Electrophysiological mapping of rat sensorimotor lumbosacral spinal networks after complete paralysis

Stimulation of the spinal cord has been shown to have great potential for improving function after motor deficits caused by injury or pathological conditions. Using a wide range of animal models, many studies have shown that stimulation applied to the neural networks intrinsic to the spinal cord can result in a dramatic improvement of motor ability, even allowing an animal to step and stand after a complete spinal cord transection. Clinical use of this technology, however, has been slow to develop due to the invasive nature of the implantation procedures and the difficulty of ascertaining specific sites of stimulation that would provide optimal amelioration of the motor deficits. Moreover, the development of tools available to control precise stimulation chronically via biocompatible electrodes has been limited. In this chapter, we outline the use of a multisite electrode array in the spinal rat model to identify and stimulate specific sites of the spinal cord to produce discrete motor behaviors in spinal rats. The results demonstrate that spinal rats can stand and step when the spinal cord is stimulated tonically via electrodes located at specific sites on the spinal cord. The quality of stepping and standing was dependent on the location of the electrodes on the spinal cord, the specific stimulation parameters, and the orientation of the cathode and anode. The spinal motor evoked potentials in selected muscles during standing and stepping are shown to be critical tools to study selective activation of interneuronal circuits via responses of varying latencies. The present results provide further evidence that the assessment of functional networks in the background of behaviorally relevant functional states is likely to be a physiological tool of considerable importance in developing strategies to facilitate recovery of motor function after a number of neuromotor disorders

Flexible active electrode arrays with ASICs that fit inside the rat's spinal canal

Epidural spinal cord electrical stimulation (ESCS) has been used as a means to facilitate locomotor recovery in spinal cord injured humans. Electrode arrays, instead of conventional pairs of electrodes, are necessary to investigate the effect of ESCS at different sites. These usually require a large number of implanted wires, which could lead to infections. This paper presents the design, fabrication and evaluation of a novel flexible active array for ESCS in rats. Three small (1.7 mm2) and thin (100 μm) application specific integrated circuits (ASICs) are embedded in the polydimethylsiloxane-based implant. This arrangement limits the number of communication tracks to three, while ensuring maximum testing versatility by providing independent access to all 12 electrodes in any configuration. Laser-patterned platinum-iridium foil forms the implant’s conductive tracks and electrodes. Double rivet bonds were employed for the dice microassembly. The active electrode array can deliver current pulses (up to 1 mA, 100 pulses per second) and supports interleaved stimulation with independent control of the stimulus parameters for each pulse. The stimulation timing and pulse duration are very versatile. The array was electrically characterized through impedance spectroscopy and voltage transient recordings. A prototype was tested for long term mechanical reliability when subjected to continuous bending. The results revealed no track or bond failure. To the best of the authors’ knowledge, this is the first time that flexible active electrode arrays with embedded electronics suitable for implantation inside the rat’s spinal canal have been proposed, developed and tested in vitro

Electronics with shape actuation for minimally invasive spinal cord stimulation.

Spinal cord stimulation is one of the oldest and most established neuromodulation therapies. However, today, clinicians need to choose between bulky paddle-type devices, requiring invasive surgery under general anesthetic, and percutaneous lead-type devices, which can be implanted via simple needle puncture under local anesthetic but offer clinical drawbacks when compared with paddle devices. By applying photo- and soft lithography fabrication, we have developed a device that features thin, flexible electronics and integrated fluidic channels. This device can be rolled up into the shape of a standard percutaneous needle then implanted on the site of interest before being expanded in situ, unfurling into its paddle-type conformation. The device and implantation procedure have been validated in vitro and on human cadaver models. This device paves the way for shape-changing bioelectronic devices that offer a large footprint for sensing or stimulation but are implanted in patients percutaneously in a minimally invasive fashion

Acute neuromodulation restores spinally-induced motor responses after severe spinal cord injury

