A wideband noise-canceling CMOS LNA exploiting a transformer

A broadband LNA incorporating single-ended to differential conversion, has been successfully implemented using a noise-canceling technique and a single on-chip transformer. The LNA achieves a high voltage gain of 19dB, a wideband input match (2.5-4.0 GHz), and a noise figure of 4-5.4 dB, while consuming only 8mW. The LNA is implemented in a 90nm CMOS process with 6 metal layers

A general weak nonlinearity model for LNAs

This paper presents a general weak nonlinearity model that can be used to model, analyze and describe the distortion behavior of various low noise amplifier topologies in both narrowband and wideband applications. Represented by compact closed-form expressions our model can be easily utilized by both circuit designers and LNA design automation algorithms.\ud Simulations for three LNA topologies at different operating conditions show that the model describes IM components with an error lower than 0.1% and a one order of magnitude faster response time. The model also indicates that for narrowband IM2@w1-w2 all the nonlinear capacitances can be neglected while for narrowband IM3 the nonlinear capacitances at the drainterminal can be neglected

A 1.2 V and 69 mW 60 GHz Multi-channel Tunable CMOS Receiver Design

A multi-channel receiver operating between 56 GHz and 70 GHz for coverage of different 60 GHz bands worldwide is implemented with a 90 nm Complementary Metal-Oxide Semiconductor (CMOS) process. The receiver containing an LNA, a frequency down-conversion mixer and a variable gain amplifier incorporating a band-pass filter is designed and implemented. This integrated receiver is tested at four channels of centre frequencies 58.3 GHz, 60.5 GHz, 62.6 GHz and 64.8 GHz, employing a frequency plan of an 8 GHz-intermediate frequency (IF). The achieved conversion gain by coarse gain control is between 4.8 dB–54.9 dB. The millimeter-wave receiver circuit is biased with a 1.2V supply voltage. The measured power consumption is 69 mW

Low-power low-voltage chopped transconductance amplifier for noise and offset reduction

This paper describes the principle and design of a CMOS low-power, low-voltage, chopped transconductance amplifier, for noise and offset reduction in mixed analogue digital applications. The operation is based on chopping and dynamic element matching, to reduce noise and offset, without excessive increase of the charge injection residual offset. Experimental results show residual offsets of less than 150µV at 100kHz chopping frequency, a signal to noise ratio of 95dB, in audio band, for 100KHz chopping and a THD of -89dB. The power consumption is 594µW

A fully integrated 24-GHz phased-array transmitter in CMOS

This paper presents the first fully integrated 24-GHz phased-array transmitter designed using 0.18-/spl mu/m CMOS transistors. The four-element array includes four on-chip CMOS power amplifiers, with outputs matched to 50 /spl Omega/, that are each capable of generating up to 14.5 dBm of output power at 24 GHz. The heterodyne transmitter has a two-step quadrature up-conversion architecture with local oscillator (LO) frequencies of 4.8 and 19.2 GHz, which are generated by an on-chip frequency synthesizer. Four-bit LO path phase shifting is implemented in each element at 19.2 GHz, and the transmitter achieves a peak-to-null ratio of 23 dB with raw beam-steering resolution of 7/spl deg/ for radiation normal to the array. The transmitter can support data rates of 500 Mb/s on each channel (with BPSK modulation) and occupies 6.8 mm /spl times/ 2.1 mm of die area

Generating All Two-MOS-Transistor Amplifiers Leads to New Wide-Band LNAs

This paper presents a methodology that systematically generates all 2-MOS-transistor wide-band amplifiers, assuming that MOSFET is exploited as a voltage-controlled current source. This leads to new circuits. Their gain and noise factor have been compared to well-known wide-band amplifiers. One of the new circuits appears to have a relatively low noise factor, which is also gain independent. Based on this new circuit, a 50-900 MHz variable-gain wide-band LNA has been designed in 0.35-µm CMOS. Measurements show a noise figure between 4.3 and 4.9 dB for gains from 6 to 11 dB. These values are more than 2 dB lower than the noise figure of the wide-band common-gate LNA for the same input matching, power consumption, and voltage gain. IIP2 and IIP3 are better than 23.5 and 14.5 dBm, respectively, while the LNA drains only 1.5 mA at 3.3 V