Airfoil shape for flight at subsonic speeds

An airfoil is examined that has an upper surface shaped to control flow accelerations and pressure distribution over the upper surface and to prevent separation of the boundary layer due to shock wave formulation at high subsonic speeds well above the critical Mach number. A highly cambered trailing edge section improves overall airfoil lifting efficiency. Diagrams illustrating supersonic flow and shock waves over the airfoil are shown

Introductory Remarks

Advanced transonic configurations, such as the supercritical wing, are inherently more sensitive to Reynolds number than earlier configurations because the pressure recovery gradients imposed on the boundary layer are generally steeper. The results of two-dimensional supercritical airfoil investigations and theoretical calculations show this effect. A technique for approximately simulating full-scale Reynolds number characteristics at present wind-tunnel Reynolds numbers for near-cruise conditions is described. The transition strip, which in the past has been located near the leading edge of the wing, is rearward so that the relative displacement thickness of the boundary layer at the trailing edge of the wing is the same as might be expected on a full-scale configuration with the transition near the leading edge. Two-dimensional wind-tunnel results indicate that the technique provides a very good simulation of airfoil characteristics at full-scale Reynolds number. The need for sorting the effects of Reynolds number and aeroelasticity, which can be done in the NTF, is also addressed

Advanced Transonic Aerodynamic Technology

Supercritical airfoils and their applications to wings for various types of aircraft are studied. The various wings discussed were designed for a subsonic jet transport with increased speed, a variable sweep fighter with greater transonic maneuverability, a high subsonic speed STOL jet transport with improved low speed characteristics, and a subsonic jet transport with substantially improved aerodynamic efficiency. Results of wind tunnel and flight demonstration investigations are described. Also discussed are refinements of the transonic area rule concept and methods for reducing the aerodynamic interference between engine nacelles and wings at high subsonic speeds

A design approach and selected wind tunnel results at high subsonic speeds for wing-tip mounted winglets

Winglets, which are small, nearly vertical, winglike surfaces, substantially reduce drag coefficients at lifting conditions. The primary winglet surfaces are rearward above the wing tips; secondary surfaces are forward below the wing tips. This report presents a discussion of the considerations involved in the design of the winglets; measured effects of these surfaces on the aerodynamic forces, moments, and loads for a representative first generation, narrow body jet transport wing; and a comparison of these effects with those for a wing tip extension which results in approximately the same increase in bending moment at the wing-fuselage juncture as did the addition of the winglets

NASA low- and medium-speed airfoil development

The status of NASA low and medium speed airfoil research is discussed. Effects of airfoil thickness-chord ratios varying from 9 percent to 21 percent on the section characteristics for a design lift coefficient of 0.40 are presented for the initial low speed family of airfoils. Also, modifications to the 17-percent low-speed airfoil to reduce the pitching-moment coefficient and to the 21-percent low speed airfoil results are shown for two new medium speed airfoils with thickness ratios of 13 percent and 17 percent and design-lift coefficients of 0.30. Applications of NASA-developed airfoils to general aviation aircraft are summarized

What Happened to the Thoreau Spring Plaque? The Story of a Maine Landmark\u27s Two Names

Thoreau Spring lies at the convergence of two trails high on Katahdin, in Maine. Howard R. Whitcomb tells the story of the spring’s two names and vandalism of a plaque that marked it

Monarch: A Reimagined Browser for the Modern Web

Web browsers have become fast and flexible enough to allow web applications to be viable competition to native applications. Now that the web as a platform has become formidable, it has changed the types of web applications being produced, and the ways in which native applications are being built. This observation leads me to propose the concept of the App Web - a category of the world wide web which increases productivity - and its place in the current application experience. Monarch is a system designed to merge the advantages of native and web applications, improving experiences for both the developer and the user