Exploring Task Mappings on Heterogeneous MPSoCs using a Bias-Elitist Genetic Algorithm

Exploration of task mappings plays a crucial role in achieving high performance in heterogeneous multi-processor system-on-chip (MPSoC) platforms. The problem of optimally mapping a set of tasks onto a set of given heterogeneous processors for maximal throughput has been known, in general, to be NP-complete. The problem is further exacerbated when multiple applications (i.e., bigger task sets) and the communication between tasks are also considered. Previous research has shown that Genetic Algorithms (GA) typically are a good choice to solve this problem when the solution space is relatively small. However, when the size of the problem space increases, classic genetic algorithms still suffer from the problem of long evolution times. To address this problem, this paper proposes a novel bias-elitist genetic algorithm that is guided by domain-specific heuristics to speed up the evolution process. Experimental results reveal that our proposed algorithm is able to handle large scale task mapping problems and produces high-quality mapping solutions in only a short time period.Comment: 9 pages, 11 figures, uses algorithm2e.st

Predictable multi-processor system on chip design for multimedia applications

The design of multimedia systems has become increasingly complex due to consumer requirements. Consumers demand the functionalities offered by a huge desktop from these systems. Many of these systems are mobile. Therefore, power consumption and size of these devices should be small. These systems are increasingly becoming multi-processor based (MPSoCs) for the reasons of power and performance. Applications execute on these systems in different combinations also known as use-cases. Applications may have different performance requirements in each use-case. Currently, verification of all these use-cases takes bulk of the design effort. There is a need for analysis based techniques so that the platforms have a predictable behaviour and in turn provide guarantees on performance without expending precious man hours on verification. In this dissertation, techniques and architectures have been developed to design and manage these multi-processor based systems efficiently. The dissertation presents predictable architectural components for MPSoCs, a Predictable MPSoC design strategy, automatic platform synthesis tool, a run-time system and an MPSoC simulation technique. The introduction of predictability helps in rapid design of MPSoC platforms. Chapter 1 of the thesis studies the trends in modern multimedia applications and processor architectures. The chapter further highlights the problems in the design of MPSoC platforms and emphasizes the need of predictable design techniques. Predictable design techniques require predictable application and architectural components. The chapter further elaborates on Synchronous Data Flow Graphs which are used to model the applications throughout this thesis. The chapter presents the architecture template used in this thesis and enlists the contributions of the thesis. One of the contributions of this thesis is the design of a predictable component called communication assist. Chapter 2 of the thesis describes the architecture of this communication assist. The communication assist presented in this thesis not only decouples the communication from computation but also provides timing guarantees. Based on this communication assist, an MPSoC platform generation technique has been presented that can design MPSoC platforms capable of satisfying the throughput constraints of multiple applications in all use-cases. The technique is presented in Chapter 3. The design strategy uses three simple steps for platform design. In the first step it finds the required number of processors. The second step minimizes the communication interconnect between the processors and the third step minimizes the communication memory requirement of the platform. Further in Chapter 4, a tool has been developed to generate CA-based platforms for FPGAs. The output of this tool can be used to synthesize platforms on real hardware with the help of FPGA synthesis tools. The applications executing on these platforms often exhibit dynamism e.g. variation in task execution times and change in application throughput requirements. Further, new applications may often be added by consumers at run-time. Resource managers have been presented in literature to handle such dynamic situations. However, the scalability of these resource managers becomes an issue with the increase in number of processors and applications. Chapter 5 presents distributed run-time resource management techniques. Two versions of distributed resource managers have been presented which are scalable with the number of applications and processors. MPSoC platforms for real-time applications are designed assuming worst-case task execution times. It is known that the difference between average-case and worst-case behaviour can be quite large. Therefore, knowing the average case performance is also important for the system designer, and software simulation is often employed to estimate this. However, simulation in software is slow and does not scale with the number of applications and processing elements. In Chapter 6, a fast and scalable simulation methodology is introduced that can simulate the execution of multiple applications on an MPSoC platform. It is based on parallel execution of SDF (Synchronous Data Flow) models of applications. The simulation methodology uses Parallel Discrete Event Simulation (PDES) primitives and it is termed as "Smart Conservative PDES". The methodology generates a parallel simulator which is synthesizable on FPGAs. The framework can also be used to model dynamic arbitration policies which are difficult to analyse using models. The generated platform is also useful in carrying out Design Space Exploration as shown in the thesis. Finally, Chapter 7 summarizes the main findings and (practical) implications of the studies described in previous chapters of this dissertation. Using the contributions mentioned in the thesis, a designer can design and implement predictable multiprocessor based systems capable of satisfying throughput constraints of multiple applications in given set of use-cases, and employ resource management strategies to deal with dynamism in the applications. The chapter also describes the main limitations of this dissertation and makes suggestions for future research

