Ultra-low phase noise all-optical microwave generation setup based on commercial devices

In this paper, we present a very simple design based on commercial devices for the all-optical generation of ultra-low phase noise microwave signals. A commercial, fibered femtosecond laser is locked to a laser that is stabilized to a commercial ULE Fabry-Perot cavity. The 10 GHz microwave signal extracted from the femtosecond laser output exhibits a single sideband phase noise $\mathcal{L}(f)=-104 \ \mathrm{dBc}/\mathrm{Hz}$ at 1 Hz Fourier frequency, at the level of the best value obtained with such "microwave photonics" laboratory experiments \cite{Fortier2011}. Close-to-the-carrier ultra-low phase noise microwave signals will now be available in laboratories outside the frequency metrology field, opening up new possibilities in various domains.Comment: 8 pages, 3 figures. To be published in Applied Optics, early posting version available at http://www.opticsinfobase.org/ao/upcoming_pdf.cfm?id=23114

ELISA: a cryocooled 10 GHz oscillator with 10-15 frequency stability

This article reports the design, the breadboarding and the validation of an ultra-stable Cryogenic Sapphire Oscillator operated in an autonomous cryocooler. The objective of this project was to demonstrate the feasibility of a frequency stability of 3x10-15 between 1 s and 1,000 s for the European Space Agency deep space stations. This represents the lowest fractional frequency instability ever achieved with cryocoolers. The preliminary results presented in this paper validate the design we adopted for the sapphire resonator, the cold source and the oscillator loop.Comment: 13 pages, 10 figure

Generation of Ultrastable Microwaves via Optical Frequency Division

There has been increased interest in the use and manipulation of optical fields to address challenging problems that have traditionally been approached with microwave electronics. Some examples that benefit from the low transmission loss, agile modulation and large bandwidths accessible with coherent optical systems include signal distribution, arbitrary waveform generation, and novel imaging. We extend these advantages to demonstrate a microwave generator based on a high-Q optical resonator and a frequency comb functioning as an optical-to-microwave divider. This provides a 10 GHz electrical signal with fractional frequency instability <8e-16 at 1 s, a value comparable to that produced by the best microwave oscillators, but without the need for cryogenic temperatures. Such a low-noise source can benefit radar systems, improve the bandwidth and resolution of communications and digital sampling systems, and be valuable for large baseline interferometry, precision spectroscopy and the realization of atomic time

A new dynamic module for in-situ nanomechanical testing at high strain rate

In-situ nanomechanical testing is commonly used to probe surface mechanical properties of bulk materials or thin films, like hardness, Young’s modulus, Yield stress…Actually most of the instruments can measure these properties only statically, i.e. a low frequency, leading to property measurement only at low strain rate (usually 10-1s-1 by nanoindentation). This is mainly caused by the low resonance frequency of the system, preventing making tests at higher speed. Performing high dynamic measurements could bring new information on materials properties like deformation mechanism at high strain rate, or high dynamic fatigue properties. A new high dynamic module usable for in-situ mechanical testing has been developed. It is composed of a small piezotube attached directly behind the tip. Because of the small dimensions of the module, his resonance frequency is very high (higher than 50kHz) in comparison to classical nanomechanical testers, permitting to perform and measure precisely the signals at very high frequency. Moreover, it can be used as a sensor and as an actuator, in x, y and z directions which gives to this module a very large range of measurements. Firstly, the characteristics, the performances and the limits of the new high dynamic module will be presented. Secondly some indentations experiments performed at high strain rate on nanocrystalline nickel with the in-situ nanomechanical tester (Alemnis Gmbh) equipped with the high dynamic will be presented and discussed (Fig. 1). Finally, some micropillar compression at high strain rate on the same material will be described and discussed

Flicker Noise of Microwave Power Detectors

International audienc

Simple architecture low phase noise microwave cryogenic sapphire oscillators

International audienc

10 GHz Cryocooled Sapphire Oscillator with Extremely Low Phase Noise

International audienceThe phase noise characterisation of two 10 GHz cryogenic sapphire oscillators exhibiting frequency stability higher than 3 x 10(-15) is reported. One of these oscillators developed for the deep space navigation ground stations of the European Space Agency, incorporates a closed cycle cryocooler as cold source. Near the carrier, the measured phase noise is limited by a flicker frequency noise: S(phi)(f) = -30log(f) - 98 dBrad(2)/Hz