114 research outputs found

    Timing and Carrier Synchronization in Wireless Communication Systems: A Survey and Classification of Research in the Last 5 Years

    Get PDF
    Timing and carrier synchronization is a fundamental requirement for any wireless communication system to work properly. Timing synchronization is the process by which a receiver node determines the correct instants of time at which to sample the incoming signal. Carrier synchronization is the process by which a receiver adapts the frequency and phase of its local carrier oscillator with those of the received signal. In this paper, we survey the literature over the last 5 years (2010–2014) and present a comprehensive literature review and classification of the recent research progress in achieving timing and carrier synchronization in single-input single-output (SISO), multiple-input multiple-output (MIMO), cooperative relaying, and multiuser/multicell interference networks. Considering both single-carrier and multi-carrier communication systems, we survey and categorize the timing and carrier synchronization techniques proposed for the different communication systems focusing on the system model assumptions for synchronization, the synchronization challenges, and the state-of-the-art synchronization solutions and their limitations. Finally, we envision some future research directions

    Synchronization in CDMA systems

    Get PDF
    Ph.DDOCTOR OF PHILOSOPH

    Adaptive receivers for direct-spread and multi-carrier code division multiple access systems

    Get PDF
    In this thesis, the detection of Direct Sequence Code Division Multiple Access (DS-CDMA) signals in an AWGN channel and Multi-Carrier (MC) CDMA signals in a time-dispersion channel is discussed. The DS-CDMA receiver employs an adaptive multiuser interference canceler that utilizes deadzone limiters in the tentative decision stage. With weights adjusted adaptively, the prior knowledge of signal powers is unnecessary. The steady state error performance of this receiver is obtained and found to be superior to the performance of the same receiver using hard limiters for tentative decisions. The channel is considered non-fading in. this receiver. Modeling the frequency selective channel lading as narrowband fiat-flat fading centered at each subcarrier, the MC-CDMA technique reduces the effect of channel dispersion. A decorrelating multiuser interference canceler is introduced in the MC-CDMA receiver to reduce the multi-access interference, especially when the orthogonality of signature codes is degraded by the fading channel

    Phase noise effects on OFDM : analysis and mitigation

    Get PDF
    Orthogonal frequency division multiplexing (OFDM) is a promising technique which has high spectrum efficiency and the robustness against channel frequency selectivity. One drawback of OFDM is its sensitivity to phase noise. It has been shown that even small phase noise leads to significant performance loss of OFDM. Therefore, phase noise effects on OFDM systems need to be analyzed and methods be provided to its mitigation. Motivated by what have been proposed in the literature, the exact signal to interference plus noise ratio (SINR) is derived in this dissertation for arbitrary phase noise levels. In a multiple access environment with multiple phase noise, the closed form of bit error rate (BER) performance is derived as a function of phase noise parameters. Due to the detrimental effects of phase noise on OFDM, phase noise mitigation is quite necessary. Several schemes are proposed to mitigate both single and multiple phase noise. It is shown that, while outperforming conventional methods, these schemes have the performance close to no-phase-noise case. Two general approaches are presented which extend the conventional schemes proposed in the literature, making them special cases of these general approaches. Moreover, different implementation techniques are also presented. Analytical and numerical results are provided to compare the performance of these migitation approaches and implementation techniques. Similar to OFDM, an OFDM system with multiple antennas, i.e., Multiple Input. Multiple Output (MIMO)-OFDM, also suffer severe performance degradation due to phase noise, and what have been proposed in the literature may not be applicable to MIMO-OFDM. Therefore, a new scheme is proposed to mitigate phase noise for MIMO-OFDM, which provides significant performance gains over systems without phase noise mitigation. This scheme provides a very simple structure and achieves adequate performance with high spectrum efficiency, which makes it very attractive for practical implementations

    Channel estimation techniques for filter bank multicarrier based transceivers for next generation of wireless networks

    Get PDF
    A dissertation submitted to Faculty of Engineering and the Built Environment, University of the Witwatersrand, Johannesburg, in fulfillment of the requirements for the degree of Master of Science in Engineering (Electrical and Information Engineering), August 2017The fourth generation (4G) of wireless communication system is designed based on the principles of cyclic prefix orthogonal frequency division multiplexing (CP-OFDM) where the cyclic prefix (CP) is used to combat inter-symbol interference (ISI) and inter-carrier interference (ICI) in order to achieve higher data rates in comparison to the previous generations of wireless networks. Various filter bank multicarrier systems have been considered as potential waveforms for the fast emerging next generation (xG) of wireless networks (especially the fifth generation (5G) networks). Some examples of the considered waveforms are orthogonal frequency division multiplexing with offset quadrature amplitude modulation based filter bank, universal filtered multicarrier (UFMC), bi-orthogonal frequency division multiplexing (BFDM) and generalized frequency division multiplexing (GFDM). In perfect reconstruction (PR) or near perfect reconstruction (NPR) filter bank designs, these aforementioned FBMC waveforms adopt the use of well-designed prototype filters (which are used for designing the synthesis and analysis filter banks) so as to either replace or minimize the CP usage of the 4G networks in order to provide higher spectral efficiencies for the overall increment in data rates. The accurate designing of the FIR low-pass prototype filter in NPR filter banks results in minimal signal distortions thus, making the analysis filter bank a time-reversed version of the corresponding synthesis filter bank. However, in non-perfect reconstruction (Non-PR) the analysis filter bank is not directly a time-reversed version of the corresponding synthesis filter bank as the prototype filter impulse response for this system is formulated (in this dissertation) by the introduction of randomly generated errors. Hence, aliasing and amplitude distortions are more prominent for Non-PR. Channel estimation (CE) is used to predict the behaviour of the frequency selective channel and is usually adopted to ensure excellent reconstruction of the transmitted symbols. These techniques can be broadly classified as pilot based, semi-blind and blind channel estimation schemes. In this dissertation, two linear pilot based CE techniques namely the least square (LS) and linear minimum mean square error (LMMSE), and three adaptive channel estimation schemes namely least mean square (LMS), normalized least mean square (NLMS) and recursive least square (RLS) are presented, analyzed and documented. These are implemented while exploiting the near orthogonality properties of offset quadrature amplitude modulation (OQAM) to mitigate the effects of interference for two filter bank waveforms (i.e. OFDM/OQAM and GFDM/OQAM) for the next generation of wireless networks assuming conditions of both NPR and Non-PR in slow and fast frequency selective Rayleigh fading channel. Results obtained from the computer simulations carried out showed that the channel estimation schemes performed better in an NPR filter bank system as compared with Non-PR filter banks. The low performance of Non-PR system is due to the amplitude distortion and aliasing introduced from the random errors generated in the system that is used to design its prototype filters. It can be concluded that RLS, NLMS, LMS, LMMSE and LS channel estimation schemes offered the best normalized mean square error (NMSE) and bit error rate (BER) performances (in decreasing order) for both waveforms assuming both NPR and Non-PR filter banks. Keywords: Channel estimation, Filter bank, OFDM/OQAM, GFDM/OQAM, NPR, Non-PR, 5G, Frequency selective channel.CK201
    corecore