Epidural electrical spinal stimulation can facilitate recovery of volitional motor control in individuals that have been completely paralyzed for more than a year. We recently reported a novel neuromodulation method named Dynamic Stimulation (DS), which short-lastingly increased spinal excitability and generated a robust modulation of locomotor networks in fully-anesthetized intact adult rats. In the present study, we applied repetitive DS patterns to four lumbosacral segments acutely after a contusive injury at lumbar level. Repetitive DS delivery restored the spinally-evoked motor EMG responses that were previously suppressed by a calibrated spinal cord contusion. Sham experiments without DS delivery did not allow any spontaneous recovery. Thus, DS uniquely provides the potential for a greater long-term functional recovery after paralysis

An Active Learning Algorithm for Control of Epidural Electrostimulation

Epidural electrostimulation has shown promise for spinal cord injury therapy. However, finding effective stimuli on the multi-electrode stimulating arrays employed requires a laborious manual search of a vast space for each patient. Widespread clinical application of these techniques would be greatly facilitated by an autonomous, algorithmic system which choses stimuli to simultaneously deliver effective therapy and explore this space. We propose a method based on GP-BUCB, a Gaussian process bandit algorithm. In n = 4 spinally transected rats, we implant epidural electrode arrays and examine the algorithm’s performance in selecting bipolar stimuli to elicit specified muscle responses. These responses are compared with temporally interleaved intra-animal stimulus selections by a human expert. GP-BUCB successfully controlled the spinal electrostimulation preparation in 37 testing sessions, selecting 670 stimuli. These sessions included sustained autonomous operations (ten-session duration). Delivered performance with respect to the specified metric was as good as or better than that of the human expert. Despite receiving no information as to anatomically likely locations of effective stimuli, GP-BUCB also consistently discovered such a pattern. Further, GP-BUCB was able to extrapolate from previous sessions’ results to make predictions about performance in new testing sessions, while remaining sufficiently flexible to capture temporal variability. These results provide validation for applying automated stimulus selection methods to the problem of spinal cord injury therapy

Using EMG to deliver lumbar dynamic electrical stimulation to facilitate cortico-spinal excitability

Background: Potentiation of synaptic activity in spinal networks is reflected in the magnitude of modulation of motor responses evoked by spinal and cortical input. After spinal cord injury, motor evoked responses can be facilitated by pairing cortical and peripheral nerve stimuli. Objective: To facilitate synaptic potentiation of cortico-spinal input with epidural electrical stimulation, we designed a novel neuromodulation method called dynamic stimulation (DS), using patterns derived from hind limb EMG signal during stepping. Methods: DS was applied dorsally to the lumbar enlargement through a high-density epidural array composed of independent platinum-based micro-electrodes. Results: In fully anesthetized intact adult rats, at the interface array/spinal cord, the temporal and spatial features of DS neuromodulation affected the entire lumbosacral network, particularly the most rostral and caudal segments covered by the array. DS induced a transient (at least 1 min) increase in spinal cord excitability and, compared to tonic stimulation, generated a more robust potentiation of the motor output evoked by single pulses applied to the spinal cord. When sub-threshold pulses were selectively applied to a cortical motor area, EMG responses from the contralateral leg were facilitated by the delivery of DS to the lumbosacral cord. Finally, based on motor-evoked responses, DS was linked to a greater amplitude of motor output shortly after a calibrated spinal cord contusion. Conclusion: Compared to traditional tonic waveforms, DS amplifies both spinal and cortico-spinal input aimed at spinal networks, thus significantly increasing the potential and accelerating the rate of functional recovery after a severe spinal lesion

Enhancing Nervous System Recovery through Neurobiologics, Neural Interface Training, and Neurorehabilitation.

