Experimental study on critical heat flux under rolling condition

Paper presented at the 9th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics, Malta, 16-18 July, 2012.This paper presents defining characteristics of the critical heat flux (CHF) for the boiling of R-134a in vertical tube operation under rolling motion in marine reactor. It is important to predict CHF of marine reactor having the rolling motion in order to increase the safety of the reactor. MArine Reactor Moving Simulator (MARMS) tests are conducted to measure the critical heat flux using R-134a flowing upward in a uniformly heated vertical tube under rolling motion. MARMS was rotated by motor and mechanical power transmission gear. The CHF tests were performed in a 9.5 mm I.D. test section with heated length of 1m. Mass fluxs range from 285 to 1300 kg/m2s, inlet subcoolings from 3 to 38oC and outlet pressures from 1.3 to 2.4 bar. Amplitudes of rolling range from 15 to 45 degrees and periods from 6 to 12 sec. To convert the test conditions of CHF test using R-134a in water, Katto's fluid-to- fluid modeling was used in present investigation. A CHF correlation is presented which accounts for the effects of pressure, mass flux, inlet subcooling and rolling angle over all conditions tested. Unlike existing transient CHF experiments, CHF ratio of certain mass flux and pressure are different in rolling motion. For the mass fluxes below 500 kg/m2s at 13, 16 (region of relative low mass flux), CHF ratio was decreased but was increased above that mass flux (region of relative high mass flux) bar. Moreover, CHF tend to enhance in entire mass flux at 24 bar.dc201

Role of remote interfacial phonons in the resistivity of graphene

The temperature ($\it T$) dependence of electrical resistivity in graphene has been experimentally investigated between 10 and 400 K for samples prepared on various substrates; HfO$_2$, SiO$_2$ and h-BN. The resistivity of graphene shows a linear $\it T$-dependence at low $\it T$ and becomes superlinear above a substrate-dependent transition temperature. The results are explained by remote interfacial phonon scattering by surface optical phonons at the substrates. The use of an appropriate substrate can lead to a significant improvement in the charge transport of graphene

EUS-Guided Biliary Drainage

The echoendoscopic biliary drainage is an option to treat obstructive jaundices when ERCP drainage fails. These procedures compose alternative methods to the side of surgery and percutaneous transhepatic biliary drainage, and it was only possible by the continuous development and improvement of echoendoscopes and accessories. The development of linear setorial array echoendoscopes in early 1990 brought a new approach to diagnostic and therapeutic dimenion on echoendoscopy capabilities, opening the possibility to perform punction over direct ultrasonographic view. Despite of the high success rate and low morbidity of biliary drainage obtained by ERCP, difficulty could be found at the presence of stent tumor ingrown, tumor gut compression, periampulary diverticula, and anatomic variation. The echoendoscopic technique starts performing punction and contrast of the left biliary tree. When performed from gastric wall, the access is made through hepatic segment III. From duodenum, direct common bile duct punction. Dilatation is required before stent introduction, and a plastic or metallic stent is introduced. This phrase should be replaced by: diathermic dilatation of the puncturing tract is required using a 6F cystostome. The technical success of hepaticogastrostomy is near 98%, and complications are present in 36%: pneumoperitoneum, choleperitoneum, infection, and stent disfunction. To prevent bile leakage, we have used the 2 stent techniques, the first stent introduced was a long uncovered metallic stent (8 or 10 cm), and inside this first stent a second fully covered stent of 6 cm was delivered to bridge the bile duct and the stomach. Choledochoduodenostomy overall success rate is 92% and described complications include, in frequency order, pneumoperitoneum and focal bile peritonitis, present in 19%. By the last 10 years, the technique was especially performed in reference centers, by ERCP experienced groups, and this seems to be a general guideline to safer procedure execution

