Modification of alumina matrices through chemical etching and electroless deposition of nano-Au array for amperometric sensing

Simple nanoporous alumina matrix modification procedure, in which the electrically highly insulating alumina barrier layer at the bottom of the pores is replaced with the conductive layer of the gold beds, was described. This modification makes possible the direct electron exchange between the underlying aluminum support and the redox species encapsulated in the alumina pores, thus, providing the generic platform for the nanoporous alumina sensors (biosensors) with the direct amperometric signal readout fabrication

Mass-Transport-Limited Electrodeposition of High-Surface-Area Coatings for Surface Acoustic Wave Sensor Technology

The sensitivity of surface acoustic wave (SAW) sensors has been enhanced by increasing the active surface area of these devices, Electrodepositions of Ni, Pd, and Pt in a mass-transport-limited mode with trace foreign metals yield highly dendritic crystal structures of uniform macroscopic thickness. The concentration of metal ions, supporting electrolyte, agitation, and additives greatly impact the crystal morphology of the deposit. This methodology can be used simply and economically to provide high-area films in selective regions

A forest without trees: Development of high-surface-area materials for enhanced-sensitivity SAW arrays

Chemical sensor arrays are an alternative to the tedious development of highly specific single-analyte detectors. Recent efforts have focused on the chemical and physical diversity of interface materials for SAW sensor arrays. However, the issues of wide dynamic range and high sensitivity must also be addressed for sensor arrays to compete in applications requiring low detection limits. Because SAW devices respond in proportion to change in mass per nominal unit area of the device surface, sensitivity is enhanced by surface modification with high-area, thin-film coating materials: a greater mass of analyte is adsorbed at a given ambient concentration. The authors are exploring several classes of electrochemically prepared high-area films, materials whose formulations and processing are well documented for applications other than chemical sensors. They present results from films formed by anodization, chemical conversion, and electroplating, yielding surface area enhancements as high as 170x

Ion-Conducting Polymer Films as Chemical Sensors

Solid Polymer Electrolytes (SPE) are widely used in batteries and fuel cells because of the high ionic conductivity that can be achieved at room temperature. The ions are usually Li or protons, although other ions can be shown to conduct in these polymer films. There has been very little work on using these films as chemical sensors. We have found that thin films of polymers like polyethyleneoxide (PEO) are very sensitive to low concentrations of volatile organic compounds (VOCS) like common solvents. We will present impedance spectroscopy of PEO films in the frequency range 0.01 Hz to 1 MHz for different concentrations of VOCS. We find that the measurement frequency is important for distinguishing ionic conductivity from the double layer capacitance and parasitic capacitances

Optimizing Chemical Sensor Array Sizes

Optimal selection of array sensors for a chemical sensing application is a nontrivial task. It is commonly believed that "more is better" when choosing the number of sensors required to achieve good chemical selectivity. However, cost and system complexity issues point towards the choice of small arrays. A quantitative array optimization is carried out to explore the selectivity of arrays of partially-selective chemical sensors as a function of array size. It is shown that modest numbers (dozens) of target analytes are completely distinguished with a range of arrays sizes. However, the array selectivity and the robustness against sensor sensitivity variability are significantly degraded if the array size is increased above a certain number of sensors, so that relatively small arrays provide the best performance. The results also suggest that data analyses for very large arrays of partially-selective sensors will be optimized by separately anal yzing small sensor subsets

Integrated chemiresistor and work function microsensor array with carbon black/polymer composite materials

An array of chemically-sensitive field-effect transistors (CHEMFETs) that measure both work function and bulk resistance changes in thin films was used to detect volatile organic compounds. Carbon black/organic polymer composite films were deposited onto the CHEMFETs using an automated microdispensing method