407 research outputs found

    The molecular structure of pectic substances

    Get PDF
    Pectic substances is a group designation for those complex colloidal carbohydrate derivatives which occur in, or are prepared from, plants and contain a large pro- portion of galacturonic acid residues existing in chain like combination. The carboxyl groups of the polygalacturonic acids may be partially esterified by methyl groups and partly or completely neutralised by one or more bases

    Assessment of X-point target divertor configuration for power handling and detachment front control

    Get PDF
    A study of long-legged tokamak divertor configurations is performed with the edge transport code UEDGE (Rognlien et al., J. Nucl. Mater. 196, 347, 1992). The model parameters are based on the ADX tokamak concept design (LaBombard et al., Nucl. Fusion 55, 053020, 2015). Several long-legged divertor configurations are considered, in particular the X-point target configuration proposed for ADX, and compared with a standard divertor. For otherwise identical conditions, a scan of the input power from the core plasma is performed. It is found that as the power is reduced to a threshold value, the plasma in the outer leg transitions to a fully detached state which defines the upper limit on the power for detached divertor operation. Reducing the power further results in the detachment front shifting upstream but remaining stable. At low power the detachment front eventually moves to the primary X-point, which is usually associated with degradation of the core plasma, and this defines the lower limit on the power for the detached divertor operation. For the studied parameters, the operation window for a detached divertor in the standard divertor configuration is very small, or even non-existent; under the same conditions for long-legged divertors the detached operation window is quite large, in particular for the X-point target configuration, allowing a factor of 5–10 variation in the input power. These modeling results point to possibility of stable fully detached divertor operation for a tokamak with extended divertor legs.United States. Department of Energy (Contract DE-AC52-07NA27344

    Heat-flux footprints for I-mode and EDA H-mode plasmas on Alcator C-Mod

    Get PDF
    IR thermography is used to measure the heat flux footprints on C-Mod’s outer target in I-mode and EDA H-mode plasmas. The footprint profiles are fit to a function with a simple physical interpretation. The fit parameter that is sensitive to the power decay length into the SOL, λ[subscript SOL], is ~1–3× larger in I-modes than in H-modes at similar plasma current, which is the dominant dependence for the H-mode λ[subscript SOL]. In contrast, the fit parameter sensitive to transport into the private-flux-zone along the divertor leg is somewhat smaller in I-mode than in H-mode, but otherwise displays no obvious dependence on I[subscript p], B[subscript t], or stored energy. A third measure of the footprint width, the “integral width”, is not significantly different between H- and I-modes. Also discussed are significant differences in the global power flows of the H-modes with “favorable” ∇B drift direction and those of the I-modes with “unfavorable” ∇B drift direction.United States. Dept. of Energy (Cooperative Agreement DE-FC02-99-ER54512

    3. Launching the New Enterprise

    Get PDF
    As the academic year of 1945-46 approached, the intensity of activity in preparation for actually opening the school in the fall term became overwhelming. Incredible though it may seem, Ives and Day were able in a period of a few weeks to assemble the nucleus of a faculty, several of whom formed a continuing source of counsel and advice both during the school’s formative years and thereafter. Includes: The First Dean and the School’s Dedication; A Participant’s View of the Early Years; Ives Moves On; Several Views of Martin P. Catherwood; The Founders

    Arterial oxygen content is precisely maintained by graded erythrocytotic responses in settings of high/normal serum iron levels, and predicts exercise capacity: an observational study of hypoxaemic patients with pulmonary arteriovenous malformations.

