151,746 research outputs found
Comparison of different measures for quantum discord under non-Markovian noise
Two geometric measures for quantum discord were recently proposed by Modi et
al. [Phys. Rev. Lett. 104, 080501 (2010)] and Dakic et al. [Phys. Rev. Lett.
105, 190502 (2010)]. We study the similarities and differences for total
quantum correlations of Bell-diagonal states using these two geometry-based
quantum discord and the original quantum discord. We show that, under
non-Markovian dephasing channels, quantum discord and one of the geometric
measures stay constant for a finite amount of time, but not the other geometric
measure. However, all the three measures share a common sudden change point.
Our study on critical point of sudden transition might be useful for keeping
long time total quantum correlations under decoherence.Comment: 10 pages, 3 figures submitted for publicatio
Electronic properties of bilayer phosphorene quantum dots in the presence of perpendicular electric and magnetic fields
Using the tight-binding approach, we investigate the electronic properties of
bilayer phosphorene (BLP) quantum dots (QDs) in the presence of perpendicular
electric and magnetic fields. Since BLP consists of two coupled phosphorene
layers, it is of interest to examine the layer-dependent electronic properties
of BLP QDs, such as the electronic distributions over the two layers and the
so-produced layer-polarization features, and to see how these properties are
affected by the magnetic field and the bias potential. We find that in the
absence of a bias potential only edge states are layer-polarized while the bulk
states are not, and the layer-polarization degree (LPD) of the unbiased edge
states increases with increasing magnetic field. However, in the presence of a
bias potential both the edge and bulk states are layer-polarized, and the LPD
of the bulk (edge) states depends strongly (weakly) on the interplay of the
bias potential and the interlayer coupling. At high magnetic fields, applying a
bias potential renders the bulk electrons in a BLP QD to be mainly distributed
over the top or bottom layer, resulting in layer-polarized bulk Landau levels
(LLs). In the presence of a large bias potential that can drive a
semiconductor-to-semimetal transition in BLP, these bulk LLs exhibit different
magnetic-field dependences, i.e., the zeroth LLs exhibit a linear-like
dependence on the magnetic field while the other LLs exhibit a square-root-like
dependence.Comment: 11 pages, 6 figure
Recommended from our members
Performance of bolted steel-beam to CFST-column joints using stiffened angles in column-removal scenario
This paper presents three experimental investigations on the performance of steel-beam to CFST-column joints using stiffened angle, long bolts and fin plate under a middle column removal scenario. Three specimens were designed and tested. The failure modes and catenary action are investigated in detail. The test results show that increasing the angle plate thickness at the joint could not only improve its performance significantly, but also trigger an early formation of catenary action. Increasing the length of short-limb had influence on the deformation ability of the proposed joint, rather than the load capacity. The buckling of stiffeners could prevent the brittle failure of the joints. With the contribution of catenary action, the joint shows much higher rotation capacities than that required in DoD design guidance. The initial stiffness of the joint was calculated using an analytical model with consideration of bolt pretension. Good agreement to the test results is achieved. A numerical analysis is also carried out, whose results show that adding additional row of bolts would improve the redundancy of the joint under column loss. An equivalent dynamic response evaluation of the joints was also performed. The results show that dynamic amplification coefficient should be worked out considering catenary action under large deformation
Recommended from our members
Enhanced forward stimulated Brillouin scattering in silicon photonic slot waveguide Bragg grating
We study the forward stimulated Brillouin scattering process in a suspended silicon slot waveguide Bragg grating. Full-vectorial formalism is applied to analyze the interplay of electrostriction and radiation pressure. We show that radiation pressure is the dominant factor in the proposed waveguide. The Brillouin gain strongly depends on the structural parameters and the maximum value in the order of 106 W−1 m−1 is obtained in the slow light regime, which is more than two orders larger than that of the stand-alone strip and slot waveguides
The optical/UV excess of isolated neutron stars in the RCS model
The X-ray dim isolated neutron stars (XDINSs) are peculiar pulsar-like
objects, characterized by their very well Planck-like spectrum. In studying
their spectral energy distributions, the optical/UV excess is a long standing
problem. Recently, Kaplan et al. (2011) have measured the optical/UV excess for
all seven sources, which is understandable in the resonant cyclotron scattering
(RCS) model previously addressed. The RCS model calculations show that the RCS
process can account for the observed optical/UV excess for most sources . The
flat spectrum of RX J2143.0+0654 may due to contribution from bremsstrahlung
emission of the electron system in addition to the RCS process.Comment: 6 pages, 2 figures, 1 table, accepted for publication in Research in
Astronomy and Astrophysic
- …