Morphology of two dimensional fracture surface

We consider the morphology of two dimensional cracks observed in experimental results obtained from paper samples and compare these results with the numerical simulations of the random fuse model (RFM). We demonstrate that the data obey multiscaling at small scales but cross over to self-affine scaling at larger scales. Next, we show that the roughness exponent of the random fuse model is recovered by a simpler model that produces a connected crack, while a directed crack yields a different result, close to a random walk. We discuss the multiscaling behavior of all these models.Comment: slightly revise

Morphology and Properties of Zn-Al-TiO2 Composite on Mild Steel

The influence of TiO2 composite and dispersed pure Al particle on zinc alloy electrodeposited on mild steel was studied from chloride bath solution.Microstructural and mechanical properties of the alloy were investigated. The structure, surface morphology, and surface topography of the deposited alloys were characterized by scanning electron microscopy (SEM) and atomic force microscope (AFM).In addition, hardness of the coated alloys was measured. It was found that the obtained Zn-Al-TiO2 alloyexhibited more preferred surface morphology and mechanical strength compared tothe substrate. The result shows the existence of interaction between TiO2 compounds and zinc alloy particulate. It also exhibited well bright dominate zinc coating on steel surface

Catalysts for electrochemical generation of oxygen

Several aspects of the electrolytic evolution of oxygen for use in life support systems are analyzed including kinetic studies of various metal and nonmetal electrode materials, the formation of underpotential films on electrodes, and electrode surface morphology and the use of single crystal metals. In order to investigate the role of surface morphology to electrochemical reactions, a low energy electron diffraction and an Auger electron spectrometer are combined with an electrochemical thin-layer cell allowing initial characterization of the surface, reaction run, and then a comparative surface analysis

Modeling sublimation by computer simulation: morphology dependent effective energies

Solid-On-Solid (SOS) computer simulations are employed to investigate the sublimation of surfaces. We distinguish three sublimation regimes: layer-by-layer sublimation, free step flow and hindered step flow. The sublimation regime is selected by the morphology i.e. the terrace width. To each regime corresponds another effective energy. We propose a systematic way to derive microscopic parameters from effective energies and apply this microscopical analysis to the layer-by-layer and the free step flow regime. We adopt analytical calculations from Pimpinelli and Villain and apply them to our model. Key-Words: Computer simulations; Models of surface kinetics; Evaporation and Sublimation; Growth; Surface Diffusion; Surface structure, morphology, roughness, and topography; Cadmium tellurideComment: 12 pages, 6 Postscript figures, uses psfig.st