Development and operation of a real-time data acquisition system for the NASA, Langley Research Center Differential Absorption Lidar

The capabilities of the DIAL data acquisition system (DAS) for the remote measurement of atmospheric trace gas concentrations from ground and aircraft platforms were extended through the purchase and integration of other hardware and the implementation of improved software. An operational manual for the current system is presented. Hardware and peripheral device registers are outlined only as an aid in debugging any DAS problems which may arise

Evaluation of atmospheric trace constituent sensors operating from remote space and airborne platforms

A laboratory gas analysis system was developed specifically to make trace level measurements of carbon monoxide. To assure that the data collected with this system are correctly aligned with other established methods for making these measurements, an intercalibration study was conducted. The calibration gas was analyzed by the various participating laboratories and found to contain 1.28 ppm CO. Samples were collected at 25 deg, 35 deg, and 45 deg N for profile data to study the variation in concentrations of CO and CH4 as a function of altitude and latitude in continental air over the eastern seaboard of the United States. The experiment was repeated several months later to determine if there were seasonally dependent variations in the CO and CH4 concentrations

The evaluation of a HgCdTe photomixer with a Tunable Diode Laser (TDL) and the evaluation of TDL's as a local oscillator in a heterodyne detection system

Heterodyne systems would be much more versatile if a broadly tunable laser, such as a semiconductor diode laser (TDL), could be used as the local oscillator (LO). Previous studies have shown that while a TDL can be used as an LO, the TDL lack sufficient power to cause the signal-to-noise ratio to be shot noise limited. The heterodyne system with a HgCdTe photodiode as the LO was characterized and the beat frequency response of the heterodyne systems was mapped out

Determination of transfer function of COPE correlation interferometer instrument

The comparison of theoretical and instrument response functions and its use as a procedure for determining the transfer function of the COPE correlation interferometer are summarized. Data show qualitative agreement can be obtained when discrepancies between theory and instrument are investigated and instrument components are analyzed in detail. Data were obtained using a set of calibration data and computer algorithms

The determination of atmospheric trace gases using the correlation interferometer technique

The theoretical feasibility inherent in the correlation interferometry technique is demonstrated. High signal to noise and increased information content in a given partial interferogram are attractive features of the technique. The separation of interfering gas species is overcome by a precise measurement program for spectral line parameters of methane and other species. There are optical, mechanical, and electronic difficulties with the interferometry hardware design. Flight data from Cessna 402 over southeastern Virginia during April 1978 yielded amplitude fluctuations that are explainable only as internal nonlinearities. Misalignment of the AGC/interferometer optical axis also contributed to a large error source in the flight data. It is concluded that no useful data on gas burdens was obtained from these flights

Analysis of impact of Busch Gardens expansion on air quality of surrounding area

This report is concerned primarily with the increase in carbon monoxide concentrations and hydrocarbon concentrations induced by the projected increased traffic that would be associated with the parking facilities planned to support the expansion of Busch Gardens (Virginia) planned for the summar of 1976. Of primary concern is the integrated effect of the increased traffic that will be handled by existing facilities and an enlarged parking lot across the highway from the main Busch Garden attraction

Sampling strategies and four-dimensional assimilation of altimetric data for ocean monitoring and prediction

Numerical experiments using simulated altimeter data were conducted in order to examine the assimilation of altimeter-derived sea surface heights into numerical ocean circulation models. A reduced-gravity, primitive equation circulation model of the Gulf of Mexico was utilized; the Gulf of Mexico was chosen because of its amenability to modeling and the ability of low vertical-mode models to reproduce the observed dynamical features of the Gulf circulation. The simulated data were obtained by flying an imaginary altimeter over the model ocean and sampling the model sea surface just as real altimeter would observe the true ocean. The data were used to initialize the numerical model and the subsequent forecast was compared to the true numerical solution. Results indicate that for a stationary, circular eddy, approximately three to four tracks (either ascending or descending) across the eddy are sufficient to ensure adequate spatial resolution

A theoretical/experimental program to develop active optical pollution sensors

Light detection and ranging (LIDAR) technology was applied to the assessment of air quality, and its usefulness was evaluated by actual field tests. Necessary hardware was successfully constructed and operated in the field. Measurements of necessary physical parameters, such as SO2 absorption coefficients were successfully completed and theoretical predictions of differential absorption performance were reported. Plume modeling improvements were proposed. A full scale field test of equipment, data analysis and auxiliary data support was conducted in Maryland during September 1976

An experimental/analytical program to assess the utility of lidar for pollution monitoring

The development and demonstration of lidar techniques for the remote measurement of atmospheric constituents and transport processes in the lower troposphere was carried out. Particular emphasis was given to techniques for monitoring SO2 and particulates, the principal pollutants in power plant and industrial plumes. Data from a plume dispersion study conducted in Maryland during September and October 1976 were reduced, and a data base was assembled which is available to the scientific community for plume model verification. A UV Differential Absorption Lidar (DIAL) was built, and preliminary testing was done