743 research outputs found

    Gallium concentration dependence of room-temperature near-bandedge luminescence in n-type ZnO:Ga

    Full text link
    We investigated the optical properties of epitaxial \textit{n}-type ZnO films grown on lattice-matched ScAlMgO4_4 substrates. As the Ga doping concentration increased up to 6×10206 \times 10^{20} cm3^{-3}, the absorption edge showed a systematic blueshift, consistent with the Burstein-Moss effect. A bright near-bandedge photoluminescence (PL) could be observed even at room temperature, the intensity of which increased monotonically as the doping concentration was increased except for the highest doping level. It indicates that nonradiative transitions dominate at a low doping density. Both a Stokes shift and broadening in the PL band are monotonically increasing functions of donor concentration, which was explained in terms of potential fluctuations caused by the random distribution of donor impurities.Comment: accepted for publication for Applied Physics Letters 4 figure

    Tailoring a two-dimensional electron gas at the LaAlO3/SrTiO3 (001) interface by epitaxial strain

    Full text link
    Recently a metallic state was discovered at the interface between insulating oxides, most notably LaAlO3 and SrTiO3. Properties of this two-dimensional electron gas (2DEG) have attracted significant interest due to its potential applications in nanoelectronics. Control over this carrier density and mobility of the 2DEG is essential for applications of these novel systems, and may be achieved by epitaxial strain. However, despite the rich nature of strain effects on oxide materials properties, such as ferroelectricity, magnetism, and superconductivity, the relationship between the strain and electrical properties of the 2DEG at the LaAlO3/SrTiO3 heterointerface remains largely unexplored. Here, we use different lattice constant single crystal substrates to produce LaAlO3/SrTiO3 interfaces with controlled levels of biaxial epitaxial strain. We have found that tensile strained SrTiO3 destroys the conducting 2DEG, while compressively strained SrTiO3 retains the 2DEG, but with a carrier concentration reduced in comparison to the unstrained LaAlO3/SrTiO3 interface. We have also found that the critical LaAlO3 overlayer thickness for 2DEG formation increases with SrTiO3 compressive strain. Our first-principles calculations suggest that a strain-induced electric polarization in the SrTiO3 layer is responsible for this behavior. It is directed away from the interface and hence creates a negative polarization charge opposing that of the polar LaAlO3 layer. This both increases the critical thickness of the LaAlO3 layer, and reduces carrier concentration above the critical thickness, in agreement with our experimental results. Our findings suggest that epitaxial strain can be used to tailor 2DEGs properties of the LaAlO3/SrTiO3 heterointerface

    Why Some Interfaces Cannot be Sharp

    Full text link
    A central goal of modern materials physics and nanoscience is control of materials and their interfaces to atomic dimensions. For interfaces between polar and non-polar layers, this goal is thwarted by a polar catastrophe that forces an interfacial reconstruction. In traditional semiconductors this reconstruction is achieved by an atomic disordering and stoichiometry change at the interface, but in multivalent oxides a new option is available: if the electrons can move, the atoms don`t have to. Using atomic-scale electron energy loss spectroscopy we find that there is a fundamental asymmetry between ionically and electronically compensated interfaces, both in interfacial sharpness and carrier density. This suggests a general strategy to design sharp interfaces, remove interfacial screening charges, control the band offset, and hence dramatically improving the performance of oxide devices.Comment: 12 pages of text, 6 figure

    Photoemission study of TiO2/VO2 interfaces

    Full text link
    We have measured photoemission spectra of two kinds of TiO2_2-capped VO2_2 thin films, namely, that with rutile-type TiO2_2 (r-TiO2_2/VO2_2) and that with amorphous TiO2_2 (a-TiO2_2/VO2_2) capping layers. Below the Metal-insulator transition temperature of the VO2_2 thin films, 300\sim 300 K, metallic states were not observed for the interfaces with TiO2_2, in contrast with the interfaces between the band insulator SrTiO3_3 and the Mott insulator LaTiO3_3 in spite of the fact that both TiO2_2 and SrTiO3_3 are band insulators with d0d^0 electronic configurations and both VO2_2 and LaTiO3_3 are Mott insulators with d1d^1 electronic configurations. We discuss possible origins of this difference and suggest the importance of the polarity discontinuity of the interfaces. Stronger incoherent part was observed in r-TiO2_2/VO2_2 than in a-TiO2_2/VO2_2, suggesting Ti-V atomic diffusion due to the higher deposition temperature for r-TiO2_2/VO2_2.Comment: 5 pages, 6 figure

