35 research outputs found
Multiple Access in Aerial Networks: From Orthogonal and Non-Orthogonal to Rate-Splitting
Recently, interest on the utilization of unmanned aerial vehicles (UAVs) has
aroused. Specifically, UAVs can be used in cellular networks as aerial users
for delivery, surveillance, rescue search, or as an aerial base station (aBS)
for communication with ground users in remote uncovered areas or in dense
environments requiring prompt high capacity. Aiming to satisfy the high
requirements of wireless aerial networks, several multiple access techniques
have been investigated. In particular, space-division multiple access(SDMA) and
power-domain non-orthogonal multiple access (NOMA) present promising
multiplexing gains for aerial downlink and uplink. Nevertheless, these gains
are limited as they depend on the conditions of the environment. Hence, a
generalized scheme has been recently proposed, called rate-splitting multiple
access (RSMA), which is capable of achieving better spectral efficiency gains
compared to SDMA and NOMA. In this paper, we present a comprehensive survey of
key multiple access technologies adopted for aerial networks, where aBSs are
deployed to serve ground users. Since there have been only sporadic results
reported on the use of RSMA in aerial systems, we aim to extend the discussion
on this topic by modelling and analyzing the weighted sum-rate performance of a
two-user downlink network served by an RSMA-based aBS. Finally, related open
issues and future research directions are exposed.Comment: 16 pages, 6 figures, submitted to IEEE Journa
High capacity multiuser multiantenna communication techniques
One of the main issues involved in the development of future wireless communication systems is the multiple access technique used to efficiently share the available spectrum among users. In rich multipath environment, spatial dimension can be exploited to meet the increasing number of users and their demands without consuming extra bandwidth and power. Therefore, it is utilized in the multiple-input multiple-output (MIMO) technology to increase the spectral efficiency significantly. However, multiuser MIMO (MU-MIMO) systems are still challenging to be widely adopted in next generation standards. In this thesis, new techniques are proposed to increase the channel and user capacity and improve the error performance of MU-MIMO over Rayleigh fading channel environment.
For realistic system design and performance evaluation, channel correlation is considered as one of the main channel impurities due its severe influence on capacity and reliability. Two simple methods called generalized successive coloring technique (GSCT) and generalized iterative coloring technique (GICT) are proposed for accurate generation of correlated Rayleigh fading channels (CRFC). They are designed to overcome the shortcomings of existing methods by avoiding factorization of desired covariance matrix of the Gaussian samples. The superiority of these techniques is demonstrated by extensive simulations of different practical system scenarios.
To mitigate the effects of channel correlations, a novel constellation constrained MU-MIMO (CC-MU-MIMO) scheme is proposed using transmit signal design and maximum likelihood joint detection (MLJD) at the receiver. It is designed to maximize the channel capacity and error performance based on principles of maximizing the minimum Euclidean distance (dmin) of composite received signals. Two signal design methods named as unequal power allocation (UPA) and rotation constellation (RC) are utilized to resolve the detection ambiguity caused by correlation. Extensive analysis and simulations demonstrate the effectiveness of considered scheme compared with conventional MU-MIMO. Furthermore, significant gain in SNR is achieved particularly in moderate to high correlations which have direct impact to maintain high user capacity.
A new efficient receive antenna selection (RAS) technique referred to as phase difference based selection (PDBS) is proposed for single and multiuser MIMO systems to maximize the capacity over CRFC. It utilizes the received signal constellation to select the subset of antennas with highest (dmin) constellations due to its direct impact on the capacity and BER performance. A low complexity algorithm is designed by employing the Euclidean norm of channel matrix rows with their corresponding phase differences. Capacity analysis and simulation results show that PDBS outperforms norm based selection (NBS) and near to optimal selection (OS) for all correlation and SNR values. This technique provides fast RAS to capture most of the gains promised by multiantenna systems over different channel conditions.
Finally, novel group layered MU-MIMO (GL-MU-MIMO) scheme is introduced to exploit the available spectrum for higher user capacity with affordable complexity. It takes the advantages of spatial difference among users and power control at base station to increase the number of users beyond the available number of RF chains. It is achieved by dividing the users into two groups according to their received power, high power group (HPG) and low power group (LPG). Different configurations of low complexity group layered multiuser detection (GL-MUD) and group power allocation ratio (η) are utilized to provide a valuable tradeoff between complexity and overall system performance. Furthermore, RAS diversity is incorporated by using NBS and a new selection algorithm called HPG-PDBS to increase the channel capacity and enhance the error performance. Extensive analysis and simulations demonstrate the superiority of proposed scheme compared with conventional MU-MIMO. By using appropriate value of (η), it shows higher sum rate capacity and substantial increase in the user capacity up to two-fold at target BER and SNR values
High Capacity CDMA and Collaborative Techniques
The thesis investigates new approaches to increase the user capacity and improve the error
performance of Code Division Multiple Access (CDMA) by employing adaptive interference cancellation
and collaborative spreading and space diversity techniques. Collaborative Coding Multiple
Access (CCMA) is also investigated as a separate technique and combined with CDMA. The
advantages and shortcomings of CDMA and CCMA are analysed and new techniques for both the
uplink and downlink are proposed and evaluated.
