Study on the effects of nitrilotriproprionic acid and 4,5-dihydroxy-1,3-benzene disulphonate on the fractionation of beryllium in human serum using graphite furnace atomic absorption spectrometry

<p>Abstract</p> <p>Background</p> <p>Occupational exposure to beryllium may cause Chronic Beryllium Disease (CBD), a lung disorder initiated by an electrostatic interaction with the MHC class II human leukocyte antigen (HLA). Molecular studies have found a significant correlation between the electrostatic potential at the HLA-DP surface and disease susceptibility. CBD can therefore be treated by chelation therapy. In this work, we studied the effect of two complexing agents, nitrilotriproprionic acid (NTP) and 4,5-dihydroxy-1,3-benzene disulphonate (Tiron), on the fractionation of beryllium in human serum analysed by graphite furnace atomic absorption spectrometry (GFAAS).</p> <p>Results</p> <p>We found the average serum beryllium concentration of fourteen non-exposed individuals to be 0.53 (± 0.14) μg l^-1, with 21 (± 3)% of the beryllium mass bound to the low molecular weight fraction (LMW), and 79 (± 3)% bound to the high molecular weight fraction (HMW). The addition of Tiron increased the beryllium mass in the HMW fraction, while NTP was not seen to have any influence on the fractionation of beryllium between the two fractions. NTP was, however, shown to complex 94.5% of the Be mass in the LMW fraction. The beryllium GFAAS detection limit, calculated as three times the standard deviation of 10 replicates of the lowest standard (0.05 μg L^-1), was 6.0 (± 0.2) ng L^-1.</p> <p>Conclusion</p> <p>The concentration of beryllium or its fractionation in human serum was not affected by sex or smoking habit. On average, three quarters of the beryllium in serum were found in the HMW fraction. Of the two ligands tested, only Tiron was effective in mobilising beryllium under physiological conditions, thus increasing the Be content in the HMW fraction.</p

Formation of Zn- and Fe-sulfides near hydrothermal vents at the Eastern Lau Spreading Center: implications for sulfide bioavailability to chemoautotrophs

This is an Open Access article distributed under the terms of the Creative Commons Attribution Licens

Removal of chromium, copper, and nickel from an electroplating effluent using a flocculent brewer's yeast strain of Saccharomyces cerevisiae

The release of heavy metals in aquatic systems due to the discharge of industrial wastewaters is a matter of environmental concern. Heat-inactivated cells of a flocculent strain of Saccharomyces cerevisiae were used in the bioremediation, in a batch mode, of a real electroplating effluent containing Cu, Ni, and Cr. In this approach, no previous reduction of Cr(VI) to Cr(III) was required. Cr(VI) was selectively removed (98%) by yeast biomass at pH 2.3. At this pH, Cr(VI) is mainly in the form of HCrO4− and yeast surface is surrounded by H+ ions, which enhance the Cr(VI) interaction with biomass binding sites by electrostatic forces. Subsequently, pH of the effluent was raised up to 6.0; this pH maximizes the efficiency of cations removal since at this pH the main binding groups of yeast cells are totally or partially deprotonated. The passage of effluent through a series of sequential batches, at pH 6.0, allowed, after the third batch, the removal of Cu(II), Ni (II), Cr total, and Cr(VI) in the effluent to values below the legal limit of discharge. The strategy proposed in the present work can be used in plants for the treatment of heavy metals rich industrial effluents containing simultaneously Cr(VI) and Cr(III).The authors thank to the "Fundacao para a Ciencia e a Tecnologia" (FCT) from Portuguese Government for the financial support of this work with FEDER founds, by the Project POCTI/CTA/47875/2002. Manuela D. Machado is also gratefully acknowledged for a grant scholarship financed under the same project and another grant from FCT (SFRH/BD/31755/2006)