Slow and Fast Transitions in the Rising Phase of Outbursts from NS-LMXB transients, AqlX-1 and 4U1608-52

We analyzed the initial rising behaviors of X-ray outbursts from two transient low-mass X-ray binaries (LMXBs) containing a neutron-star (NS), Aql X-1 and 4U 1608-52, which are continuously being monitored by MAXI/GSC in 2--20 keV, RXTE/ASM in 2--10 keV, and Swift/BAT in 15--50 keV. We found that the observed ten outbursts are classified into two types by the patterns of the relative intensity evolutions in the two energy bands below/above 15 keV. One type behaves as the 15--50 keV intensity achieves the maximum during the initial hard-state period and drops greatly at the hard-to-soft state transition. On the other hand, the other type does as both the 2--15 keV and the 15--50 keV intensities achieve the maximums after the transition. The former have the longer initial hard-state ($\gtrsim$ 9 d) than the latter's (\ltsim5 d). Therefore, we named them as slow-type (S-type) and fast-type (F-type), respectively. These two types also show the differences in the luminosity at the hard-to-soft state transition as well as in the average luminosity before the outburst started, where the S-type are higher than the F-type in the both. These results suggest that the X-ray radiation during the pre-outburst period, which heats up the accretion disk and delays the disk transition (i.e., from a geometrically thick disk to a thin one), would determine whether the following outburst becomes S-type or F-type. The luminosity when the hard-to-soft state transition occurs is higher than $\sim 8 \times10^{36}$ erg s$^{-1}$ in the S-type, which corresponds to 4% of the Eddington luminosity for a 1.4 \Mo NS.Comment: 14 pages, 10 figures; Publications of the Astronomical Society of Japan, 201

Conformational Study of Polypeptide Chains Grafted on the Surface of Polylactide Latex Particle

Polylactide (PLA) latex particle covered with polypeptide chains were prepared by means of solvent exchange method from PLA and PLA-block-polypeptide block copolymer solutions. PLA segment of the block copolymer and PLA homopolymer formed a core of the particle, and the polypeptide segment of the block copolymer, which is designed as tightly fixed biodegradable emulsifier, formed corona around the particle surface. This picture was supported by the fact that zeta-potential of PLA latex particle covered with polypeptide segment was different from that of bare PLA particle because of the presence of the ionizable group in the polypeptide chains. To clarify the effect of the ionizable group on conformation of the polypeptide chain, the relation between the polypeptide chain length and the area occupied by the single block chain was evaluated. The result that the occupied area per a polypeptide chain was linearly increased with the increase in the polypeptide chain length indicates that the polypeptide chains trail on the particle surface and did not take helical structures

Combined Spectral and Timing Analysis of the Black Hole Candidate MAXI J1659-152 Discovered by MAXI and Swift

We report on X-ray spectral and timing results of the new black hole candidate (BHC) MAXI J1659-152 with the orbital period of 2.41 hours (shortest among BHCs) in the 2010 outburst from 65 Rossi X-ray Timing Explorer (RXTE) observations and 8 simultaneous Swift and RXTE observations. According to the definitions of the spectral states in Remillard & McClintock (2006), most of the observations have been classified into the intermediate state. All the X-ray broadband spectra can be modeled by a multi-color disk plus a power-law with an exponential cutoff or a multi-color disk plus a Comptonization component. During the initial phase of the outburst, a high energy cutoff was visible at 30-40 keV. The innermost radius of the disk gradually decreased by a factor of more than 3 from the onset of the outburst and reached a constant value of 35 d_10 cos i^-1/2 km, where d_10 is the distance in units of 10 kpc and $i$ is the inclination. The type-C quasi-periodic oscillation (QPO) frequency varied from 1.6 Hz to 7.3 Hz in association with a change of the innermost radius, while the innermost radius remained constant during the type-B QPO detections at 1.6-4.1 Hz. Hence, we suggest that the origin of the type-B QPOs is different from that of type-C QPOs, the latter of which would originate from the disk truncation radius. Assuming the constant innermost radius in the latter phase of the outburst as the innermost stable circular orbit, the black hole mass in MAXI J1659-152 is estimated to be 3.6-8.0 M_solar for a distance of 5.3-8.6 kpc and an inclination angle of 60-75 degrees.Comment: 27 pages, 14 figures, accepted for publication in PAS

Spectral Evolutions in Gamma-Ray Burst Exponential Decays Observed with Suzaku WAM

This paper presents a study on the spectral evolution of gamma-ray burst (GRB) prompt emissions observed with the Suzaku Wide-band All-sky Monitor (WAM). By making use of the WAM data archive, 6 bright GRBs exhibiting 7 well-separated fast-rise-exponential-decay (FRED) shaped light curves are presented and the evaluated exponential decay time constants of the energy-resolved light curves from these FRED peak light curves are shown to indicate significant spectral evolution. The energy dependence of the time constants is well described with a power-law function tau(E) ~ E^gamma, where gamma ~ -(0.34 +/- 0.12) in average, although 5 FRED peaks show consistent value of gamma = -1/2 which is expected in synchrotron or inverse-Compton cooling models. In particular, 2 of the GRBs were located with accuracy sufficient to evaluate the time-resolved spectra with precise energy response matrices. Their behavior in spectral evolution suggests two different origins of emissions. In the case of GRB081224, the derived 1-s time-resolved spectra are well described by a blackbody radiation model with a power-law component. The derived behavior of cooling is consistent with that expected from radiative cooling or expansion of the emission region. On the other hand, the other 1-s time-resolved spectra from GRB100707A is well described by a Band GRB model as well as with the thermal model. Although relative poor statistics prevent us to conclude, the energy dependence in decaying light curve is consistent with that expected in the former emission mechanism model.Comment: 11 pages, 7 figures, 5 tables. PASJ accepte