Multiple access interference (MAI) problem in the uplink of CDMA is investigated first. The
practical issues of multiuser detection (MUD) techniques are reviewed and a novel blind adaptive
approach to interference cancellation (IC) is proposed. It exploits the constant modulus (CM)
property of digital signals to blindly suppress interference during the despreading process and obtain
amplitude estimation with minimum mean squared error for use in cancellation stages. Two
new blind adaptive receiver designs employing successive and parallel interference cancellation
architectures using the CM algorithm (CMA) referred to as ‘CMA-SIC’ and ‘BA-PIC’, respectively,
are presented. These techniques have shown to offer near single user performance for large
number of users. It is shown to increase the user capacity by approximately two fold compared
with conventional IC receivers. The spectral efficiency analysis of the techniques based on output
signal-to interference-and-noise ratio (SINR) also shows significant gain in data rate. Furthermore,
an effective and low complexity blind adaptive subcarrier combining (BASC) technique using a
simple gradient descent based algorithm is proposed for Multicarrier-CDMA. It suppresses MAI
without any knowledge of channel amplitudes and allows large number of users compared with
equal gain and maximum ratio combining techniques normally used in practice.
New user collaborative schemes are proposed and analysed theoretically and by simulations
in different channel conditions to achieve spatial diversity for uplink of CCMA and CDMA. First,
a simple transmitter diversity and its equivalent user collaborative diversity techniques for CCMA
are designed and analysed. Next, a new user collaborative scheme with successive interference
cancellation for uplink of CDMA referred to as collaborative SIC (C-SIC) is investigated to reduce
MAI and achieve improved diversity. To further improve the performance of C-SIC under high
system loading conditions, Collaborative Blind Adaptive SIC (C-BASIC) scheme is proposed.
It is shown to minimize the residual MAI, leading to improved user capacity and a more robust
system. It is known that collaborative diversity schemes incur loss in throughput due to the need of
orthogonal time/frequency slots for relaying source’s data. To address this problem, finally a novel
near-unity-rate scheme also referred to as bandwidth efficient collaborative diversity (BECD) is proposed and evaluated for CDMA. Under this scheme, pairs of users share a single spreading sequence to exchange and forward their data employing a simple superposition or space-time
encoding methods. At the receiver collaborative joint detection is performed to separate each
paired users’ data. It is shown that the scheme can achieve full diversity gain at no extra bandwidth
as inter-user channel SNR becomes high.
A novel approach of ‘User Collaboration’ is introduced to increase the user capacity of CDMA
for both the downlink and uplink. First, collaborative group spreading technique for the downlink
of overloaded CDMA system is introduced. It allows the sharing of the same single spreading
sequence for more than one user belonging to the same group. This technique is referred to as
Collaborative Spreading CDMA downlink (CS-CDMA-DL). In this technique T-user collaborative
coding is used for each group to form a composite codeword signal of the users and then a
single orthogonal sequence is used for the group. At each user’s receiver, decoding of composite
codeword is carried out to extract the user’s own information while maintaining a high SINR performance.
To improve the bit error performance of CS-CDMA-DL in Rayleigh fading conditions,
Collaborative Space-time Spreading (C-STS) technique is proposed by combining the collaborative
coding multiple access and space-time coding principles. A new scheme for uplink of CDMA
using the ‘User Collaboration’ approach, referred to as CS-CDMA-UL is presented next. When
users’ channels are independent (uncorrelated), significantly higher user capacity can be achieved
by grouping multiple users to share the same spreading sequence and performing MUD on per
group basis followed by a low complexity ML decoding at the receiver. This approach has shown
to support much higher number of users than the available sequences while also maintaining the
low receiver complexity. For improved performance under highly correlated channel conditions,
T-user collaborative coding is also investigated within the CS-CDMA-UL system
Analysis and Design of Algorithms for the Improvement of Non-coherent Massive MIMO based on DMPSK for beyond 5G systems
Mención Internacional en el título de doctorNowadays, it is nearly impossible to think of a service that does not rely on wireless communications.
