7,443 research outputs found
Physics Behind Precision
This document provides a writeup of contributions to the FCC-ee mini-workshop
on "Physics behind precision" held at CERN, on 2-3 February 2016.Comment: https://indico.cern.ch/event/469561
Results on Multiple Coulomb Scattering from 12 and 20 GeV electrons on Carbon targets
Multiple scattering effects of 12 and 20 GeV electrons on 8 and 20 mm
thickness carbon targets have been studied with high-resolution silicon
microstrip detectors of the UA9 apparatus at the H8 line at CERN. Comparison of
the scattering angle between data and GEANT4 simulation shows excellent
agreement in the core of the distributions leaving some residual disagreement
in the tails.Comment: 14 pages, 16 figures. Updated to match published versio
Single-hit resolution measurement with MEG II drift chamber prototypes
Drift chambers operated with helium-based gas mixtures represent a common
solution for tracking charged particles keeping the material budget in the
sensitive volume to a minimum. The drawback of this solution is the worsening
of the spatial resolution due to primary ionisation fluctuations, which is a
limiting factor for high granularity drift chambers like the MEG II tracker. We
report on the measurements performed on three different prototypes of the MEG
II drift chamber aimed at determining the achievable single-hit resolution. The
prototypes were operated with helium/isobutane gas mixtures and exposed to
cosmic rays, electron beams and radioactive sources. Direct measurements of the
single hit resolution performed with an external tracker returned a value of
110 m, consistent with the values obtained with indirect measurements
performed with the other prototypes.Comment: 18 pages, 18 figure
MEG Upgrade Proposal
We propose the continuation of the MEG experiment to search for the charged
lepton flavour violating decay (cLFV) \mu \to e \gamma, based on an upgrade of
the experiment, which aims for a sensitivity enhancement of one order of
magnitude compared to the final MEG result, down to the
level. The key features of this new MEG upgrade are an increased rate
capability of all detectors to enable running at the intensity frontier and
improved energy, angular and timing resolutions, for both the positron and
photon arms of the detector. On the positron-side a new low-mass, single
volume, high granularity tracker is envisaged, in combination with a new highly
segmented, fast timing counter array, to track positron from a thinner stopping
target. The photon-arm, with the largest liquid xenon (LXe) detector in the
world, totalling 900 l, will also be improved by increasing the granularity at
the incident face, by replacing the current photomultiplier tubes (PMTs) with a
larger number of smaller photosensors and optimizing the photosensor layout
also on the lateral faces. A new DAQ scheme involving the implementation of a
new combined readout board capable of integrating the diverse functions of
digitization, trigger capability and splitter functionality into one condensed
unit, is also under development. We describe here the status of the MEG
experiment, the scientific merits of the upgrade and the experimental methods
we plan to use.Comment: A. M. Baldini and T. Mori Spokespersons. Research proposal submitted
to the Paul Scherrer Institute Research Committee for Particle Physics at the
Ring Cyclotron. 131 Page
Measurement of the radiative decay of polarized muons in the MEG experiment
We studied the radiative muon decay by
using for the first time an almost fully polarized muon source. We identified a
large sample (~13000) of these decays in a total sample of 1.8x10^14 positive
muon decays collected in the MEG experiment in the years 2009--2010 and
measured the branching ratio B() =
(6.03+-0.14(stat.)+-0.53(sys.))x10^-8 for E_e > 45 MeV and E_{\gamma} > 40 MeV,
consistent with the Standard Model prediction. The precise measurement of this
decay mode provides a basic tool for the timing calibration, a normalization
channel, and a strong quality check of the complete MEG experiment in the
search for process.Comment: 8 pages, 7 figures. Added an introduction to NLO calculation which
was recently calculated. Published versio
The MEG detector for decay search
The MEG (Mu to Electron Gamma) experiment has been running at the Paul
Scherrer Institut (PSI), Switzerland since 2008 to search for the decay \meg\
by using one of the most intense continuous beams in the world. This
paper presents the MEG components: the positron spectrometer, including a thin
target, a superconducting magnet, a set of drift chambers for measuring the
muon decay vertex and the positron momentum, a timing counter for measuring the
positron time, and a liquid xenon detector for measuring the photon energy,
position and time. The trigger system, the read-out electronics and the data
acquisition system are also presented in detail. The paper is completed with a
description of the equipment and techniques developed for the calibration in
time and energy and the simulation of the whole apparatus.Comment: 59 pages, 90 figure
New constraint on the existence of the mu+-> e+ gamma decay
The analysis of a combined data set, totaling 3.6 \times 10^14 stopped muons
on target, in the search for the lepton flavour violating decay mu^+ -> e^+
gamma is presented. The data collected by the MEG experiment at the Paul
Scherrer Institut show no excess of events compared to background expectations
and yield a new upper limit on the branching ratio of this decay of 5.7 \times
10^-13 (90% confidence level). This represents a four times more stringent
limit than the previous world best limit set by MEG.Comment: 5 pages, 3 figures, a version accepted in Phys. Rev. Let
Proceedings of the Workshop on Monte Carlo's, Physics and Simulations at the LHC PART II
These proceedings collect the presentations given at the first three meetings
of the INFN "Workshop on Monte Carlo's, Physics and Simulations at the LHC",
held at the Frascati National Laboratories in 2006. The first part of these
proceedings contains pedagogical introductions to several basic topics of both
theoretical and experimental high pT LHC physics. The second part collects more
specialised presentations.Comment: 157 pages, 136 figures; contribution by M. Grazzini has been adde
Global Decay Chain Vertex Fitting at B-Factories
We present a particle vertex fitting method designed for B factories. The
presented method uses a Kalman Filter to solve a least squares estimate to
globally fit decay chains, as opposed to traditional methods that fit each
vertex at a time. It allows for the extraction of particle momenta, energies,
vertex positions and flight lengths, as well as the uncertainty estimates of
these quantities. Furthermore, it allows for the precise extraction of vertex
parameters in complex decay chains containing neutral final state particles,
such as or , which cannot properly be tracked due to limited
spatial resolution of longitudinally segmented single-layer crystal
calorimeters like the Belle II ECL. The presented technique can be used to
suppress combinatorial background and improve resolutions on measured
parameters. We present studies using Monte Carlo simulations of collisions in
the Belle II experiment, where modes with neutrals are crucial to the physics
analysis program
- âŠ