SiGe-based broadband and high suppression frequency doubler ICs for wireless communications

制度:新 ; 報告番号:甲3419号 ; 学位の種類:博士(工学) ; 授与年月日:2011/9/15 ; 早大学位記番号:新574

캘리브레이션이 필요없는 위상고정 루프의 설계

학위논문 (박사)-- 서울대학교 대학원 : 전기·컴퓨터공학부, 2017. 2. 김재하.A PVT-insensitive-bandwidth PLL and a chirp frequency synthesizer PLL are proposed using a constant-relative-gain digitally-controlled oscillator (DCO), a constant-gain time-to-digital converter (TDC), and a simple digital loop filter (DLF) without an explicit calibration or additional circuit components. A digital LC-PLL that realizes a PVT-insensitive loop bandwidth (BW) by using the constant-relative-gain LC-DCO and constant-gain TDC is proposed. In other words, based on ratiometric circuit designs, the LC-DCO can make a fixed percent change to its frequency for a unit change in its digital input and the TDC can maintain a fixed range and resolution measured in reference unit intervals (UIs) across PVT variations. With such LC-DCO and TDC, the proposed PLL can realize a bandwidth which is a constant fraction of the reference frequency even with a simple proportional-integral digital loop filter without any explicit calibration loops. The prototype digital LC-PLL fabricated in a 28-nm CMOS demonstrates a frequency range of 8.38~9.34 GHz and 652-fs,rms integrated jitter from 10-kHz to 1-GHz at 8.84-GHz while dissipating 15.2-mW and occupying 0.24-mm^2. Also, the PLL across three different die samples and supply voltage ranging from 1.0 to 1.2V demonstrates a nearly constant BW at 822-kHz with the variation of ±4.25-% only. A chirp frequency synthesizer PLL (FS-PLL) that is capable of precise triangular frequency modulation using type-III digital LC-PLL architecture for X-band FMCW imaging radar is proposed. By employing a phase-modulating two-point modulation (TPM), constant-gain TDC, and a simple second-order DLF with polarity-alternating frequency ramp estimator, the PLL achieves a gain self-tracking TPM realizing a frequency chirp with fast chirp slope (=chirp BW/chirp period) without increasing frequency errors around the turn-around points, degrading the effective resolution achievable. A prototype chirp FS-PLL fabricated in a 65nm CMOS demonstrates that the PLL can generate a precise triangular chirp profile centered at 8.9-GHz with 940-MHz bandwidth and 28.8-us period with only 1.9-MHz,rms frequency error including the turn-around points and 14.8-mW power dissipation. The achieved 32.63-MHz/us chirp slope is higher than that of FMCW FS-PLLs previously reported by 2.6x.CHAPTER 1 INTRODUCTION 1 1.1 MOTIVATION 1 1.2 THESIS ORGANIZATION 5 CHAPTER 2 CONVENTIONAL PHASE-LOCKED LOOP 7 2.1 CHARGE-PUMP PLL 7 2.1.1 OPERATING PRINCIPLE 7 2.1.2 LOOP DYNAMICS 9 2.2 DIGITAL PLL 10 2.2.1 OPERATING PRINCIPLE 11 2.2.2 LOOP DYNAMICS 12 CHAPTER 3 VARIATIONS ON PHASE-LOCKED LOOP 14 3.1 OSCILLATOR GAIN VARIATION 14 3.1.1 RING VOLTAGE-CONTROLLED OSCILLATOR 15 3.1.2 LC VOLTAGE-CONTROLLED OSCILLATOR 17 3.1.3 LC DIGITALLY-CONTROLLED OSCILLATOR 19 3.2 PHASE DETECTOR GAIN VARIATION 20 3.2.1 LINEAR PHASE DETECTOR 20 3.2.2 LINEAR TIME-TO-DIGITAL CONVERTER 21 CHAPTER 4 PROPOSED DCO AND TDC FOR CALIBRATION-FREE PLL 23 4.1 DIGTALLY-CONTROLLED OSCILLATOR (DCO) 25 4.1.1 OVERVIEW 24 4.1.2 CONSTANT-RELATIVE-GAIN DCO 26 4.2 TIME-TO-DIGITAL CONVERTER (TDC) 28 4.2.1 OVERVIEW 28 4.2.2 CONSTANT-GAIN TDC 30 CHAPTER 5 PVT-INSENSITIVE-BANDWIDTH PLL 35 5.1 OVERVIEW 36 5.2 PRIOR WORKS 37 5.3 PROPOSED PVT-INSENSITIVE-BANDWIDTH PLL 39 5.4 CIRCUIT IMPLEMENTATION 41 5.4.1 CAPACITOR-TUNED LC-DCO 41 5.4.2 TRANSFORMER-TUNED LC-DCO 45 5.4.3 OVERSAMPLING-BASED CONSTANT-GAIN TDC 49 5.4.4 PHASE DIGITAL-TO-ANALOG CONVERTER 52 5.4.5 DIGITAL LOOP FILTER 54 5.4.6 FREQUENCY DIVIDER 55 5.4.7 BANG-BANG PHASE-FREQUENCY DETECTOR 56 5.5 CELL-BASED DESIGN FLOW 57 5.6 MEASUREMENT RESULTS 58 CHAPTER 6 CHIRP FREQUENCY SYNTHESIZER PLL 66 6.1 OVERVIEW 67 6.2 PRIOR WORKS 71 6.3 PROPOSED CHIRP FREQUENCY SYNTHESIZER PLL 75 6.4 CIRCUIT IMPLEMENTATION 83 6.4.1 SECOND-ORDER DIGITAL LOOP FILTER 83 6.4.2 PHASE MODULATOR 84 6.4.3 CONSTANT-GAIN TDC 85 6.4.4 VRACTOR-BASED LC-DCO 87 6.4.5 OVERALL CLOCK CHAIN 90 6.5 MEASUREMENT RESULTS 91 6.6 SIGNAL-TO-NOISE RATIO OF RADAR 98 CHAPTER 7 CONCLUSION 100 BIBLIOGRAPHY 102 초록 109Docto