    No full text
    Oxygen, haemoglobin and cardiac output are integrated components of oxygen transport: each gram of haemoglobin transports 1.34 mls of oxygen in the blood. Low arterial partial pressure of oxygen (PaO2), and haemoglobin saturation (SaO2), are the indices used in clinical assessments, and usually result from low inspired oxygen concentrations, or alveolar/airways disease. Our objective was to examine low blood oxygen/haemoglobin relationships in chronically compensated states without concurrent hypoxic pulmonary vasoreactivity.165 consecutive unselected patients with pulmonary arteriovenous malformations were studied, in 98 cases, pre/post embolisation treatment. 159 (96%) had hereditary haemorrhagic telangiectasia. Arterial oxygen content was calculated by SaO2 x haemoglobin x 1.34/100.There was wide variation in SaO2 on air (78.5-99, median 95)% but due to secondary erythrocytosis and resultant polycythaemia, SaO2 explained only 0.1% of the variance in arterial oxygen content per unit blood volume. Secondary erythrocytosis was achievable with low iron stores, but only if serum iron was high-normal: Low serum iron levels were associated with reduced haemoglobin per erythrocyte, and overall arterial oxygen content was lower in iron deficient patients (median 16.0 [IQR 14.9, 17.4]mls/dL compared to 18.8 [IQR 17.4, 20.1]mls/dL, p<0.0001). Exercise tolerance appeared unrelated to SaO2 but was significantly worse in patients with lower oxygen content (p<0.0001). A pre-defined athletic group had higher Hb:SaO2 and serum iron:ferritin ratios than non-athletes with normal exercise capacity. PAVM embolisation increased SaO2, but arterial oxygen content was precisely restored by a subsequent fall in haemoglobin: 86 (87.8%) patients reported no change in exercise tolerance at post-embolisation follow-up.Haemoglobin and oxygen measurements in isolation do not indicate the more physiologically relevant oxygen content per unit blood volume. This can be maintained for SaO2 ≥78.5%, and resets to the same arterial oxygen content after correction of hypoxaemia. Serum iron concentrations, not ferritin, seem to predict more successful polycythaemic responses

    Investigation of RF-enhanced plasma potentials on Alcator C-Mod

    Get PDF
    Radio frequency (RF) sheath rectification is a leading mechanism suspected of causing anomalously high erosion of plasma facing materials in RF-heated plasmas on Alcator C-Mod. An extensive experimental survey of the plasma potential (Φ[subscript P]) in RF-heated discharges on C-Mod reveals that significant Φ[subscript P] enhancement (>100 V) is found on outboard limiter surfaces, both mapped and not mapped to active RF antennas. Surfaces that magnetically map to active RF antennas show Φ[subscript P] enhancement that is, in part, consistent with the recently proposed slow wave rectification mechanism. Surfaces that do not map to active RF antennas also experience significant Φ[subscript P] enhancement, which strongly correlates with the local fast wave intensity. In this case, fast wave rectification is a leading candidate mechanism responsible for the observed enhancement.United States. Dept. of Energy (DE-FC02-99ER54512

    Household-level predictors of the presence of servants in Northern Orkney, Scotland, 1851–1901

    Get PDF
    Servants were an important part of the northwestern European household economy in the preindustrial past. This study examines household-level characteristics that are predictive of the presence of rural servants using data from Orkney, Scotland. The number of servants present in a household is related to household composition, landholding size, and the marital status of the household head. In addition, the sex of the particular servant hired reveals that the labor of male and female servants is not fungible. The sex of the servant hired is related to the ratio of male and female household members of working age, the occupation of the head, household composition, and the size of the household\u27s landholding

    Measurement of LHCD edge power deposition through modulation techniques on Alcator C-Mod

    Get PDF
    The efficiency of LHCD on Alcator C-Mod drops exponentially with line average density. At reactor relevant densities (> 1 · 1020 [m[-3 superscript]]) no measurable current is driven. While a number of causes have been suggested, no specific mechanism has been shown to be responsible for the loss of current drive at high density. Fast modulation of the LH power was used to isolate and quantify the LHCD deposition within the plasma. Measurements from these plasmas provide unique evidence for determining a root cause. Modulation of LH power in steady plasmas exhibited no correlated change in the core temperature. A correlated, prompt response in the edge suggests that the loss in efficiency is related to a edge absorption mechanism. This follows previous results which found the generation of n||-independent SOL currents. Multiple Langmuir probe array measurements of the conducted heat conclude that the lost power is deposited near the last closed flux surface. The heat flux induced by LH waves onto the outer divertor is calculated. Changes in the neutral pressure, ionization and hard X-ray emission at high density highlight the importance of the active divertor in the loss of efficiency. Results of this study implicate a mechanism which may occur over multiple passes, leading to power absorption near the LCFS
    corecore