Experimental observation of the effect of aftercavity interaction in a depressed collector gyrotron oscillator

This paper presents the experimental observation of the effect of an aftercavity interaction (ACI) in a depressed collector gyrotron oscillator. The gyrotron generates an output power of 1.5 MW at 110 GHz in 3 ??s pulses with a 96 kV and 40 A electron beam and has a single-stage depressed collector. The ACI arises from an unintended cyclotron resonant interaction between the microwave beam traveling out from the cavity and the gyrating electron beam. The interaction occurs in the uptaper of the launcher, immediately downstream from the cavity, where the magnetic field is slightly lower than its value in the cavity region. The ACI results in a reduction in efficiency since the electron beam tends to extract power from the wave. There is also a broadening of the spent beam energy profile, which reduces the effectiveness of the depressed collector and in turn limits the overall efficiency of a gyrotron. Measurements of the maximum depression voltage of the collector vs beam current at 96 kV are compared with simulations from the MAGY code [M. Botton, IEEE Trans. Plasma Sci. 26, 882 (1998)]. Excellent agreement is obtained between theory and experiment but only if the ACI is included. In the present experiment, it is estimated that the observed efficiency of 50% would have been about 60% in the absence of the ACI. These results verify the role of the ACI in reducing the efficiency of the gyrotron interaction.open151

Experimental results for a 1.5 MW, 110 GHz gyrotron oscillator with reduced mode competition

A new result from a 110 GHz gyrotron at MIT is reported with an output power of 1.67 MW and an efficiency of 42% when operated at 97 kV and 41 A for 3 mu s pulses in the TE22,6 mode. These results are a major improvement over results obtained with an earlier cavity design, which produced 1.43 MW of power at 37% efficiency. These new results were obtained using a cavity with a reduced output taper angle and a lower ohmic loss when compared with the earlier cavity. The improved operation is shown experimentally to be the result of reduced mode competition from the nearby TE19,7 mode. The reduced mode competition agrees well with an analysis of the startup scenario based on starting current simulations. The present results should prove useful in planning long pulse and CW versions of the 110 GHz gyrotron.open141

Cryogenic sample exchange NMR probe for magic angle spinning dynamic nuclear polarization

We describe a cryogenic sample exchange system that dramatically improves the efficiency of magic angle spinning (MAS) dynamic nuclear polarization (DNP) experiments by reducing the time required to change samples and by improving long-term instrument stability. Changing samples in conventional cryogenic MAS DNP/NMR experiments involves warming the probe to room temperature, detaching all cryogenic, RF, and microwave connections, removing the probe from the magnet, replacing the sample, and reversing all the previous steps, with the entire cycle requiring a few hours. The sample exchange system described here—which relies on an eject pipe attached to the front of the MAS stator and a vacuum jacketed dewar with a bellowed hole—circumvents these procedures. To demonstrate the excellent sensitivity, resolution, and stability achieved with this quadruple resonance sample exchange probe, we have performed high precision distance measurements on the active site of the membrane protein bacteriorhodopsin. We also include a spectrum of the tripeptide N-f-MLF-OH at 100 K which shows 30 Hz linewidths.National Institute for Biomedical Imaging and Bioengineering (U.S.) (Grant EB-002804)National Institute for Biomedical Imaging and Bioengineering (U.S.) (Grant EB-001960)National Institute for Biomedical Imaging and Bioengineering (U.S.) (Grant EB-001035)National Institute for Biomedical Imaging and Bioengineering (U.S.) (Grant EB-002026)National Institute for Biomedical Imaging and Bioengineering (U.S.) (Grant EB-003151)National Science Foundation (U.S.). Graduate Research Fellowship Progra

Observation of large arrays of plasma filaments in air breakdown by 1.5-MW 110-GHz gyrotron pulses

We report the observation of two-dimensional plasma filamentary arrays with more than 100 elements generated during breakdown of air at atmospheric pressure by a focused Gaussian beam from a 1.5-MW, 110-GHz gyrotron operating in 3-mu s pulses. Each element is a plasma filament elongated in the electric field direction and regularly spaced about one-quarter wavelength apart in the plane perpendicular to the electric field. The development of the array is explained as a result of diffraction of the beam around the filaments, leading to the sequential generation of high intensity spots, at which new filaments are created, about a quarter wavelength upstream from each existing filament. Electromagnetic wave simulations corroborate this explanation and show very good correlation to the observed pattern of filaments.open424

