39,213 research outputs found
Characteristics of the Termination Shock: Insights from Voyager
We examine the energy spectra obtained from the cosmic ray instrument on the Voyager 1 spacecraft during 2002/215 through 2005/60. We find that the energy spectra of protons below ~20 MeV often resemble two power laws with a relatively hard index at low energies and a softer index at higher energies. The point of intersection of the two power laws is ~3 MeV. Beginning in 2005, the low-energy index is typically –1.5, corresponding to a shock strength (compression ratio) of 2.5. We attribute these characteristics to a restricted region of the solar wind termination shock that is sporadically connected to the Voyager 1 spacecraft by the interplanetary magnetic field. The absence of significant spectral variability in 2005 suggests that Voyager 1 entered a region with minimal spatial gradients of the lowest energy ions
Liquid acrobatics
We experiment with injecting a continuous stream of gas into a shallow
liquid, similar to how one might blow into a straw placed at the bottom of a
near-empty drink. By varying the angle of the straw (here a metal needle), we
observe a variety of dynamics, which we film using a high-speed camera. Most
noteworthy is an intermediate regime in which cyclical jets erupt from the
air-liquid interface and breakup into air-born droplets. These droplets trace
out a parabolic trajectory and bounce on the air-liquid interface before
eventually coalescing. The shape of each jet, as well as the time between jets,
is remarkably similar and leads to droplets with nearly identical trajectories.
The following article accompanies the linked fluid dynamics video submitted to
the Gallery of Fluid Motion in 2008.Comment: Accompanies video submission to APS DFD 2008 Gallery of Fluid Motion,
low
http://ecommons.library.cornell.edu/bitstream/1813/11469/3/Bird_DFD2008_mpeg1.mpg
, and high resolution
http://ecommons.library.cornell.edu/bitstream/1813/11469/2/Bird_DFD2008_mpeg2.mp
The anomalous cosmic-ray component
This brief report is intended to update the anomalous component section of the summary report of the galactic cosmic-ray working group (Mewaldt et al., 1987), which was drafted at the March 1987 Workshop on the Interplanetary Charged Particle Environment at the Jet Propulsion Laboratory. The description of the spectrum of the anomalous cosmic-ray component is contained in section 3.3 of that report. That description is based on data analyzed through day 310 of 1986, and in it we proposed that the energy spectrum of the various species of the anomalous component could be derived by scaling from two generic spectra. Two generic spectra were required because the energy spectrum of the anomalous component changed shape near the time of the solar magnetic field reversal in 1980. These two generic spectra are shown in Figure 2 of the summary report
Shear dispersion in dense granular flows
We formulate and solve a model problem of dispersion of dense granular
materials in rapid shear flow down an incline. The effective dispersivity of
the depth-averaged concentration of the dispersing powder is shown to vary as
the P\'eclet number squared, as in classical Taylor--Aris dispersion of
molecular solutes. An extensions to generic shear profiles is presented, and
possible applications to industrial and geological granular flows are noted.Comment: 6 pages, 2 figures, Springer svjour3 format; to appear in Granular
Matte
Asteroid selection for mission opportunities
A study to assess the present state of knowledge of asteroids as well as the rate of change of that knowledge to better identify the mission and target priorities for advanced planning of asteroidal flights in the 1980's is presented. Topics discussed include; the present state of asteroid knowledge, the scientific goals and priorities attached to asteroid exploration, the anticipated advances in knowledge over the current decade, asteroid mission consideration, and asteroid selection. Data sheets for 118 asteroids are contained. These are asteroids for which some data is available over and above orbital parameters and magnitude
Research relative to the heavy isotope spectrometer telescope experiment
The Heavy Isotope Spectrometer Telescope (HIST) was launched during August 1978 on ISEE-3 (ICE). HIST was designed to measure the isotopic composition of solar, galactic, and interplanetary cosmic ray nuclei for the elements from H to Ni (1 less than or equal to Z less than or equal to 28) in the energy range from approximately 5 to approximately 200 MeV/nucleon. The results of these measurements have been used in studies of the composition of solar matter and galactic cosmic ray sources, the study of nucleosynthesis processes, studies of particle acceleration and propagation, and studies of the life-history of cosmic rays in the heliosphere and in the galaxy. On December 1, 1978, after 110 days in orbit, HIST suffered an electronic failure in its readout system. After that point, only one-half of the telemetry bits associated with the pulse heights measured by HIST were transmitted to Earth. As a result, the resolution of HIST was significantly degraded, and it served as an element rather than an isotope spectrometer. Fortunately, HIST was able to measure the isotopic composition of heavy nuclei in the 9/23/78 solar event (the largest solar energetic particle event since 1972) during the brief period that it operated at full resolution. This grant funded the analysis of data from the HIST instrument over the period from 12/1/85 to 11/30/92. In section 2 of this final report, we summarize the scientific accomplishments that have resulted from HIST measurements during this time period. A bibliography of tasks and papers that resulted is attached
