All-fiber fused directional coupler for highly efficient spatial mode conversion

We model and demonstrate a simple mode selective all-fiber coupler capable of exciting specific higher order modes in two- and few-mode fibres with high efficiency and purity. The coupler is based on inter-modally phase-matching the propagation constants in each arm of the asymmetric fused coupler, formed by dissimilar fibres. At a specific coupler diameter, the launched fundamental LP01 mode is coupled into the higher order mode (LP11, LP21, LP02) in the other arm, over a broadband wavelength range around 1550 nm. Unlike other techniques, the demonstrated coupler is composed of a multimode fiber that is weakly fused with a phase matched conventional single mode telecom fiber (SMF-28). The beating between the supermodes at the coupler waist produces a periodic power transfer between the two arms, and therefore, by monitoring the beating while tapering, it is possible to obtain optimum selection for the desired mode. High coupling efficiencies in excess of 90% for all the higher order modes were recorded over 100 nm spectral range, while insertion losses remain as low as 0.5 dB. Coupling efficiency can be further enhanced by performing slow tapering at high temperature, in order to precisely control the coupler cross-section geometry

Dissipative Two-Mode Tavis-Cummings Model with Time-Delayed Feedback Control

We investigate the dynamics of a two-mode laser system by extending the two-mode Tavis-Cummings model with dissipative channels and incoherent pumping and by applying the mean-field approximation in the thermodynamic limit. To this end we analytically calculate up to four possible non-equilibrium steady states (fixed points) and determine the corresponding complex phase diagram. Various possible phases are distinguished by the actual number of fixed points and their stability. In addition, we apply three time-delayed Pyragas feedback control schemes. Depending on the time delay and the strength of the control term this can lead to the stabilization of unstable fixed points or to the selection of a particular cavity mode that is macroscopically occupied

Concepts and methods in optimization of integrated LC VCOs

Underlying physical mechanisms controlling the noise properties of oscillators are studied. This treatment shows the importance of inductance selection for oscillator noise optimization. A design strategy centered around an inductance selection scheme is executed using a practical graphical optimization method to optimize phase noise subject to design constraints such as power dissipation, tank amplitude, tuning range, startup condition, and diameters of spiral inductors. The optimization technique is demonstrated through a design example, leading to a 2.4-GHz fully integrated, LC voltage-controlled oscillator (VCO) implemented using 0.35-μm MOS transistors. The measured phase-noise values are -121, -117, and -115 dBc/Hz at 600-kHz offset from 1.91, 2.03, and 2.60-GHz carriers, respectively. The VCO dissipates 4 mA from a 2.5-V supply voltage. The inversion mode MOSCAP tuning is used to achieve 26% of tuning range. Two figures of merit for performance comparison of various oscillators are introduced and used to compare this work to previously reported results

Super-resolving phase measurements with a multi-photon entangled state

Using a linear optical elements and post-selection, we construct an entangled polarization state of three photons in the same spatial mode. This state is analogous to a ``photon-number path entangled state'' and can be used for super-resolving interferometry. Measuring a birefringent phase shift, we demonstrate two- and three-fold improvements in phase resolution.Comment: 4 pages, 3 figure

Polarization dynamics in vertical-cavity surface emitting lasers

Experiments and their interpretation on polarization dynamics and polarization switching in vertical-cavity surface-emitting lasers operated in the fundamental transverse mode regime are reviewed. Important observations are switching events to a mode with the lower unsaturated gain and the existence of elliptically polarized dynamical transition states after the destabilization of the low-frequency polarization mode. The observations demonstrate the need to consider explicitly the phase properties of the optical field as well as nonlinear effects affecting polarization selection above threshold. Good qualitative agreement is found with a model which takes into account the spin degrees of freedom of the light field as well as of the carriers (`spin-flip model'), if the spin-flip rate is taken to be some tens of $10^9$~s$^{-1}$. This constitutes a strong -- though indirect -- indication that spin dependent processes are important in polarization selection in the devices investigated