By the end of 2022, mobile internet represented a 60% of the total global online traffic.
There is an increasing trend both in the number of subscribers and in the traffic handled by each
subscriber. Larger data rates, smaller extreme-to-extreme (E2E) delays and greater number of
devices are current interests for the development of mobile communications. Furthermore, it
is foreseen that these demands should also be fulfilled in scenarios with stringent conditions,
such as very fast varying wireless communications channels (either in time or frequency) or
scenarios with power constraints, mainly found when the equipment is battery powered.
Since most of the wireless communications techniques and standards rely on the fact that the
wireless channel is somehow characterized or estimated to be pre or post-compensated in transmission
(TX) or reception (RX), there is a clear problem when the channels vary rapidly or the
available power is constrained. To estimate the wireless channel and obtain the so-called channel
state information (CSI), some of the available resources (either in time, frequency or any
other dimension), are utilized by including known signals in the TX and RX typically known as
pilots, thus avoiding their use for data transmission. If the channels vary rapidly, they must be
estimated many times, which results in a very low data efficiency of the communications link.
Also, in case the power is limited or the wireless link distance is large, the resulting signal-tointerference-
plus-noise ratio (SINR) will be low, which is a parameter that is directly related to
the quality of the channel estimation and the performance of the data reception. This problem
is aggravated in massive multiple-input multiple-output (massive MIMO), which is a promising
technique for future wireless communications since it can increase the data rates, increase the
reliability and cope with a larger number of simultaneous devices. In massive MIMO, the base
station (BS) is typically equipped with a large number of antennas that are coordinated. In these
scenarios, the channels must be estimated for each antenna (or at least for each user), and thus,
the aforementioned problem of channel estimation aggravates. In this context, algorithms and
techniques for massive MIMO without CSI are of interest.
This thesis main topic is non-coherent massive multiple-input multiple-output (NC-mMIMO)
which relies on the use of differential M-ary phase shift keying (DMPSK) and the spatial
diversity of the antenna arrays to be able to detect the useful transmitted data without CSI knowledge. On the one hand, hybrid schemes that combine the coherent and non-coherent
schemes allowing to get the best of both worlds are proposed. These schemes are based on
distributing the resources between non-coherent (NC) and coherent data, utilizing the NC data
to estimate the channel without using pilots and use the estimated channel for the coherent
data. On the other hand, new constellations and user allocation strategies for the multi-user
scenario of NC-mMIMO are proposed. The new constellations are better than the ones in the
literature and obtained using artificial intelligence techniques, more concretely evolutionary
computation.This work has received funding from the European Union Horizon 2020 research and innovation
programme under the Marie Skłodowska-Curie ETN TeamUp5G, grant agreement No.
813391. The PhD student was the Early Stage Researcher (ESR) number 2 of the project.
This work has also received funding from the Spanish National Project IRENE-EARTH
(PID2020-115323RB-C33) (MINECO/AEI/FEDER, UE), which funded the work of some coauthors.Programa de Doctorado en Multimedia y Comunicaciones por la Universidad Carlos III de Madrid y la Universidad Rey Juan CarlosPresidente: Luis Castedo Ribas.- Secretario: Matilde Pilar Sánchez Fernández.- Vocal: Eva Lagunas Targaron
Multiple Access in Aerial Networks : From Orthogonal and Non-Orthogonal to Rate-Splitting
Recently, interest on the utilization of unmanned aerial vehicles (UAVs) has aroused. Specifically, UAVs can be used in cellular networks as aerial users for delivery, surveillance, rescue search, or as an aerial base station (aBS) for communication with ground users in remote uncovered areas or in dense environments requiring prompt high capacity. Aiming to satisfy the high requirements of wireless aerial networks, several multiple access techniques have been investigated. In particular, space-division multiple access (SDMA) and power-domain non-orthogonal multiple access (NOMA) present promising multiplexing gains for aerial downlink and uplink. Nevertheless, these gains are limited as they depend on the conditions of the environment. Hence, a generalized scheme has been recently proposed, called rate-splitting multiple access (RSMA), which is capable of achieving better spectral efficiency gains compared to SDMA and NOMA. In this paper, we present a comprehensive survey of key multiple access technologies adopted for aerial networks, where aBSs are deployed to serve ground users. Since there have been only sporadic results reported on the use of RSMA in aerial systems, we aim to extend the discussion on this topic by modelling and analyzing the weighted sum-rate performance of a two-user network served by an RSMA-based aBS. Finally, related open issues and future research directions are exposed.publishedVersionPeer reviewe