14 research outputs found
RESEARCHES CONCERNING IMPROVING METHODS OF IN VITRO MICROTUBERS PRODUCTION
Five genotypes of potato (Solanum tuberosum L.) were induced to form microtubers under two in vitro culture conditions (continuos darkness and light). Cultures maintained under continuos darkness (with a temperatue of 170C) had a higher yield with a greater number of microtuber (1.394/plantlet) than those maintained under long days (16 h of light/day) combined with temperature of 200C. In the last case the microtubers were higher, with with the highest average weight of 0.602 g. Three phytohormones it was used: coumarine, benzylaminopurine and salicylic acid. Regarding the average number of microtubers obtained when it was used coumarine and salicylic acid, the highest average number of microtubers was recorded (1,135 microtubers/plantlet). The study had been performed also on two fractions of the of sugar quantity (80 and 140 g/l), but they had less influence compared to the varieties
The incidence of Mop-Top and Aucuba potato viruses in several Romanian areas (preliminary studies)
PMTV (Potato Mop-Top Virus ) an PAMV (Potato Aucuba Mosaic Virus) are new Romanian damaging pathogens of
potato crop. They can cause serious reduced yield and decrease of the tuber’s quality. In case of these viruses, infected
plants do not allways show symptoms and symptom depends on potato cultivar, virus strain and the environment.
PMTV and PAMV infection of material plants can produce spraing in tubers of sensitive varieties. PMTV cause heavy
losses in northen Europe and it is very difficult to control. Foliar symptoms include bright yellow blotch (Aucuba), a
’V’-shaped yellow pattern, deformed leaves and internode shortening. PAMV is a helping virus for devlopment of
dangerous potyvirus like Potato Virus Y (PVY). Elimination of all these pathogens from potato supply is essential for
potato production and the choice of resistant varieties to the infection with these viruses could be one of the measures
recommended for farmers and producers. The results of this preliminary study show that PMTV and PAMV were not
found in the material collected from the following varieties: Armonia, Azaria, Christian, Cosiana and Millenium
(samples collected from the counties Braşov, Covasna, Harghita, Suceava in 2019 and 2020)
Optimization of sweet potato (Ipomoea batatas L.) in vitro cultivation by using the contaminated cultures for obtaining new shoots in greenhouse conditions
The artificial media used for plant tissue cultures contains numerous nutrients that can create favorable conditions for
the development of pathogens. As antibiotic use is not encouraged, a new strategy has been tried to reduce the losses
caused by the presence of microbial infections in "in vitro" cultivation of sweet potato. This consisted in the
transplantation in greenhouse conditions of sweet potato plantlets from contaminated "in vitro" cultures, in order to
obtain new shoots. Five sweet potato varieties were used in this study, and two types of substrate for planting: pearlite
and a mixture of peat and pearlite (1:1). The survival rate of the plantlets was 100% on the substrate consisting only of
pearlite. The surviving sweet potato plants had a rapid growth rate, the greenhouse conditions being favorable for this
culture. Approximately two months after transplantation, the obtained shoots could be used as a source of explants to
initiate new "in vitro" cultures. Regarding the number of shoots the highest value was obtained by the Yulmi variety.
