61 research outputs found
Outdoor to Indoor Penetration Loss at 28 GHz for Fixed Wireless Access
This paper present the results from a 28 GHz channel sounding campaign
performed to investigate the effects of outdoor to indoor penetration on the
wireless propagation channel characteristics for an urban microcell in a fixed
wireless access scenario. The measurements are performed with a real-time
channel sounder, which can measure path loss up to 169 dB, and equipped with
phased array antennas that allows electrical beam steering for directionally
resolved measurements in dynamic environments. Thanks to the short measurement
time and the excellent phase stability of the system, we obtain both
directional and omnidirectional channel power delay profiles without any delay
uncertainty. For outdoor and indoor receiver locations, we compare path loss,
delay spreads and angular spreads obtained for two different types of
buildings
Understanding Noise and Interference Regimes in 5G Millimeter-Wave Cellular Networks
With the severe spectrum shortage in conventional cellular bands,
millimeter-wave (mmWave) frequencies have been attracting growing attention for
next-generation micro- and picocellular wireless networks. A fundamental and
open question is whether mmWave cellular networks are likely to be noise- or
interference-limited. Identifying in which regime a network is operating is
critical for the design of MAC and physical-layer procedures and to provide
insights on how transmissions across cells should be coordinated to cope with
interference. This work uses the latest measurement-based statistical channel
models to accurately assess the Interference-to-Noise Ratio (INR) in a wide
range of deployment scenarios. In addition to cell density, we also study
antenna array size and antenna patterns, whose effects are critical in the
mmWave regime. The channel models also account for blockage, line-of-sight and
non-line-of-sight regimes as well as local scattering, that significantly
affect the level of spatial isolation
Achieving Ultra-Low Latency in 5G Millimeter Wave Cellular Networks
The IMT 2020 requirements of 20 Gbps peak data rate and 1 millisecond latency
present significant engineering challenges for the design of 5G cellular
systems. Use of the millimeter wave (mmWave) bands above 10 GHz --- where vast
quantities of spectrum are available --- is a promising 5G candidate that may
be able to rise to the occasion.
However, while the mmWave bands can support massive peak data rates,
delivering these data rates on end-to-end service while maintaining reliability
and ultra-low latency performance will require rethinking all layers of the
protocol stack. This papers surveys some of the challenges and possible
solutions for delivering end-to-end, reliable, ultra-low latency services in
mmWave cellular systems in terms of the Medium Access Control (MAC) layer,
congestion control and core network architecture
The chromosomal DNA damage in buccal mucosa cells among schools children in the vicinity of mobile base stations in Selangor
Introduction: The increased use of mobile phones has increased the mobile base stations (MBS) deployment. While understanding of radiation protection is growing among the public, questions regarding early-life exposure to radiofrequency radiation (RFR) from MBS in children are of importance as to whether it will raise the chances of developing chronic diseases during adulthood. Taking into account the sitting location of MBS, the purpose of this study is to evaluate the chromosomal DNA damage in buccal mucosal cells between school children exposed to RFR emitted from base station antennas. Method: This is a comparative cross-sectional study in which two group of school children were sampled i.e. exposed groups are children whose school located near MBS (≤200 meters); unexposed groups are children whose school located distant far from the MBS (>200 meters). Digital RF Analyzer was used to measure RFR at the school surrounding. Buccal mucosa cells from the oral cavity were sampled to examine the level of micronuclei (MN) frequencies. Results: This study found that the densities of the RFR energy differed in range. Although all measurements showed the RFR reading below the acceptable exposure level, there were still significant variations at each location assessed. Statistically, the MN frequency is significantly different when compared to the exposed and non-exposed group. Conclusion: To understand the mechanism of health effects from exposure to low-level RFR emited from MBS, further study should consider environmental factors influencing MBS sitting on RFR emission, as well as examining the health effects into molecular levels
- …