After an initial period of recovery, human neurological injury has long been thought to be static. In order to improve quality of life for those suffering from stroke, spinal cord injury, or traumatic brain injury, researchers have been working to restore the nervous system and reduce neurological deficits through a number of mechanisms. For example, neurobiologists have been identifying and manipulating components of the intra- and extracellular milieu to alter the regenerative potential of neurons, neuro-engineers have been producing brain-machine and neural interfaces that circumvent lesions to restore functionality, and neurorehabilitation experts have been developing new ways to revitalize the nervous system even in chronic disease. While each of these areas holds promise, their individual paths to clinical relevance remain difficult. Nonetheless, these methods are now able to synergistically enhance recovery of native motor function to levels which were previously believed to be impossible. Furthermore, such recovery can even persist after training, and for the first time there is evidence of functional axonal regrowth and rewiring in the central nervous system of animal models. To attain this type of regeneration, rehabilitation paradigms that pair cortically-based intent with activation of affected circuits and positive neurofeedback appear to be required-a phenomenon which raises new and far reaching questions about the underlying relationship between conscious action and neural repair. For this reason, we argue that multi-modal therapy will be necessary to facilitate a truly robust recovery, and that the success of investigational microscopic techniques may depend on their integration into macroscopic frameworks that include task-based neurorehabilitation. We further identify critical components of future neural repair strategies and explore the most updated knowledge, progress, and challenges in the fields of cellular neuronal repair, neural interfacing, and neurorehabilitation, all with the goal of better understanding neurological injury and how to improve recovery

A spinal cord neuroprosthesis for locomotor deficits due to Parkinson’s disease

People with late-stage Parkinson’s disease (PD) often suffer from debilitating locomotor deficits that are resistant to currently available therapies. To alleviate these deficits, we developed a neuroprosthesis operating in closed loop that targets the dorsal root entry zones innervating lumbosacral segments to reproduce the natural spatiotemporal activation of the lumbosacral spinal cord during walking. We first developed this neuroprosthesis in a non-human primate model that replicates locomotor deficits due to PD. This neuroprosthesis not only alleviated locomotor deficits but also restored skilled walking in this model. We then implanted the neuroprosthesis in a 62-year-old male with a 30-year history of PD who presented with severe gait impairments and frequent falls that were medically refractory to currently available therapies. We found that the neuroprosthesis interacted synergistically with deep brain stimulation of the subthalamic nucleus and dopaminergic replacement therapies to alleviate asymmetry and promote longer steps, improve balance and reduce freezing of gait. This neuroprosthesis opens new perspectives to reduce the severity of locomotor deficits in people with PD

A parylene-based microelectrode array implant for spinal cord stimulation in rats

The design and fabrication of an epidural spinal cord implant using a parylene-based microelectrode array is presented. Rats with hindlimb paralysis from a complete spinal cord transection were implanted with the device and studied for up to eight weeks, where we have demonstrated recovery of hindlimb stepping functionality through pulsed stimulation. The microelectrode array allows for a high degree of freedom and specificity in selecting the site of stimulation compared to wire-based implants, and triggers varied biological responses that can lead to an increased understanding of the spinal cord and locomotion recovery for victims of spinal cord injury

Implantable Organic Transistors on Biodegradable Scaffolds for the Treatment of the Spinal Cord Injury

Neural plasticity after severe spinal cord injury (SCI) is promoted by activity stimulating treatments such as specific physiotherapeutic training, injection of pharmaceutical cues and electrical stimulation (ES). However, full or even partial recovery of neuronal functionality is difficult to be achieved with current treatments. Organic bioelectronics provides novel architectures and materials that set the basement of modern neuroprosthetics. In this thesis, an active multifunctional implantable device (AMID) is developed that is highly conformable and biodegradable while being fully biocompatible. AMID integrates a three-fold functionality crucial for future treatments of SCI: a microfluidic channel allows the precise administration of anti-inflammatory pharmaceuticals or plasticity inducing agents; patterned electrodes allow delivering of electric stimuli promoting SC plasticity; organic electrochemical transistors allow to transduce bioelectronic activity providing possible information about the regeneration status. Biodegradability opens to transient neuroprostheses that are bioresporbed within the body after the regeneration process thus reducing both chronic foreign body reaction and the needs of secondary surgeries for the removal of the implant. The work starts with the fabrication and validation of the stimulation and sensing architectures onto biodegradable scaffold. Secondary, the sensing of a relevant bioelectric signal (electrocardiogram) is performed. Then, stimulating capability of biodegradable organic transistors is demonstrated with in vitro experiments onto primary neurons and macrophages. Last, the fabrication of the implantable device is presented and preliminary results about in vivo stimulation (on animal SCI model) and implant compatibility are discussed