1,354 research outputs found

    Near-capacity MIMOs using iterative detection

    No full text
    In this thesis, Multiple-Input Multiple-Output (MIMO) techniques designed for transmission over narrowband Rayleigh fading channels are investigated. Specifically, in order to providea diversity gain while eliminating the complexity of MIMO channel estimation, a Differential Space-Time Spreading (DSTS) scheme is designed that employs non-coherent detection. Additionally, in order to maximise the coding advantage of DSTS, it is combined with Sphere Packing (SP) modulation. The related capacity analysis shows that the DSTS-SP scheme exhibits a higher capacity than its counterpart dispensing with SP. Furthermore, in order to attain additional performance gains, the DSTS system invokes iterative detection, where the outer code is constituted by a Recursive Systematic Convolutional (RSC) code, while the inner code is a SP demapper in one of the prototype systems investigated, while the other scheme employs a Unity Rate Code (URC) as its inner code in order to eliminate the error floor exhibited by the system dispensing with URC. EXIT charts are used to analyse the convergence behaviour of the iteratively detected schemes and a novel technique is proposed for computing the maximum achievable rate of the system based on EXIT charts. Explicitly, the four-antenna-aided DSTSSP system employing no URC precoding attains a coding gain of 12 dB at a BER of 10-5 and performs within 1.82 dB from the maximum achievable rate limit. By contrast, the URC aidedprecoded system operates within 0.92 dB from the same limit.On the other hand, in order to maximise the DSTS system’s throughput, an adaptive DSTSSP scheme is proposed that exploits the advantages of differential encoding, iterative decoding as well as SP modulation. The achievable integrity and bit rate enhancements of the system are determined by the following factors: the specific MIMO configuration used for transmitting data from the four antennas, the spreading factor used and the RSC encoder’s code rate.Additionally, multi-functional MIMO techniques are designed to provide diversity gains, multiplexing gains and beamforming gains by combining the benefits of space-time codes, VBLASTand beamforming. First, a system employing Nt=4 transmit Antenna Arrays (AA) with LAA number of elements per AA and Nr=4 receive antennas is proposed, which is referred to as a Layered Steered Space-Time Code (LSSTC). Three iteratively detected near-capacity LSSTC-SP receiver structures are proposed, which differ in the number of inner iterations employed between the inner decoder and the SP demapper as well as in the choice of the outer code, which is either an RSC code or an Irregular Convolutional Code (IrCC). The three systems are capable of operating within 0.9, 0.4 and 0.6 dB from the maximum achievable rate limit of the system. A comparison between the three iteratively-detected schemes reveals that a carefully designed two-stage iterative detection scheme is capable of operating sufficiently close to capacity at a lower complexity, when compared to a three-stage system employing a RSC or a two-stage system using an IrCC as an outer code. On the other hand, in order to allow the LSSTC scheme to employ less receive antennas than transmit antennas, while still accommodating multiple users, a Layered Steered Space-Time Spreading (LSSTS) scheme is proposed that combines the benefits of space-time spreading, V-BLAST, beamforming and generalised MC DS-CDMA. Furthermore, iteratively detected LSSTS schemes are presented and an LLR post-processing technique is proposed in order to improve the attainable performance of the iteratively detected LSSTS system.Finally, a distributed turbo coding scheme is proposed that combines the benefits of turbo coding and cooperative communication, where iterative detection is employed by exchanging extrinsic information between the decoders of different single-antenna-aided users. Specifically, the effect of the errors induced in the first phase of cooperation, where the two users exchange their data, on the performance of the uplink in studied, while considering different fading channel characteristics

    Signal Design and Machine Learning Assisted Nonlinearity Compensation for Coherent Optical Fibre Communication Links

    Get PDF
    This thesis investigates low-complexity digital signal processing (DSP) for signal design and nonlinearity compensation strategies to improve the performance of single-mode optical fibre links over different distance scales. The performance of a novel ML-assisted inverse regular perturbation technique that mitigates fibre nonlinearities was investigated numerically with a dual-polarization 64 quadrature amplitude modulation (QAM) link over 800 km distance. The model outperformed the heuristically-optimised digital backpropagation approach with <5 steps per span and mitigated the gain expansion issue, which limits the accuracy of an untrained model when the balance between the nonlinear and linear components becomes considerable. For short reach links, the phase noise due to low-cost, high-linewidth lasers is a more significant channel impairment. A novel constellation optimisation algorithm was, therefore, proposed to design modulation formats that are robust against both additive white Gaussian noise (AWGN) and the residual laser phase noise (i.e., after carrier phase estimation). Subsequently, these constellations were numerically validated in the context of a 400ZR standard system, and achieved up to 1.2 dB gains in comparison with the modulation formats which were optimised only for the AWGN channel. The thesis concludes by examining a joint strategy to modulate and demodulate signals in a partially-coherent AWGN (PCAWGN) channel. With a low-complexity PCAWGN demapper, 8- to 64-ary modulation formats were designed and validated through numerical simulations. The bit-wise achievable information rates (AIR) and post forward error correction (FEC) bit error rates (BER) of the designed constellations were numerically validated with: the theoretically optimum, Euclidean (conventional), and low-complexity PCAWGN demappers. The resulting constellations demonstrated post-FEC BER shaping gains of up to 2.59 dB and 2.19 dB versus uniform 64 QAM and 64-ary constellations shaped for the purely AWGN channel model, respectively. The described geometric shaping strategies can be used to either relax linewidth and/or carrier phase estimator requirements, or to increase signal-to-noise ratio (SNR) tolerance of a system in the presence of residual phase noise

