larger, as well as monitoring the height of the world's inland bodies of water and the flow rate of rivers. The Surface Water and Ocean Topography (SWOT) mission was recommended by the National Research Council's Earth Science Decadal Survey and selected by the National Aeronautics and Space Administration as an accelerated Tier-2 mission to address these needs. Current surface altimetry missions use nadir pointing 18-37 GHz microwave radiometers to correct for errors in SSH due to wet-tropospheric path delay. Using current antennas at these frequencies, oceanic measurements include significant errors within 50 km of coastlines due to varying emissivity and temperature of land. Higher frequencies (90-170 GHz) can provide proportionally smaller footprints for the same antenna size. In turn, this provides improved retrievals of wet-tropospheric path delay near the coasts. This thesis will focus on the design, fabrication, and testing of two direct detection radiometers with internal calibration at center frequencies of 92 and 130 GHz. Component design, testing and integration of the radiometers using multi-chip modules are discussed. The performance of these radiometers is characterized, including noise figure, internal calibration and long-term stability. These performance parameters, along with their mass, volume, and power consumption, will be used as the basis for the development of future airborne and space-borne millimeter-wave direct detection radiometers with internal calibration

NASA SBIR abstracts of 1990 phase 1 projects

The research objectives of the 280 projects placed under contract in the National Aeronautics and Space Administration (NASA) 1990 Small Business Innovation Research (SBIR) Phase 1 program are described. The basic document consists of edited, non-proprietary abstracts of the winning proposals submitted by small businesses in response to NASA's 1990 SBIR Phase 1 Program Solicitation. The abstracts are presented under the 15 technical topics within which Phase 1 proposals were solicited. Each project was assigned a sequential identifying number from 001 to 280, in order of its appearance in the body of the report. The document also includes Appendixes to provide additional information about the SBIR program and permit cross-reference in the 1990 Phase 1 projects by company name, location by state, principal investigator, NASA field center responsible for management of each project, and NASA contract number

Technology transfer: Transportation

The application of NASA derived technology in solving problems related to highways, railroads, and other rapid systems is described. Additional areas/are identified where space technology may be utilized to meet requirements related to waterways, law enforcement agencies, and the trucking and recreational vehicle industries

Review of existing and operable observing systems and sensors

Deliverable 1.4 is aimed at identification of existing and operable observing systems and sensors which are relevant to COMMON SENSE objectives. Report aggregates information on existing observing initiatives, programmes, systems, platforms and sensors. The Report includes: • inventory of previous and current EU funded projects. Some of the them, even if started before 2007, were aimed at activities which are relevant or in line with those stemming from MSFD in 2008. The ‘granulation’ of the contents and objectives of the projects varies from sensors development through observation methodologies to monitoring strategies, • inventory of research infrastructure in Europe. It starts from an attempt to define of Marine Research Infrastructure, as there is not a single definition of Research Infrastructure (RI) or of Marine Research Infrastructure (MRI), and there are different ways to categorise them. The chapter gives the categorization of the MRI, together with detailed description and examples of MRI – research platforms, marine data systems, research sites and laboratories with respect of four MSFD descriptors relevant to COMMON SENSE project, • two chapters on Research Programs and Infrastructure Networks; the pan-European initiatives aimed at cooperation and efficient use of infrastructural resources for marine observation and monitoring and data exchange are analysed. The detailed description of observing sensors and system are presented as well as frameworks for cooperation, • information on platforms (research vessels) available to the Project for testing developed sensors and systems. Platforms are available and operating in all three regions of interest to the project (Mediterranean, North Sea, Baltic), • annexed detailed description of two world-wide observation networks and systems. These systems are excellent examples of added value offered by integrated systems of ocean observation (from data to knowledge) and how they work in practice. Report concludes that it is seen a shortage of new classes of sensors to fulfil the emerging monitoring needs. Sensors proposed to be developed by COMMON SENSE project shall answer to the needs stemmed from introduction of MSFD and GES descriptors

Analysis of relevant technical issues and deficiencies of the existing sensors and related initiatives currently set and working in marine environment. New generation technologies for cost-effective sensors

The last decade has seen significant growth in the field of sensor networks, which are currently collecting large amounts of environmental data. This data needs to be collected, processed, stored and made available for analysis and interpretation in a manner which is meaningful and accessible to end users and stakeholders with a range of requirements, including government agencies, environmental agencies, the research community, industry users and the public. The COMMONSENSE project aims to develop and provide cost-effective, multi-functional innovative sensors to perform reliable in-situ measurements in the marine environment. The sensors will be easily usable across several platforms, and will focus on key parameters including eutrophication, heavy metal contaminants, marine litter (microplastics) and underwater noise descriptors of the MSFD. The aims of Tasks 2.1 and 2.2 which comprise the work of this deliverable are: • To obtain a comprehensive understanding and an up-to-date state of the art of existing sensors. • To provide a working basis on “new generation” technologies in order to develop cost-effective sensors suitable for large-scale production. This deliverable will consist of an analysis of state-of-the-art solutions for the different sensors and data platforms related with COMMONSENSE project. An analysis of relevant technical issues and deficiencies of existing sensors and related initiatives currently set and working in marine environment will be performed. Existing solutions will be studied to determine the main limitations to be considered during novel sensor developments in further WP’s. Objectives & Rationale The objectives of deliverable 2.1 are: • To create a solid and robust basis for finding cheaper and innovative ways of gathering data. This is preparatory for the activities in other WPs: for WP4 (Transversal Sensor development and Sensor Integration), for WP(5-8) (Novel Sensors) to develop cost-effective sensors suitable for large-scale production, reducing costs of data collection (compared to commercially available sensors), increasing data access availability for WP9 (Field testing) when the deployment of new sensors will be drawn and then realized