Automatic Verification of Erlang-Style Concurrency

This paper presents an approach to verify safety properties of Erlang-style, higher-order concurrent programs automatically. Inspired by Core Erlang, we introduce Lambda-Actor, a prototypical functional language with pattern-matching algebraic data types, augmented with process creation and asynchronous message-passing primitives. We formalise an abstract model of Lambda-Actor programs called Actor Communicating System (ACS) which has a natural interpretation as a vector addition system, for which some verification problems are decidable. We give a parametric abstract interpretation framework for Lambda-Actor and use it to build a polytime computable, flow-based, abstract semantics of Lambda-Actor programs, which we then use to bootstrap the ACS construction, thus deriving a more accurate abstract model of the input program. We have constructed Soter, a tool implementation of the verification method, thereby obtaining the first fully-automatic, infinite-state model checker for a core fragment of Erlang. We find that in practice our abstraction technique is accurate enough to verify an interesting range of safety properties. Though the ACS coverability problem is Expspace-complete, Soter can analyse these verification problems surprisingly efficiently.Comment: 12 pages plus appendix, 4 figures, 1 table. The tool is available at http://mjolnir.cs.ox.ac.uk/soter

The nonlinear analysis of an innovative slit reinforced concrete water tower in seismic regions

Water towers are widely used in our society as one of water distribution facilities within water network systems. In the event of a severe earthquake, however, a single plastic hinge that occurs in a water tower could cause its total collapse before nonlinear resources of the rest of the tower remains fully utilised. This research presents an innovative technique for the assembly of a water tower using the slits in its reinforced concrete shaft for the purpose of mitigating the seismic response. Slit shafts were designed to have four slits at 90 degree intervals along the full height of the shafts. The shaft parts were connected to each other at the bottom, top and every five meters with coupling beams. The slit width was used as a variable in this study which varied between 50 mm and 2000 mm. The nonlinear seismic performance of the proposed slit towers was analysed by means of a finite element approach with respect to soil types defined in Eurocode 8 and seismic behaviour were compared to the solid water tower. A detailed observation of the compression and tension stress distributions with respect to the slit width was performed. The obtained analytical results revealed that slit width in the reinforced concrete tower affect the failure mode and stiffness of a water tower significantly. With an appropriate design, the conversion of a solid water tower into a slit tower can significantly increase its ductility under seismic action without significantly compromising its bearing capacity. The results showed that contours of tension and compression stress intensity in shafts, which could lead to a failure of water towers, highly depended on the slit width. In the solid water tower, the stress concentration dominated at the base of the shaft, however in the narrow slit water towers the stresses were equally distributed along the height of the shafts. Also, the stresses were mostly concentrated at the top of the shafts in the wide slit water towers. Conclusively, the results provided useful information regarding the compression stress distribution along the slit shafts in the water towers which can be used in obtaining an optimum slit shaft design for different soil types

Fully supersymmetric CP violations in the kaon system

We show that, on the contrary to the usual claims, fully supersymmetric CP violations in the kaon system are possible through the gluino mediated flavor changing interactions. Both $\epsilon_K$ and ${\rm Re} (\epsilon' / \epsilon_K)$ can be accommodated for relatively large $\tan\beta$ without any fine tunings or contradictions to the FCNC and EDM constraints.Comment: Contribution to the Proceedings of ICHEP2000, Osaka, 200

On the gauge and BRST invariance of the chiral QED with Faddeevian anomaly

Chiral Schwinger model with the Faddeevian anomaly is considered. It is found that imposing a chiral constraint this model can be expressed in terms of chiral boson. The model when expressed in terms of chiral boson remains anomalous and the Gauss law of which gives anomalous Poisson brackets between itself. In spite of that a systematic BRST quantization is possible. The Wess-Zumino term corresponding to this theory appears automatically during the process of quantization. A gauge invariant reformulation of this model is also constructed. Unlike the former one gauge invariance is done here without any extension of phase space. This gauge invariant version maps onto the vector Schwinger model.The gauge invariant version of the chiral Schwinger model for $a=2$ has a massive field with identical mass however gauge invariant version obtained here does not map on to that.Comment: 11 pages latex, no figures, A little change in Title and abstrac

