2,805 research outputs found
Lepton flavor violating Higgs boson decays in seesaw models: new discussions
The lepton flavor violating decay of the Standard Model-like Higgs boson
(LFVHD), h->\mu\tau, is discussed in seesaw models at the one-loop level. Based
on particular analytic expressions of Passarino-Veltman functions, the two
unitary and 't Hooft Feynman gauges are used to compute the branching ratio of
LFVHD and compare with results reported recently. In the minimal seesaw (MSS)
model, the branching ratio was investigated in the whole valid range
10^{-9}-10^{15} GeV of new neutrino mass scale m_{n_6}. Using the Casas-Ibarra
parameterization, this branching ratio enhances with large and increasing
m_{n_6}. But the maximal value can reach only order of 10^{-11}. Interesting
relations of LFVHD predicted by the MSS and inverse seesaw (ISS) model are
discussed. The ratio between two LFVHD branching ratios predicted by the ISS
and MSS is simply m^2_{n_6}\mu^{-2}_X, where \mu_X is the small neutrino mass
scale in the ISS. The consistence between different calculations is shown
precisely from analytical approach.Comment: 4 figures, 26 pages, some analytic formulas and statements are
corrected. Main results are unchanged. New references added. Version
published in NP
TECHNICAL NOTE ON THE INTRODUCTION OF PARTRIDGE COLOURED HUNGARIAN CHICKEN IN THE MEKONG DELTA OF VIETNAM
The paper aims to provide a brief agricultural profile of Tra Vinh province, informative adaptation results of Partridge coloured Hungarian chicken (PH) in Mekong Delta and describe the procedure to introduce PH into Tra Vinh province. During the introducing process, flexibility, consideration of the local condition (temperature, humidity, daily sunlight…), and availability of local resources such as bamboo blind, rice husk is essential for introducing a new chicken breed into Mekong Delta. For this, practical examples are given in the study. Regarding adaptation results, relatively high survival rate (89.6%) of PH was recorded at the end of 8th week. Although the recorded data of PH in Tra Vinh is limited, their performance is expected to be equally good or even better in comparison with that obtained in the sub-tropical climatic zone (North Vietnam). Further studies of PH adaptability in Mekong Delta for sustainable, traditional production and crossing purposes, as well as the involvement of chicken caravans to free range farming are recommended
Designing a novel heterostructure AgInS<sub>2</sub>@MIL-101(Cr) photocatalyst from PET plastic waste for tetracycline degradation
Semiconductor-containing porous materials with a well-defined structure could be unique scaffolds for carrying out selective organic transformations driven by visible light. We herein introduce for the first time a heterostructure of silver indium sulfide (AgInS(2)) ternary chalcogenide and a highly porous MIL-101(Cr) metal–organic framework (MOF) synthesised from polyethylene terephthalate plastic waste. Our results demonstrate that AgInS(2) nanoparticles were uniformly attached to each lattice plane of the octahedral MIL-101(Cr) structure, resulting in a nanocomposite with a high distribution of semiconductors in a porous media. We also demonstrate that the nanocomposite with up to 40% of AgInS(2) doping exhibited excellent catalytic activity for tetracycline degradation under visible light irradiation (∼99% tetracycline degraded after 4 h) and predominantly maintained its performance after five cycles. These results could promote a new material circularity pathway to develop new semiconductors that can be used to protect water from further pollution
One-pot preparation of alumina-modified polysulfone-graphene oxide nanocomposite membrane for separation of emulsion-oil from wastewater
In recent years, polysulfone-based nanocomposite membranes have been widely used for contaminated water treatment because they comprise properties such as high thermal stability and chemical resistance. In this study, a polysulfone (PSf) nanocomposite membrane was fabricated using the wet-phase inversion method with the fusion of graphene oxide (GO) and alumina (Al2O3) nanoparticles. We also showed that GO-Al2O3 nanoparticles were synthesised successfully by using a one-pot hydrothermal method. The nanocomposite membranes were characterised by Fourier transform infrared (FT-IR), scanning electron microscopy (SEM), nitrogen adsorption-desorption isotherms, energy-dispersive X-ray spectroscopy (EDX), thermogravimetric analysis (TGA), and water contact angle. The loading of GO and Al2O3 was investigated to improve the hydrophilic and oil rejection of the matrix membrane. It was shown that by using 1.5 wt.% GO-Al2O3 loaded in polysulfone, ~74% volume of oil was separated from the oil/water emulsion at 0.87 bar and 30 min. This figure was higher than that of the process using the unmodified membrane (PSf/GO) at the same conditions, in which only ~60% volume of oil was separated. The pH, oil/water emulsion concentration, separation time, and irreversible fouling coefficient (FRw) were also investigated. The obtained results suggested that the GO-Al2O3 nanoparticles loaded in the polysulfone membrane might have potential use in oily wastewater treatment applications
Van der Waals epitaxy of Bi2Se3 on Si(111) vicinal surface: An approach to prepare high-quality thin films of topological insulator
Epitaxial growth of topological insulator Bi2Se3 thin films on nominally flat
and vicinal Si(111) substrates is studied. In order to achieve planner growth
front and better quality epifilms, a two-step growth method is adopted for the
van der Waal epitaxy of Bi2Se3 to proceed. By employing vicinal Si(111)
substrate surfaces, the in-pane growth rate anisotropy of Bi2Se3 is explored to
achieve single crystalline Bi2Se3 epifilms, in which threading defects and
twins are effectively suppressed. Optimization of the growth parameters has
resulted in vicinal Bi2Se3 films showing a carrier mobility of ~ 2000 cm2V-1s-1
and the background doping of ~ 3 x 1018 cm-3 of the as-grown layers. Such
samples not only show relatively high magnetoresistance but also a linear
dependence on magnetic field.Comment: 18 pages, 4 figure
Fast response and high sensitivity ZnO/glass surface acoustic wave humidity sensors using graphene oxide sensing layer.
We report ZnO/glass surface acoustic wave (SAW) humidity sensors with high sensitivity and fast response using graphene oxide sensing layer. The frequency shift of the sensors is exponentially correlated to the humidity change, induced mainly by mass loading effect rather than the complex impedance change of the sensing layer. The SAW sensors show high sensitivity at a broad humidity range from 0.5%RH to 85%RH with < 1 sec rise time. The simple design and excellent stability of our GO-based SAW humidity sensors, complemented with full humidity range measurement, highlights their potential in a wide range of applications.This work was supported
by NSFC (Nos. 61274037, 61274123, and 61474099) and the Zhejiang Provincial NSF (Nos.
Z11101168 and LR12F04001). The authors also would like to acknowledge the financial
support by the Innovation Platform of Micro/Nano devices and Integration System,
Zhejiang University. TH wishes to acknowledge funding from the Royal Academy of
Engineering. YX thanks the award from China Scholarship Council (CSC), Scholarship of
Cyber Innovation Joint Research Center, Support by the Fundamental Research Funds for
the Central Universities (2014XZZX006), and Fellowship from Churchill College at
University of Cambridge.This is the final published version of the article. It originally appeared at http://www.nature.com/srep/2014/141126/srep07206/full/srep07206.html
- …