The length of the shoots varied according to the variety, thus the highest value was recorded by the KSC1 variety (98.30
cm) . The number of buds/shoot is strongly influenced by the variety. In some sweet potato varieties the distance
between buds is smaller, and in others larger, this being a characteristic of the variety. Regarding this trait the best
results were obtained in Juhwangmi variety. By applying this method, the process of sweet potato "in vitro"
multiplication becomes more economically efficient. After only a few weeks under greenhouse conditions, involving
minimal costs, many shoots can be obtained
Research on the influence of culture technology, for certain potato cultivars in Lazarea - Harghita county, Romania
Our goals were to increase the coefficient of seed potato, using different calibration classes for next cultivars: Ostara,
Christian, Roclas, Desiree; development of planting material with high biological value from the fraction <25 mm
(minitubers) compared with 25-35mm fraction; elaboration of differentiated technological variants (including sequence
of technology culture and pest control performance); obtaining virus-free planting material (without infection) and a
bigger amount of seed. Minitubers size 25-35mm planting influenced obtain higher yields than 15-25mm size, both in
open field cultivation and in the tunnel. The research was conducted over two years, and watched the production of
potato seed obtained, by planting minitubers to different planting densities and applying two tehgnologii culture, open
field and tunnel in insect proof. Planting density of 8 tubers / linear meter determined obtaining the highest yields of
potato varietie
In vitro selection of true potato seed genotypes tolerant to drought stress
The biological material used in this study was produced from true potato seed (TPS). Nine genotypes (MIL19-01-08,
MIL19-01-22, MIL19-01-37, ZIL19-02-01 , ZIL19-02-11, ZIL19-02-43, GIL19-03-07, GIL19-03-29 and GIL19-03-38)
were tested in vitro for drought tolerance. Four treatments were used to induce in vitro water stress: MS medium with
three different concentrations of PEG (1%, 1.5%, 2%) and one variant of MS medium without PEG as control. On
culture medium variant with highest concentration of PEG (2%) GIL19-03-29 obtained best results for plantlet height
(11.08 cm), leaf number (9.50), root number (5.33), fresh plant weight (0.167 g). In stress conditions GIL19-03-07
recorded best results for plant fresh weight (0.173 g), root length (7.17 cm), plantlet height (12.28 cm) on PEG 1%.
Also, ZIL19-02-43 obtained higher values on the culture medium variants with the highest level of water stress for
parameters such as root fresh weight (0.146 g), plant fresh weight (0.163 g), root length (7.08 cm) on PEG 1.5%. The
potato genotypes GIL19-03-29, GIL19-03-07 and ZIL19-02-43 showed the best tolerance to the water deficit and were
selected for further assessments both in protected area (greenhouse) and open-field conditions
Researches regarding the minitubers production from potato lines
In this study was done researches about minitubers production from 14 potato lines studied: TS 12-1488-1574, TS 12-
1489-1574, TS 12-1497-1573, TS 11-1475-1633, TS 12-1502-1675, TS 11-1472-1633, TS 11-1468-1633, TS 09-1441-
1525, TS 11-1486-1642, TS 12-1501-1582, TS 11-1480-1633, TS 96 -1207-169, TS 11-1467-1633, TS 09-1442-1525.
The experience was monofactorial, in which the analyzed factor was the genotype, consisted of 14 variants, divided into
3 repetitions. As a control, the average of the determined values was determined for each parameter taken in the study.
The parameters analyzed were: minitubers number / plant and minitubers weight minitubers / pl. TS 12-1489-1574
potato line was the most representative, being a productive line, which was distinguished by a number of 11.83
minitubers / plant and a significantly positive difference of + 4.21 comparative with control taken in the study. Weight
of minitubers / plant was influenced by genotype, proving superiority TS11-1468-1633 potato line which had a good
capacity to produce minitubers with high weight (295.17 g) (and a distinct significant difference, positive, to control
+114,83). Thus, this potato line has a high potential for producing high yields
Behaviour of different potato varieties by simulating in vitro of hydric stress conditions
The water deficit, extreme temperatures and low atmospheric humidity lead to drought, which is one of the limiting
factors affecting crop quality and quantity. In vitro selection may shorten considerably the time selection of desirable
traits and completes selection in the field. In vitro tissue culture can be used to determine the drought tolerance of the
various varieties assuming that there is a correlation between plant cells in vitro and in vivo. For determining the
resistance to water stress, the research was conducted in the Laboratory of Vegetal Tissue Culture and experience
consisted of two factors: variety and nutritive medium with different osmotic agents. With the increasing amount of
sorbitol and PEG, water absorption becomes difficult for plantlets from nutrient medium and thus was simulate the
effect of drought over microplants. With the increasing amount of sorbitol or PEG into the growth medium, the drought
intensity was bigger. Observations were made for different parameters: the average number of leaves; the average
number of internodes; the average height of plantlet (cm); the average root length (cm); the average weight of fresh
plantlet (mg); the average fresh root weight (mg). This study was performed in order to determine the best osmotic
agent put into the in vitro medium for simulate the water stress, as well as for for testing the particular genotypes
genotypes on different culture media causing selection pressure of water stress
CHALLENGES AND SOLUTIONS WITHIN IN VITRO PROPAGATION OF SWEET POTATO (IPOMOEA BATATAS L.)