Ab initio study of ferroelectric domain walls in PbTiO3

We have investigated the atomistic structure of the 180-degree and 90-degree domain boundaries in the ferroelectric perovskite compound PbTiO3 using a first-principles ultrasoft-pseudopotential approach. For each case we have computed the position, thickness and creation energy of the domain walls, and an estimate of the barrier height for their motion has been obtained. We find both kinds of domain walls to be very narrow with a similar width of the order of one to two lattice constants. The energy of the 90-dergree domain wall is calculated to be 35 mJ/m^2, about a factor of four lower than the energy of its 180-degree counterpart, and only a miniscule barrier for its motion is found. As a surprising feature we detected a small offset of 0.15-0.2 eV in the electrostatic potential across the 90-degree domain wall.Comment: 12 pages, with 9 postscript figures embedded. Uses REVTEX and epsf macros. Also available at http://www.physics.rutgers.edu/~dhv/preprints/bm_dw/index.htm

Reaction Diffusion Models in One Dimension with Disorder

We study a large class of 1D reaction diffusion models with quenched disorder using a real space renormalization group method (RSRG) which yields exact results at large time. Particles (e.g. of several species) undergo diffusion with random local bias (Sinai model) and react upon meeting. We obtain the large time decay of the density of each specie, their associated universal amplitudes, and the spatial distribution of particles. We also derive the spectrum of exponents which characterize the convergence towards the asymptotic states. For reactions with several asymptotic states, we analyze the dynamical phase diagram and obtain the critical exponents at the transitions. We also study persistence properties for single particles and for patterns. We compute the decay exponents for the probability of no crossing of a given point by, respectively, the single particle trajectories ($\theta$) or the thermally averaged packets ($\bar{\theta}$). The generalized persistence exponents associated to n crossings are also obtained. Specifying to the process $A+A \to \emptyset$ or A with probabilities $(r,1-r)$, we compute exactly the exponents $\delta(r)$ and $\psi(r)$ characterizing the survival up to time t of a domain without any merging or with mergings respectively, and $\delta_A(r)$ and $\psi_A(r)$ characterizing the survival up to time t of a particle A without any coalescence or with coalescences respectively. $\bar{\theta}, \psi, \delta$ obey hypergeometric equations and are numerically surprisingly close to pure system exponents (though associated to a completely different diffusion length). Additional disorder in the reaction rates, as well as some open questions, are also discussed.Comment: 54 pages, Late

Generation of disease-specific induced pluripotent stem cells from patients with rheumatoid arthritis and osteoarthritis

INTRODUCTION: Since the concept of reprogramming mature somatic cells to generate induced pluripotent stem cells (iPSCs) was demonstrated in 2006, iPSCs have become a potential substitute for embryonic stem cells (ESCs) given their pluripotency and "stemness" characteristics, which resemble those of ESCs. We investigated to reprogram fibroblast-like synoviocytes (FLSs) from patients with rheumatoid arthritis (RA) and osteoarthritis (OA) to generate iPSCs using a 4-in-1 lentiviral vector system. METHODS: A 4-in-1 lentiviral vector containing Oct4, Sox2, Klf4, and c-Myc was transduced into RA and OA FLSs isolated from the synovia of two RA patients and two OA patients. Immunohistochemical staining and real-time PCR studies were performed to demonstrate the pluripotency of iPSCs. Chromosomal abnormalities were determined based on the karyotype. SCID-beige mice were injected with iPSCs and sacrificed to test for teratoma formation. RESULTS: After 14 days of transduction using the 4-in-1 lentiviral vector, RA FLSs and OA FLSs were transformed into spherical shapes that resembled embryonic stem cell colonies. Colonies were picked and cultivated on matrigel plates to produce iPSC lines. Real-time PCR of RA and OA iPSCs detected positive markers of pluripotency. Immunohistochemical staining tests with Nanog, Oct4, Sox2, Tra-1-80, Tra-1-60, and SSEA-4 were also positive. Teratomas that comprised three compartments of ectoderm, mesoderm, and endoderm were formed at the injection sites of iPSCs. Established iPSCs were shown to be compatible by karyotyping. Finally, we confirmed that the patient-derived iPSCs were able to differentiate into osteoblast, which was shown by an osteoimage mineralization assay. CONCLUSION: FLSs derived from RA and OA could be cell resources for iPSC reprogramming. Disease- and patient-specific iPSCs have the potential to be applied in clinical settings as source materials for molecular diagnosis and regenerative therapy