1,636 research outputs found
Degrees of Freedom of the 3-User Rank-Deficient MIMO Interference Channel
We provide the degrees of freedom (DoF) characterization for the -user
multiple-input multiple-output (MIMO) interference channel (IC)
with \emph{rank-deficient} channel matrices, where each transmitter is equipped
with antennas and each receiver with antennas, and the interfering
channel matrices from each transmitter to the other two receivers are of ranks
and , respectively. One important intermediate step for both the
converse and achievability arguments is to convert the fully-connected
rank-deficient channel into an equivalent partially-connected full-rank MIMO-IC
by invertible linear transformations. As such, existing techniques developed
for full-rank MIMO-IC can be incorporated to derive the DoF outer and inner
bounds for the rank-deficient case. Our result shows that when the interfering
links are weak in terms of the channel ranks, i.e., , zero forcing is sufficient to achieve the optimal DoF. On the other
hand, when , a combination of zero forcing and
interference alignment is in general required for DoF optimality. The DoF
characterization obtained in this paper unifies several existing results in the
literature.Comment: 28 pages, 7 figures. To appear in IEEE transactions on wireless
communication
Single-Carrier Modulation versus OFDM for Millimeter-Wave Wireless MIMO
This paper presents results on the achievable spectral efficiency and on the
energy efficiency for a wireless multiple-input-multiple-output (MIMO) link
operating at millimeter wave frequencies (mmWave) in a typical 5G scenario. Two
different single-carrier modem schemes are considered, i.e., a traditional
modulation scheme with linear equalization at the receiver, and a
single-carrier modulation with cyclic prefix, frequency-domain equalization and
FFT-based processing at the receiver; these two schemes are compared with a
conventional MIMO-OFDM transceiver structure. Our analysis jointly takes into
account the peculiar characteristics of MIMO channels at mmWave frequencies,
the use of hybrid (analog-digital) pre-coding and post-coding beamformers, the
finite cardinality of the modulation structure, and the non-linear behavior of
the transmitter power amplifiers. Our results show that the best performance is
achieved by single-carrier modulation with time-domain equalization, which
exhibits the smallest loss due to the non-linear distortion, and whose
performance can be further improved by using advanced equalization schemes.
Results also confirm that performance gets severely degraded when the link
length exceeds 90-100 meters and the transmit power falls below 0 dBW.Comment: accepted for publication on IEEE Transactions on Communication
Massive MIMO Systems with Non-Ideal Hardware: Energy Efficiency, Estimation, and Capacity Limits
The use of large-scale antenna arrays can bring substantial improvements in
energy and/or spectral efficiency to wireless systems due to the greatly
improved spatial resolution and array gain. Recent works in the field of
massive multiple-input multiple-output (MIMO) show that the user channels
decorrelate when the number of antennas at the base stations (BSs) increases,
thus strong signal gains are achievable with little inter-user interference.
Since these results rely on asymptotics, it is important to investigate whether
the conventional system models are reasonable in this asymptotic regime. This
paper considers a new system model that incorporates general transceiver
hardware impairments at both the BSs (equipped with large antenna arrays) and
the single-antenna user equipments (UEs). As opposed to the conventional case
of ideal hardware, we show that hardware impairments create finite ceilings on
the channel estimation accuracy and on the downlink/uplink capacity of each UE.
Surprisingly, the capacity is mainly limited by the hardware at the UE, while
the impact of impairments in the large-scale arrays vanishes asymptotically and
inter-user interference (in particular, pilot contamination) becomes
negligible. Furthermore, we prove that the huge degrees of freedom offered by
massive MIMO can be used to reduce the transmit power and/or to tolerate larger
hardware impairments, which allows for the use of inexpensive and
energy-efficient antenna elements.Comment: To appear in IEEE Transactions on Information Theory, 28 pages, 15
figures. The results can be reproduced using the following Matlab code:
https://github.com/emilbjornson/massive-MIMO-hardware-impairment
Uplink CoMP under a Constrained Backhaul and Imperfect Channel Knowledge
Coordinated Multi-Point (CoMP) is known to be a key technology for next
generation mobile communications systems, as it allows to overcome the burden
of inter-cell interference. Especially in the uplink, it is likely that
interference exploitation schemes will be used in the near future, as they can
be used with legacy terminals and require no or little changes in
standardization. Major drawbacks, however, are the extent of additional
backhaul infrastructure needed, and the sensitivity to imperfect channel
knowledge. This paper jointly addresses both issues in a new framework
incorporating a multitude of proposed theoretical uplink CoMP concepts, which
are then put into perspective with practical CoMP algorithms. This
comprehensive analysis provides new insight into the potential usage of uplink
CoMP in next generation wireless communications systems.Comment: Submitted to IEEE Transactions on Wireless Communications in February
201
Joint Unitary Triangularization for MIMO Networks
This work considers communication networks where individual links can be
described as MIMO channels. Unlike orthogonal modulation methods (such as the
singular-value decomposition), we allow interference between sub-channels,
which can be removed by the receivers via successive cancellation. The degrees
of freedom earned by this relaxation are used for obtaining a basis which is
simultaneously good for more than one link. Specifically, we derive necessary
and sufficient conditions for shaping the ratio vector of sub-channel gains of
two broadcast-channel receivers. We then apply this to two scenarios: First, in
digital multicasting we present a practical capacity-achieving scheme which
only uses scalar codes and linear processing. Then, we consider the joint
source-channel problem of transmitting a Gaussian source over a two-user MIMO
channel, where we show the existence of non-trivial cases, where the optimal
distortion pair (which for high signal-to-noise ratios equals the optimal
point-to-point distortions of the individual users) may be achieved by
employing a hybrid digital-analog scheme over the induced equivalent channel.
These scenarios demonstrate the advantage of choosing a modulation basis based
upon multiple links in the network, thus we coin the approach "network
modulation".Comment: Submitted to IEEE Tran. Signal Processing. Revised versio
Hardware Impairments Aware Transceiver Design for Full-Duplex Amplify-and-Forward MIMO Relaying
In this work we study the behavior of a full-duplex (FD) and
amplify-and-forward (AF) relay with multiple antennas, where hardware
impairments of the FD relay transceiver is taken into account. Due to the
inter-dependency of the transmit relay power on each antenna and the residual
self-interference in an FD-AF relay, we observe a distortion loop that degrades
the system performance when the relay dynamic range is not high. In this
regard, we analyze the relay function in presence of the hardware inaccuracies
and an optimization problem is formulated to maximize the signal to
distortion-plus-noise ratio (SDNR), under relay and source transmit power
constraints. Due to the problem complexity, we propose a
gradient-projection-based (GP) algorithm to obtain an optimal solution.
Moreover, a nonalternating sub-optimal solution is proposed by assuming a
rank-1 relay amplification matrix, and separating the design of the relay
process into multiple stages (MuStR1). The proposed MuStR1 method is then
enhanced by introducing an alternating update over the optimization variables,
denoted as AltMuStR1 algorithm. It is observed that compared to GP, (Alt)MuStR1
algorithms significantly reduce the required computational complexity at the
expense of a slight performance degradation. Finally, the proposed methods are
evaluated under various system conditions, and compared with the methods
available in the current literature. In particular, it is observed that as the
hardware impairments increase, or for a system with a high transmit power, the
impact of applying a distortion-aware design is significant.Comment: Submitted to IEEE Transactions on Wireless Communication
- …