    Signal design for Multiple-Antenna Systems and Wireless Networks

    Get PDF
    This dissertation is concerned with the signal design problems for Multiple Input and Multiple Output (MIMO) antenna systems and wireless networks. Three related but distinct problems are considered.The first problem considered is the design of space time codes for MIMO systems in the case when neither the transmitter nor the receiver knows the channel. We present the theoretical concept of communicating over block fading channel using Layered Unitary Space Time Codes (LUSTC), where the input signal is formed as a product of a series of unitary matrices with corresponding dimensionality. We show the channel capacity using isotropically distributed (i.d.) input signaling and optimal decoding can be achieved by layered i.d. signaling scheme along with a low complexity successive decoding. The closed form layered channel capacity is obtained, which serves as a design guideline for practical LUSTC. In the design of LUSTC, a successive design method is applied to leverage the problem of optimizing over lots of parameters.The feedback of channel state information (CSI) to the transmitter in MIMO systems is known to increase the forward channel capacity. A suboptimal power allocation scheme for MIMO systems is then proposed for limited rate feedback of CSI. We find that the capacity loss of this simple scheme is rather small compared to the optimal water-filling solution. This knowledge is applied for the design of the feedback codebook. In the codebook design, a generalized Lloyd algorithm is employed, in which the computation of the centroid is formulated as an optimization problem and solved optimally. Numerical results show that the proposed codebook design outperforms the existing algorithms in the literature.While it is not feasible to deploy multiple antennas in a wireless node due to the space limitation, user cooperation is an alternative to increase performance of the wireless networks. To this end, a coded user cooperation scheme is considered in the dissertation, which is shown to be equivalent to a coding scheme with the encoding done in a distributive manner. Utilizing the coding theoretic bound and simulation results, we show that the coded user cooperation scheme has great advantage over the non-cooperative scheme

    Combined Time, Frecuency and Space Diversity in Multimedia Mobile Broadcasting Systems

    Full text link
    El uso combinado de diversidad en el dominio temporal, frecuencial y espacial constituye una valiosa herramienta para mejorar la recepción de servicios de difusión móviles. Gracias a la mejora conseguida por las técnicas de diversidad es posible extender la cobertura de los servicios móviles además de reducir la infraestructura de red. La presente tesis investiga el uso de técnicas de diversidad para la provisión de servicios móviles en la familia europea de sistemas de difusión terrestres estandarizada por el prpoyecto DVB (Digital Video Broadcasting). Esto incluye la primera y segunda generación de sistemas DVB-T (Terrestrial), DVB-NGH (Handheld), y DVB-T2 (Terrestrial 2nd generation), así como el sistema de siguiente generación DVB-NGH. No obstante, el estudio llevado a cabo en la tesis es genérico y puede aplicarse a futuras evoluciones de estándares como el japonés ISDB-T o el americano ATSC. Las investigaciones realizadas dentro del contexto de DVB-T, DVB-H y DVBT2 tienen como objetivo la transmisión simultánea de servicios fijos y móviles en redes terrestres. Esta Convergencia puede facilitar la introducción de servicios móviles de TB debido a la reutilización de espectro, contenido e infraestructura. De acuerdo a los resultados, la incorporación de entrelazado temporal en la capa física para diversidad temporal, y de single-input multiple-output (SIMO) para diversidad espacial, son esenciales para el rendimiento de sistemas móviles de difusión. A pesar de que las técnicas upper later FEC (UL-FEC) pueden propocionar diversidad temporal en sistemas de primera generación como DVB-T y DVB-H, requieren la transmisión de paridad adicional y no son útiles para la recepción estática. El análisis en t�ñerminos de link budjget revela que las técnicas de diversidad noson suficientes para facilitar la provision de servicios móviles en redes DVB-T y DVB-T2 planificadas para recepción fija. Sin embargo, el uso de diversidad en redes planificadas para recepción portableGozálvez Serrano, D. (2012). Combined Time, Frecuency and Space Diversity in Multimedia Mobile Broadcasting Systems [Tesis doctoral no publicada]. Universitat Politècnica de València. https://doi.org/10.4995/Thesis/10251/16273Palanci
    corecore