    Analysis on reflection spectra in strained ZnO thin films

    Full text link
    Thin films of laser molecular-beam epitaxy grown ZnO films were studied with respect to their optical properties. 4-K reflectivity was used to analyze various samples grown at different biaxial in-plane strain. The spectra show two structures at 3.37 eV corresponding to the A-free exciton transition and at 3.38 eV corresponding to the B-free exciton transition. Theoretical reflectivity spectra were calculated using the spatial dispersion model. Thus, the transverse energies, the longitudinal transversal splitting (ELT,), the oscillator strengths, and the damping parameters were determined for both the A- and B-free excitons of ZnO. As a rough trend, the strain dependence of the energy E_LT for the A-excitons is characterized by a negatively-peaking behavior with a minimum around the zero strain, while ELT for the B-excitons is an increasing function of the strain field values.Comment: 4 pages, 2 figures, 1 table, conference: ICMAT2005 (Singapore), to appear in an issue of J. Cryst. Growt

    Two-dimensional superconductivity at a Mott-Insulator/Band-Insulator interface: LaTiO3/SrTiO3

    Full text link
    Transition metal oxides display a great variety of quantum electronic behaviours where correlations often play an important role. The achievement of high quality epitaxial interfaces involving such materials gives a unique opportunity to engineer artificial structures where new electronic orders take place. One of the most striking result in this area is the recent observation of a two-dimensional electron gas at the interface between a strongly correlated Mott insulator LaTiO3 and a band insulator SrTiO3. The mechanism responsible for such a behaviour is still under debate. In particular, the influence of the nature of the insulator has to be clarified. Here we show that despite the expected electronic correlations, LaTiO3/SrTiO3 heterostructures undergo a superconducting transition at a critical temperature Tc=300 mK. We have found that the superconducting electron gas is confined over a typical thickness of 12 nm. We discuss the electronic properties of this system and review the possible scenarios

    Water release and homogenization by dynamic recrystallization of quartz

    Get PDF
    To evaluate changes in water distribution generated by dynamic recrystallization of quartz, we performed infrared (IR) spectroscopy mapping of quartz in deformed granite from the Wariyama uplift zone in NE Japan. We analyzed three granite samples with different degrees of deformation: almost undeformed, weakly deformed, and strongly deformed. Dynamically recrystallized quartz grains with a grain size of ∼10 µm are found in these three samples, but the percentages of recrystallized grains and the recrystallization processes are different. Quartz in the almost-undeformed sample shows wavy grain boundaries, with a few bulged quartz grains. In the weakly deformed sample, bulging of quartz, which consumed adjacent host quartz grains, forms regions of a few hundred micrometers. In the strongly deformed sample, almost all quartz grains are recrystallized by subgrain rotation. IR spectra of quartz in the three samples commonly show a broad water band owing to H2O fluid at 2800–3750 cm−1, with no structural OH bands. Water contents in host quartz grains in the almost-undeformed sample are in the range of 40–1750 wt ppm, with a mean of 500±280 wt ppm H2O. On the other hand, water contents in regions of recrystallized grains, regardless of the recrystallization processes involved, are in the range of 100–510 wt ppm, with a mean of 220±70 wt ppm; these values are low and homogeneous compared with the contents in host quartz grains. These low water contents in recrystallized regions also contrast with those of up to 1540 wt ppm in adjacent host grains in the weakly deformed sample. Water contents in regions of subgrains are intermediate between those in host and recrystallized grains. These results for water distribution in quartz imply that water was released by dynamic recrystallization.</p
    corecore