26 research outputs found
An islanded microgrid energy management controller validated by using Hardware-In-the-Loop Emulators
A novel microgrid emulator used to test multiple microgrid configurations and energy management control strategies is presented. The system includes Hardware-In-the-Loop (HIL) emulators for geothermal and biogas energy sources. It also includes actual photovoltaic energy together with a lead acid battery bank for storage and it is controlled by a two level control system. The control system consists of a primary level voltage-reactive power and frequency-active power and a secondary level energy management algorithm based on the balance between the power produced by the renewable energy generators, state of charge of the battery bank and the loads. The energy management control strategy is based on cycle-charging the batteries at a reference value in order to efficiently use the available resources. The primary energy source is considered the geothermal energy, while the most cost effective one is the photovoltaic energy. A buffer zone is kept in the battery bank in order to store as much energy produced by the photovoltaic system as possible. The presented microgrid, used for testing the energy management strategies, employs emulators for the geothermal and biogas generators; however, the results are relevant and can be scaled for a real-life microgrid
Renewable energy EV charging station
Due to the increased interest in electric vehicle (EV) technologies and the cost reduction of photovoltaic systems, industrial development of battery charging stations for electric vehicles based on solar energy has started. Although it is convenient to charge EVs at night, when there is less electricity consumption, there will always be consumers who prefer or need to charge their EV during daytime and even during peak hours. In this paper, an EV charging station integrating renewable energy in the form of solar energy is proposed and analyzed. Using a local battery pack, the charging station allows semi-fast and fast charging and can be installed in individual homes and apartment buildings, where the maximum power delivered by the grid is limited to 3.6kW. The charging station uses converters widely available on the market. A simulation model for this charging station is developed and various distinct operation modes are presented, validating the correct operation of the entire system
Modelling and simulation of a remote controlled mechatronic device
The paper introduces the design, modelling and simulation of an electromechanical actuator device able to produce periodical translation movement. The parameters characterizing this movement (stroke length, force, speed profile) are considered to be remotely programmable via a wireless interface
Application of the Filippov method for the stability analysis of a photovoltaic system
International audienceThis paper describes bifurcation phenomena of a photovoltaic system. The studied photovoltaic (PV) system includes a solar panel, a boost converter, a maximum power point tracking (MPPT) controller and a storage device. Computer simulations are performed to capture the effects of variation of some chosen parameters on the qualitative behavior of the system. The impact of the maximum power point (MPP) current and voltage variations due to luminosity changes is determinate, as well as the load variation. The stability of the system is analyzed using the state transition matrix over one switching cycle (the monodromy matrix) including the state transition matrices during each switching (the saltation matrices). This investigation is important to predict nonlinear phenomena and for the components dimensioning for a proper functioning