4,888 research outputs found
Confirming the Detection of an Intergalactic X-ray Absorber Toward PKS 2155-304
We present new observations on PKS 2155-304 with the Chandra Low Energy
Transmission Grating Spectrometer (LETG), using the Advanced CCD Imaging
Spectrometer (ACIS). We confirm the detection of an absorption line plausibly
identified as OVIII Ly-alpha from the warm-hot intergalactic medium associated
with a small group of galaxies along the line of sight, as originally reported
by Fang et al. 2002 (here after FANG02). Combining the previous observations in
FANG02 and five new, long observations on the same target, we increase the
total exposure time by a factor of three, and the total counts per resolution
element by a factor of five. The measured line equivalent width is smaller than
that observed in FANG02, but still consistent at 90% confidence. We also
analyze the XMM-Newton observations on the same target, as well as observations
using the Chandra LETG and the High Resolution Camera (HRC) combination. These
observations have been used to challenge our reported detection. While no line
is seen in either the XMM-Newton and the Chandra LETG+HRC data, we find that
our result is consistent with the upper limits from both data sets. We
attribute the non-detection to (1) higher quality of the Chandra LETG+ACIS
spectrum, and (2) the rather extended wings of the line spread functions of
both the XMM RGS and the Chandra LETG+HRC. We discuss the implication of our
observation on the temperature and density of the absorber. We also confirm the
detection of z ~ 0 OVII absorption and, comparing with previous Chandra
analysis, we obtain much tighter constraints on the line properties.Comment: 10 pages, 8 figures, accepted for publication in Ap
Recommended from our members
Surface Morphology of Selective Laser-Melted Titanium
The surface morphology of biomaterials is one of the most important biocompatibility
factors. In this paper, the change in surface morphology of selective laser-melted titanium with
process parameters was investigated to control the pore structure and mesh size. First, the process
map which shows the relation between the morphology of laser-melted track and the process
parameters such as laser power and scan speed was drawn by experiments. The laser-melted layer
was fabricated on the basis of the process map. As a result, the surface morphology, especially
pore structure and mesh size, of the layer is affected strongly by energy density as well as scan
spacing.Mechanical Engineerin
Properties of the cosmological filament between two clusters: A possible detection of a large-scale accretion shock by
We report on the results of a observation of the plasma in the
filament located between the two massive clusters of galaxies Abell 399 and
Abell 401. Abell 399 (=0.0724) and Abell 401 (=0.0737) are expected to be
in the initial phase of a cluster merger. In the region between the two
clusters, we find a clear enhancement in the temperature of the filament plasma
from 4 keV (expected value from a typical cluster temperature profile) to
6.5 keV. Our analysis also shows that filament plasma is present out to
a radial distance of 15' (1.3 Mpc) from a line connecting the two clusters. The
temperature profile is characterized by an almost flat radial shape with
6-7 keV within 10' or 0.8 Mpc. Across =8'~from the axis, the
temperature of the filament plasma shows a drop from 6.3 keV to 5.1 keV,
indicating the presence of a shock front. The Mach number based on the
temperature drop is estimated to be 1.3. We also successfully
determined the abundance profile up to 15' (1.3 Mpc), showing an almost
constant value (=0.3 solar) at the cluster outskirt. We estimated the
Compton -parameter to be 14.5, which is in
agreement with 's results (14-17 on the filament). The
line of sight depth of the filament is 1.1 Mpc, indicating that the
geometry of filament is likely a pancake shape rather than cylindrical. The
total mass of the filamentary structure is 7.7. We discuss a possible interpretation of the drop of X-ray emission
at the rim of the filament, which was pushed out by the merging activity and
formed by the accretion flow induced by the gravitational force of the
filament.Comment: 8 pages, 8 figures, accepted for publication in A&
Large electroweak penguin contribution in B -> K pi and pi pi decay modes
We discuss about a possibility of large electroweak penguin contribution in B
-> K pi and pi pi from recent experimental data. The experimental data may be
suggesting that there are some discrepancies between the data and theoretical
estimation in the branching ratios of them. In B -> K pi decays, to explain it,
a large electroweak penguin contribution and large strong phase differences
seem to be needed. The contributions should appear also in B -> pi pi. We show,
as an example, a solution to solve the discrepancies in both B -> K pi and B ->
pi pi. However the magnitude of the parameters and the strong phase estimated
from experimental data are quite large compared with the theoretical
estimations. It may be suggesting some new physics effects are including in
these processes. We will have to discuss about the dependence of the new
physics. To explain both modes at once, we may need large electroweak penguin
contribution with new weak phases and some SU(3) breaking effects by new
physics in both QCD and electroweak penguin type processes.Comment: 23 pages, 9 figure
Ionization Source of a Minor-axis Cloud in the Outer Halo of M82
The M82 `cap' is a gas cloud at a projected radius of 11.6 kpc along the
minor axis of this well known superwind source. The cap has been detected in
optical line emission and X-ray emission and therefore provides an important
probe of the wind energetics. In order to investigate the ionization source of
the cap, we observed it with the Kyoto3DII Fabry-Perot instrument mounted on
the Subaru Telescope. Deep continuum, Ha, [NII]6583/Ha, and [SII]6716,6731/Ha
maps were obtained with sub-arcsecond resolution. The superior spatial
resolution compared to earlier studies reveals a number of bright Ha emitting
clouds within the cap. The emission line widths (< 100 km s^-1 FWHM) and line
ratios in the newly identified knots are most reasonably explained by slow to
moderate shocks velocities (v_shock = 40--80 km s^-1) driven by a fast wind
into dense clouds. The momentum input from the M82 nuclear starburst region is
enough to produce the observed shock. Consequently, earlier claims of
photoionization by the central starburst are ruled out because they cannot
explain the observed fluxes of the densest knots unless the UV escape fraction
is very high (f_esc > 60%), i.e., an order of magnitude higher than observed in
dwarf galaxies to date. Using these results, we discuss the evolutionary
history of the M82 superwind. Future UV/X-ray surveys are expected to confirm
that the temperature of the gas is consistent with our moderate shock model.Comment: 7 pages, 5 figures, 2 tables; Accepted for publication in Ap
Sulfur-Mediated Palladium Catalyst Immobilized on a GaAs Surface
We present a hard x-ray photoelectron spectroscopy study on the preparation process of palladium catalyst immobilized on an S-terminated GaAs(100) surface. It is revealed that Pd(II) species are reduced on the GaAssurface and yield Pd nanoparticles during the process of Pd immobilization and the subsequent heat treatment. A comparison with the results on GaAs without S-termination suggests that the reduction of Pd is promoted by hydroxy groups during the Pd immobilization and by S during the heat treatment
DIOS: the Diffuse Intergalactic Oxygen Surveyor
We present our proposal for a small X-ray mission DIOS (Diffuse Intergalactic
Oxygen Surveyor), consisting of a 4-stage X-ray telescope and an array of TES
microcalorimeters, cooled with mechanical coolers, with a total weight of about
400 kg. The mission will perform survey observations of warm-hot intergalactic
medium using OVII and OVIII emission lines, with the energy coverage up to 1.5
keV. The wide field of view of about 50' diameter, superior energy resolution
close to 2 eV FWHM, and very low background will together enable us a wide
range of science for diffuse X-ray sources. We briefly describe the design of
the satellite, performance of the subsystems and the expected results.Comment: 9 pages, 11 figures, a proceedings of SPIE "Astronomical Telescopes
and Instrumentation" 200
- …