Dynamic Energy and Thermal Management of Multi-Core Mobile Platforms: A Survey

Multi-core mobile platforms are on rise as they enable efficient parallel processing to meet ever-increasing performance requirements. However, since these platforms need to cater for increasingly dynamic workloads, efficient dynamic resource management is desired mainly to enhance the energy and thermal efficiency for better user experience with increased operational time and lifetime of mobile devices. This article provides a survey of dynamic energy and thermal management approaches for multi-core mobile platforms. These approaches do either proactive or reactive management. The upcoming trends and open challenges are also discussed

Energy Aware Runtime Systems for Elastic Stream Processing Platforms

Following an invariant growth in the required computational performance of processors, the multicore revolution started around 20 years ago. This revolution was mainly an answer to power dissipation constraints restricting the increase of clock frequency in single-core processors. The multicore revolution not only brought in the challenge of parallel programming, i.e. being able to develop software exploiting the entire capabilities of manycore architectures, but also the challenge of programming heterogeneous platforms. The question of “on which processing element to map a specific computational unit?”, is well known in the embedded community. With the introduction of general-purpose graphics processing units (GPGPUs), digital signal processors (DSPs) along with many-core processors on different system-on-chip platforms, heterogeneous parallel platforms are nowadays widespread over several domains, from consumer devices to media processing platforms for telecom operators. Finding mapping together with a suitable hardware architecture is a process called design-space exploration. This process is very challenging in heterogeneous many-core architectures, which promise to offer benefits in terms of energy efficiency. The main problem is the exponential explosion of space exploration. With the recent trend of increasing levels of heterogeneity in the chip, selecting the parameters to take into account when mapping software to hardware is still an open research topic in the embedded area. For example, the current Linux scheduler has poor performance when mapping tasks to computing elements available in hardware. The only metric considered is CPU workload, which as was shown in recent work does not match true performance demands from the applications. Doing so may produce an incorrect allocation of resources, resulting in a waste of energy. The origin of this research work comes from the observation that these approaches do not provide full support for the dynamic behavior of stream processing applications, especially if these behaviors are established only at runtime. This research will contribute to the general goal of developing energy-efficient solutions to design streaming applications on heterogeneous and parallel hardware platforms. Streaming applications are nowadays widely spread in the software domain. Their distinctive characiteristic is the retrieving of multiple streams of data and the need to process them in real time. The proposed work will develop new approaches to address the challenging problem of efficient runtime coordination of dynamic applications, focusing on energy and performance management.Efter en oföränderlig tillväxt i prestandakrav hos processorer, började den flerkärniga processor-revolutionen för ungefär 20 år sedan. Denna revolution skedde till största del som en lösning till begränsningar i energieffekten allt eftersom klockfrekvensen kontinuerligt höjdes i en-kärniga processorer. Den flerkärniga processor-revolutionen medförde inte enbart utmaningen gällande parallellprogrammering, m.a.o. förmågan att utveckla mjukvara som använder sig av alla delelement i de flerkärniga processorerna, men också utmaningen med programmering av heterogena plattformar. Frågeställningen ”på vilken processorelement skall en viss beräkning utföras?” är väl känt inom ramen för inbyggda datorsystem. Efter introduktionen av grafikprocessorer för allmänna beräkningar (GPGPU), signalprocesserings-processorer (DSP) samt flerkärniga processorer på olika system-on-chip plattformar, är heterogena parallella plattformar idag omfattande inom många domäner, från konsumtionsartiklar till mediaprocesseringsplattformar för telekommunikationsoperatörer. Processen att placera beräkningarna på en passande hårdvaruplattform kallas för utforskning av en designrymd (design-space exploration). Denna process är mycket utmanande för heterogena flerkärniga arkitekturer, och kan medföra fördelar när det gäller energieffektivitet. Det största problemet är att de olika valmöjligheterna i designrymden kan växa exponentiellt. Enligt den nuvarande trenden som förespår ökad heterogeniska aspekter i processorerna är utmaningen att hitta den mest passande placeringen av beräkningarna på hårdvaran ännu en forskningsfråga inom ramen för inbyggda datorsystem. Till exempel, den nuvarande schemaläggaren i Linux operativsystemet är inkapabel att hitta en effektiv placering av beräkningarna på den underliggande hårdvaran. Det enda mätsättet som används är processorns belastning vilket, som visats i tidigare forskning, inte motsvarar den verkliga prestandan i applikationen. Användning av detta mätsätt vid resursallokering resulterar i slöseri med energi. Denna forskning härstammar från observationerna att dessa tillvägagångssätt inte stöder det dynamiska beteendet hos ström-processeringsapplikationer (stream processing applications), speciellt om beteendena bara etableras vid körtid. Denna forskning kontribuerar till det allmänna målet att utveckla energieffektiva lösningar för ström-applikationer (streaming applications) på heterogena flerkärniga hårdvaruplattformar. Ström-applikationer är numera mycket vanliga i mjukvarudomän. Deras distinkta karaktär är inläsning av flertalet dataströmmar, och behov av att processera dem i realtid. Arbetet i denna forskning understöder utvecklingen av nya sätt för att lösa det utmanade problemet att effektivt koordinera dynamiska applikationer i realtid och fokus på energi- och prestandahantering