Plasma structures observed in gas breakdown using a 1.5 MW, 110 GHz pulsed gyrotron

Regular two-dimensional plasma filamentary arrays have been observed in gas breakdown experiments using a pulsed 1.5 MW, 110 GHz gyrotron. The gyrotron Gaussian output beam is focused to an intensity of up to 4 MW/ cm2. The plasma filaments develop in an array with a spacing of about one quarter wavelength, elongated in the electric field direction. The array was imaged using photodiodes, a slow camera, which captures the entire breakdown event, and a fast camera with a 6 ns window. These diagnostics demonstrate the sequential development of the array propagating back toward the source. Gases studied included air, nitrogen, SF6, and helium at various pressures. A discrete plasma array structure is observed at high pressure, while a diffuse plasma is observed at lower pressure. The propagation speed of the ionization front for air and nitrogen at atmospheric pressure for 3 MW/ cm2 was found to be of the order of 10 km/s.open322

Resolution and Polarization Distribution in Cryogenic DNP/MAS Experiments

This contribution addresses four potential misconceptions associated with high-resolution dynamic nuclear polarization/magic angle spinning (DNP/MAS) experiments. First, spectral resolution is not generally compromised at the cryogenic temperatures at which DNP experiments are performed. As we demonstrate at a modest field of 9 T (380 MHz [superscript 1]H), 1 ppm linewidths are observed in DNP/MAS spectra of a membrane protein in its native lipid bilayer, and <0.4 ppm linewidths are reported in a crystalline peptide at 85 K. Second, we address the concerns about paramagnetic broadening in DNP/MAS spectra of proteins by demonstrating that the exogenous radical polarizing agents utilized for DNP are distributed in the sample in such a manner as to avoid paramagnetic broadening and thus maintain full spectral resolution. Third, the enhanced polarization is not localized around the polarizing agent, but rather is effectively and uniformly dispersed throughout the sample, even in the case of membrane proteins. Fourth, the distribution of polarization from the electron spins mediated via spin diffusion between [superscript 1]H–[superscript 1]H strongly dipolar coupled spins is so rapid that shorter magnetization recovery periods between signal averaging transients can be utilized in DNP/MAS experiments than in typical experiments performed at ambient temperature.National Institutes of Health (U.S.) (Grant EB002804)National Institutes of Health (U.S.) (Grant EB003151)National Institutes of Health (U.S.) (Grant EB002026)National Institutes of Health (U.S.) (Grant EB001965)National Institutes of Health (U.S.) (Grant EB004866)National Science Foundation (U.S.). Graduate Research Fellowship Progra

17 GHz photonic band gap cavity with improved input coupling

We present the theoretical design and cold test of a 17 GHz photonic band gap (PBG) cavity with improved coupling from an external rectangular waveguide. The PBG cavity is made of a triangular lattice of metal rods with a defect (missing rod) in the center. The TM_{010}-like defect mode was chosen as the operating mode. Experimental results are presented demonstrating that critical coupling into the cavity can be achieved by partial withdrawal or removal of some rods from the lattice, a result that agrees with simulations. A detailed design of the PBG accelerator structure is compared with a conventional (pillbox) cavity. One advantage of the PBG cavity is that its resonance frequency is much less perturbed by the input/output coupling structure than in a comparable pillbox cavity. The PBG structure is attractive for future accelerator applications

Design of an overmoded W-band TWT

We report on the design and cold test validation of an overmoded TWT capable of producing power in excess of 100 Watts in the W-band and above. The TWT operates in the TM31 mode of a rectangular cavity and has transverse dimensions three times larger than a conventional ladder TWT. Dielectric loading of a resonant cavity was utilized to suppress lower order modes and prevent parasitic oscillations. HFSS and MAGIC3D codes were used to predict performance. An X-Ku band scaled down version of the interaction structure was built and cold tests performed on it showed excellent agreement with HFSS simulations.United States. Air Force Office of Scientific Researc