Critical Point Mounting of Kinetoplast DNA for Atomic Force Microscopy

Atomic force microscope (AFM) images of intact kinetoplast DNA were obtained from samples prepared utilizing critical point drying. These images are compared with AFM images obtained using conventional methods for DNA deposition. Although the images obtained on chemically pretreated mica show more details than on unmodified mica, images obtained with critical point drying were superior. Kinetoplast networks with expected sizes and structures were routinely observed with critical point drying. The resolution of individual strands of DNA was greatly improved, and image artifacts associated with air dried samples were eliminated. Samples prepared using mildly sonicated kinetoplast DNA show isolated minicircles

Scanning Tunneling Microscopy and Spectroscopy of Plasmid DNA

We present scanning tunneling microscope (STM) images of uncoated deoxyribonucleic acid (DNA) electrochemically mounted on highly-oriented pyrolytic graphite (HOPG) and imaged in air. Images of linear abnormalities inherent to HOPG surfaces that can be confused with DNA are also presented. Scanning tunneling spectroscopic (STS) images generated by superimposing a small, high frequency ac bias onto the de tunnel bias and recording the ac current signal were taken simultaneously with the topographic images. These spectroscopic images reveal contrast due to local conductivity variations and can be used to differentiate DNA molecules from graphite artifacts

Atomic Force Microscopy of DNA on Mica and Chemically Modified Mica

Atomic force microscopy (AFM) was used to image circular DNA adsorbed on freshly cleaved mica and mica chemically modified with Mg(II), Co(II), La(III), and Zr(IV). Images obtained on unmodified mica show coiling of DNA due to forces involved during the drying process. The coiling or super twisting appeared to be right handed and the extent of super twisting could be controlled by the drying conditions. Images of DNA observed on chemically modified surfaces show isolated open circular DNA that is free from super twisting, presumably due to strong binding of DNA on chemically modified surfaces

Calibration of Atomic Force Microscope Tips Using Biomolecules

Atomic force microscope (AFM) images of surfaces and samples mounted on substrates are subject to artifacts such as broadening of structures and ghost images of tips due to the finite size and shape of the contacting probe. Therefore, knowledge of the radius of the AFM probe tip is essential for the interpretation of images. We have deduced the shape of the AFM tip by imaging cylindrical biological molecules of various diameters such as deoxyribonucleic acid (DNA), tobacco mosaic virus (TMV), tobacco etch virus (TEV) and bacteriophage M-13 (M-13). Using a paraboloidal tip model and numerically solving equations of contact, the curvatures of the tip and lithographically sharpened tip were ascertained

Triangular Step Instability and 2D/3D Transition During the Growth of Strained Ge Films on Si(100)

We show that an activation energy barrier exists to the formation of wavy step edges due to stress-driven 2D instability. The barrier height and the barrier width depend sensitively on the surface stress anisotropy and step free energy. The large misfit strain of Ge films significantly reduces the barrier by lowering the S{sub B} step energy, inducing S{sub A} steps to undergo a triangular instability even during low temperature growth of Ge on Si(100). The step instability results in a novel arrangement of stress domains, and the interaction between the domains causes a spatial variation of surface strain with a surprisingly large influence on the energy barrier for island nucleation. Calculations indicate a dramatic enhancement in the nucleation of 3D islands at the apex regions of triangular steps, in good agreement with our experimental measurements

Optical and infrared detection using microcantilevers

The feasibility of micromechanical optical and infrared (IR) detection using microcantilevers is demonstrated. Microcantilevers provide a simple means for developing single- and multi-element sensors for visible and infrared radiation that are smaller, more sensitive and lower in cost than quantum or thermal detectors. Microcantilevers coated with a heat absorbing layer undergo bending due to the differential stress originating from the bimetallic effect. Bending is proportional to the amount of heat absorbed and can be detected using optical or electrical methods such as resistance changes in piezoresistive cantilevers. The microcantilever sensors exhibit two distinct thermal responses: a fast one ({theta}{sub 1}{sup thermal} < ms) and a slower one ({tau}{sub 2}{sup thermal} {approximately} 10 ms). A noise equivalent temperature difference, NEDT = 90 mK was measured. When uncoated microcantilevers were irradiated by a low-power diode laser ({lambda} = 786 nm) the noise equivalent power, NEP, was found to be 3.5nW/{radical}Hz which corresponds to a specific detectivity, D*, of 3.6 {times} 10{sup 7} cm {center_dot} {radical}Hz/W at a modulation frequency of 20 Hz

Growth and transport properties of Y-Ba-Cu-O/Pr-Ba-Cu-O superlattices

The pulsed-laser deposition method has been used to fabricate epitaxial, nonsymmetric M(Y) {times} N(Pr) superlattices in which YBa{sub 2}Cu{sub 3}O{sub 7-x} (YBCO) layers either M = 1,2,3,4,8, or 16 c-axis unit cells thick are separated by insulating PrBa{sub 2}Cu{sub 3}O{sub 7-x} (PBCO) layers N unit cells thick (N = 1 to {approximately}32). The zero-resistance superconducting transition temperature, T{sub c0}, initially decreases rapidly with increasing PBCO layer thickness, but then saturates at T{sub c0} {approximately} 19 K, 54 K, 71 K, or 80 K, or structures containing 1-,2-,3-, or 4-cell-thick YBCO layers, respectively. Critical current density measurements carried out on structures with 16- or 32-cell thick YBCO layers show that the magnitude of J{sub c}(H = 0) {approximately} 1-2 MA/cm{sup 2}, as well as the magnetic field dependence and the anisotropy of J{sub c}(H) all are in good agreement with corresponding measurements on thicker, single-layer YBCO films. Thus, there is no evidence of an enhanced J{sub c}(H) due to the multi-layered structure, for the layer thickness investigated to date. The systematic variation of T{sub c0}, as a function of the YBCO and PBCO layer thickness, is discussed in light of other recent experiments and theoretical model calculations. The superlattices' structural and compositional order are characterized using x-ray diffraction, transmission electron microscopy, and scanning tunneling microscopy, and details of the pulsed-laser deposition process are reported. 42 refs., 7 figs

Combination therapy in hypertension: An update

Meticulous control of blood pressure is required in patients with hypertension to produce the maximum reduction in clinical cardiovascular end points, especially in patients with comorbidities like diabetes mellitus where more aggressive blood pressure lowering might be beneficial. Recent clinical trials suggest that the approach of using monotherapy for the control of hypertension is not likely to be successful in most patients. Combination therapy may be theoretically favored by the fact that multiple factors contribute to hypertension, and achieving control of blood pressure with single agent acting through one particular mechanism may not be possible. Regimens can either be fixed dose combinations or drugs added sequentially one after other. Combining the drugs makes them available in a convenient dosing format, lower the dose of individual component, thus, reducing the side effects and improving compliance. Classes of antihypertensive agents which have been commonly used are angiotensin receptor blockers, thiazide diuretics, beta and alpha blockers, calcium antagonists and angiotensin-converting enzyme inhibitors. Thiazide diuretics and calcium channel blockers are effective, as well as combinations that include renin-angiotensin-aldosterone system blockers, in reducing BP. The majority of currently available fixed-dose combinations are diuretic-based. Combinations may be individualized according to the presence of comorbidities like diabetes mellitus, chronic renal failure, heart failure, thyroid disorders and for special population groups like elderly and pregnant females