Analysis and Design of Radio Frequency Integrated Circuits for Breast Cancer Radar Imaging in CMOS Technology

Breast cancer is by far the most incident tumor among female population. Early stage prevention is a key factor in delivering long term survival of breast cancer patients. X-ray mammography is the most commonly used diagnostic technique to detect non-palpable tumors. However, 10-30% of tumors are missed by mammography and ionizing radiations together with breast compression do not lead to comfort in patient treatment. In this context, ultrawideband microwave radar technology is an attractive alternative. It relies on the dielectric contrast of normal and malignant tissues at microwave frequencies to detect and locate tumors inside the breast. This work presents the analysis and design of radio frequency integrated circuits for breast cancer imaging in CMOS technology. The first part of the thesis concerns the system analysis. A behavioral model of two different transceiver architectures for UWB breast cancer imaging employing a SFCW radar system are presented. A mathematical model of the direct conversion and super heterodyne architectures together with a numerical breast phantom are developed. FDTD simulations data are used to on the behavioral model to investigate the limits of both architectures from a circuit-level point of view. Insight is given into I/Q phase inaccuracies and their impact on the quality of the final reconstructed images. The result is that the simplicity of the direct conversion architecture makes the receiver more robust toward the critical impairments for this application. The second part of the thesis is dedicated to the circuit design. The main achievement is a 65nm CMOS 2-16GHz stepped frequency radar transceiver for medical imaging. The RX features 36dB conversion gain, >29dBm compression point, 7dB noise figure, and 30Hz 1/f noise corner. The TX outputs 14dBm with >40dBc harmonic rejection and <109dBc/Hz phase noise at 1MHz offset. Overall power dissipation is 204mW from 1.2V supply. The radar achieves 3mm resolution within the body, and 107dB dynamic range, a performance enabling the use for breast cancer diagnostic imaging. To further assess the capabilities of the proposed radar, a physical breast phantom was synthesized and two targets mimicking two tumors were buried inside the breast. The targets are clearly identified and correctly located, effectively proving the performance of the designed radar as a possible tool for breast cancer detection