Nanocrystallization in Co67Cr7Fe4Si8B14 Amorphous Alloy Ribbons

The nanocrystallization of Co67Fe4Cr7Si8B14 amorphous ribbons which prepared by planar flow melt spinning process (PFMS) was investigated. Crystallization of the ribbons was studied by differential thermal analysis (DTA), X-ray diffraction (XRD) and transmission electron microscopy (TEM). The DTA result of amorphous ribbon at heating rate of 10˚C/min showedoccurrence of phase transitions in two stages. The ribbons were isothermally annealed for 30 minutes in argon atmosphere at different temperatures between 300 and 650ºC with 25ºC steps. The magnetic properties of annealed samples were measured using a vibrating sample magnetometer (VSM). The VSM results revealed that optimum soft magnetic properties occurred at 400ºC. XRD patterns showed that the samples isothermally annealed up to 450ºC were amorphous, while TEM results at 400ºC indicated 7-8 nm mean size nanocrytallites in amorphous matrix and size of the nanocrystallites increased by increasing temperature. Also by X-ray diffraction pattern, precipitation of different phases at higher temperatures confirmed

Effect of cryogenic cycling on mechanical properties of ZrTiCuNiBe bulk metallic glass

The effect of deep cryogenic cycle treatment (DCT) on Zr41.2Ti13.8Cu12.5Ni10Be22.5 (Vit-1) bulk metallic glass (BMG) prepared from high-purity raw materials was investigated. After DCT, no obvious rejuvenation of the samples was detected. With an increasing number of cryogenic cycles, the hardness of the samples first decreased and then increased, the room-temperature compression plasticity first increased and then generally remained unchanged, and the impact toughness underwent almost no obvious change. The absence of rejuvenation was attributed to the high fragility index (47–50) and high glass forming ability (GFA) of the material. As lower purity of the raw materials is expected in practical applications, DCT of Vit-1 BMG prepared from low-purity raw materials was also performed. After DCT, the samples prepared with the lower-purity raw materials were clearly rejuvenated, and the room-temperature mechanical properties improved significantly.Both the compression plasticity and impact toughness reached peak values after 5 cryogenic cycles. The initial impurities (including Y and O) had a complex and comprehensive effect on the deformation mechanism of the BMG during DCT. Our findings indicate that the structural heterogeneity, fragility index, and GFA of the BMG alter the effect of DCT