Solar cycle variations of the anomalous cosmic ray component
The intensity of the anomalous cosmic ray component, consisting of He, N, O, and Ne, has long been known to be especially sensitive to the effects of solar modulation. Following its discovery in 1972, this component dominated the quiet time flux of cosmic ray nuclei below approx. 30 MeV/nucleon during the 1972 to 1978 solar minimum, but then became essentially unobservable at 1 AU with the approach of solar maximum conditions. One recent theoretical model predicts substantial differences in the intensity of the anomalous fluxes from one solar minimum period to the next because of the reversal of the solar magnetic field. Using data from the Caltech experiments on IMP-8 and ICE (ISEE-3), the intensity of anomalous O and He at 1 AU during the years 1972 to 1985 is reported in particular. Whether the anomalous fluxes will return to their 1972-1978 levels, as predicted by spherically symmetric modulation models, or whether they will fail to return to 1 AU, as suggested by modulation models in which gradient and curvature drifts dominate are to be determined. The preliminary analysis of data from 1984 shows that the intensity of 8 to 27 MeV/nucleon O is still more than an order of magnitude below its 1972 to 1978 levels, while the intensity of 25 to 43 MeV/nucleon He is a factor of Approx. 8 below its maximum level in 1977
Reduction and analysis of data from experiment CAI on the IMP-8 mission
The Caltech Electron/Isotope Spectrometer (EIS) on the Interplanetary Monitoring Platform 8 (IMP-8) has provided precise measurements of the energy spectra and time variations of low energy electrons (0.16 to 6 MeV), the isotopes of hydrogen and helium (approximately 2 to 40 MeV/nucleon), and the elements from lithium through oxygen (approximately 5 to 50 MeV/nucleon) in energetic particle fluxes of solar, galactic, interplanetary, and magnetospheric origin since 1973. The accomplishments that have resulted from EIS measurements during the period March 24, 1980 to December 31, 1984 are summarized
Battery health determination by subspace parameter estimation and sliding mode control for an all-electric Personal Rapid Transit vehicle — the ULTra
The paper describes a real-time adaptive battery modelling methodology for use in an all electric personal rapid transit (PRT) vehicle. Through use of a sliding-mode observer and online subspace parameter estimation, the voltages associated with monitoring the state of charge (SoC) of the battery system are shown to be accurately estimated, even with erroneous initial conditions in both the model and parameters. In this way, problems such as self- discharge during storage of the cells and SoC drift (as usually incurred by coulomb-counting methods due to overcharging or ambient temperature fluctuations) are overcome. Moreover, through online monitoring of the degradation of the estimated parameters, battery ageing (State of Health) can be monitored and, in the case of safety- critical systems, cell failure may be predicted in time to avoid inconvenience to passenger networks. Due to the adaptive nature of the proposed methodology, this system can be implemented over a wide range of operating environments, applications and battery topologies, by adjustment of the underlying state-space model
State-variable modelling of CLL resonant converters
The paper presents the derivation and application of state-variable models to high-order topologies of resonant converters. In particular, a 3rd order CLL resonant circuit is considered with bridge rectification and both a capacitive output filter (voltage output), and an LC output filter (current output). The state-variable model accuracy is verified against component-based simulation packages (Spice) and practical measurements, and it is shown that the resulting models facilitate rapid analysis compared to their integration-based counterparts (Spice, Saber), without the loss of accuracy normally associated with fundamental mode approximation (FMA) techniques. Moreover, unlike FMA, the models correctly predict the resonant peaks associated with harmonic excitation of the tank resonance. Subsequently, it is shown that excitation of the resonant tank by odd harmonics of the input voltage can be utilised to provide overcurrent protection in the event of an output short-circuit. Further, through judicious control of operating frequency, it is shown that 'inductive' zero voltage switching (ZVS) can still be obtained, facilitating reductions in gate-drive switching losses, thereby improving efficiency and thermal management of the supply under fault conditions. Although the results are ultimately generic to other converter counterparts, measured results from two prototype 36 V input, 11-14.4V output, 3rd - order CLL converters are included to practically demonstrate the attributes of the proposed analysis and control schemes
- …