The purpose of this study was to find viable solutions for problems encountered during in vitro cultivation of sweet potato (Ipomoea batatas (L.) Lam.). Plant tissue culture are especially suitable for obtaining and maintaining a stock of pathogen-free plants, which can then be multiplied and used as an initial material. Although tissue cultures, carried out under controlled conditions, in a sterile environment, have important applications in plant biotechnologies, however, there are many factors that can influence their success. In addition to the minimum equipment of a plant tissue culture laboratory good function (adequate spaces, equipment, chemicals, laboratory glassware and tools etc.) and trained workers, the success of such an activity also depends on finding the best conditions for the harmonious growth and development of plant organisms, in a controlled environment. These challenges relate in particular to: introducing in vitro conditions of biological material from the in vivo environment; sterilization of the material which will be used as a source of explants; choosing a suitable growth medium, microbial contamination control; establishing optimal parameters in terms of temperature and photoperiod etc. The factors mentioned above vary by species and, more than that, by variety. In this study, the research was carried out over four years, on five Korean sweet potato varieties, at the Research Laboratory for Plant Tissue Cultures of the National Research and Development Institute for Potato and Sugar Beet, Brasov
PREPARATIONS PRO-IMPLANT VERSUS PRO-PROSTHETIC
The aim of this study is to analyze the role of training in the therapeutic algorithm of pro-prosthetic of partial
large edentulous, the interventions correlate with the peculiarity of the clinical case, providing the necessary
conditions for modern approach for therapeutic solutions.We studied a group consisting of 60 patients aged
between 35 and 75 years old, who were present in Clinic Base for Education of the Faculty of Dental Medicine
and in private practice surgery, they signed a consent form with information about their participation in this
study. The patients of the analyzed lot are diagnosed with large partial edentulous of varied ethiology and
complications due to different prosthesis, incorrect prothesis or not having prothesis, with complete prosthetics,
incomplete or lacking prothesis. The need for sinus lifting pro-prosthetic procedure is required in 40% of cases
with a marked resorption at the posterior jaw for clinical cases in which the therapeutic solution chosen is the
rehabilitation of the prosthetic implants, in 60% of cases the rehabilitation can be performed without sinus lift.
The pro implant vs. pro-prosthetic implantation have a role in therapeutic success, providing optimization of the
type of the support characterized by negative indice
The Growth Response of Several Potato Genotypes (<i>Solanum tuberosum</i> L.) to Induced Water Stress Using Sorbitol and Polyethylene Glycol
The current paper aimed to study the in vitro response of potato genotypes to water stress induced by adding sorbitol and polyethylene glycol in the culture medium. The biological material analysed in the experiment was represented by a Romanian line ‘LP 11-1525/1’ and two isogenic lines ‘LI 101’ and ‘LI 102’. For cultures initiation, the line ‘LP 11-1525/1’ was started from meristems and for the other two genotypes true potato seeds were used. The studied potato genotypes behaved differently depending on the analysed parameters and on the treatment applied for drought tolerance. It was noted that the line ‘LP 11-1525/1’ achieved good results for most of the growth parameters studied, and also the lines derived from true potato seeds behaved well, in some cases even exceeding the line derived from meristems. Of the lines derived from true potato seeds, the best performance was noted for line ‘LI 101-6’ in all the analysed parameters, both on sorbitol and PEG medium. In addition, lines ‘LI 101-7’ and ‘LI 102-4’ achieved good results on both variants of medium used to mediate water stress. Therefore, establishing drought tolerance individuals within populations derived from true potato seeds using sorbitol and polyethylene glycol might be applied