Two-Loop Large-mtm_t Electroweak Corrections to K→πννˉK\to\pi\nu\bar\nu for Arbitrary Higgs Boson Mass

We consider for the first time the leading large top mass corrections, arising at higher order in electroweak interactions, to the rare decays $K\to\pi\nu\bar\nu$ and the related modes $B\to X_s\nu\bar\nu$ and $B\to l^+l^-$. Higher order effects of similar type have previously been calculated in the large-$m_t$ limit for key observables of precision electroweak physics at Z-factories. Here we obtain the corresponding corrections of order ${\cal O}(G^2_F m^4_t)$ at the amplitude level for short-distance dominated rare meson decays. This allows us to quantify the importance of higher order electroweak effects for these processes, which can be reliably computed and have very small uncertainties from strong interactions. Simultaneously it becomes possible to remove, to some extent, ambiguities in the definition of electroweak parameters describing the strength of FCNC interactions. The corrections we discuss are at the level of a few percent.Comment: 11 pages, LaTeX, 1 eps-figur

Effects of various fluoride solutions on enamel erosion in vitro

The objective of this in vitro study was to investigate the effect of different fluoride solutions on enamel erosion. Human enamel specimens were pretreated with 1 of 10 different fluoride solutions (n = 20): TiF(4), NaF, AmF, ZnF(2), or SnF(2), each at native pH (pH range: 1.2-7.8) or buffered pH (pH = 4). The control group samples received no fluoride pretreatment. All samples were then eroded by citric acid (pH 2.6) for 6 x 1 min daily over 5 days. Between the erosive cycles, the samples were stored in artificial saliva. Erosion effects were investigated by surface profilometry (n = 10), scanning electron microscopy (n = 4), and energy-dispersive X-ray spectroscopy (n = 6) after fluoride pretreatment and after erosion. To test the effects of pH only, additional experiments were carried out with fluoride-free solutions at similar pH to that of fluoride solutions. In general, AmF solution was more effective in protecting enamel erosion compared to all other fluoride agents. However, the application of native TiF(4), native and buffered SnF(2), and native and buffered AmF solutions also resulted in significantly less enamel loss compared to the control group. A Ti-rich coating was formed after application of native TiF(4), but partially dissolved due to erosive attack. Samples pretreated with SnF(2) showed a significant increase in surface tin content. Surface fluoride concentration was significantly increased by native TiF(4), native and buffered AmF, buffered ZnF(2), and buffered NaF application. Under the current experimental setting, the fluoride agents at lower pH had better protective potential. Highly concentrated TiF(4), AmF, and SnF(2) solution was effective in inhibiting erosion of enamel

Estimate of B(K -> pi nu nubar) from Standard Model fits to lambda_t

We estimate B(K -> pi nu nubar) in the context of the Standard Model by fitting for lambda_t = Vtd x V*ts of the `kaon unitarity triangle' relation. We fit data from epsilon_K, the CP-violating parameter describing K-mixing, and a_{psi K}, the CP-violating asymmetry in B -> J/psi K decays. Our estimate is independent of the CKM matrix element Vcb and of the ratio of Bs to Bd mixing frequencies. The measured value of B(K+ -> pi+ nu nubar) can be compared both to this estimate and to predictions made from the ratio of B mixing frequencies.Comment: 8 pages, including 6 figures. v3 includes an expanded discussion of correlations between SM inputs to the lambda_t fit, clarifies the discussion of the independence of this result from the ratio of B mixing frequencies, includes minor updates to the values of SM input parameters, and includes some new and some updated reference

Effects of the K+→π+ννˉK^+\to\pi^+\nu\bar{\nu} and of other processes on the mixing hierarchies in the four-generation model

We analyze in the four-generation model the first measurement of the branching ratio of rare kaon decay $K^+\to\pi^+\nu\bar{nu}$, along with the other processes of $K_L-K_S$ mass difference $\Delta m_K$, CP-violating parameter $\epsilon_K, B_d-\bar{B_d}$ mixing, $B_s-\bar{B_s}$ mixing, $B(K_L\to\mu\bar{\mu})$, and the upper bound values of $D^0-\bar{D^0}$ mixing and $B(K_L\to\pi^0\nu\bar{\nu})$, and try to search for mixing of the fourth generation in the hierarchical mixing scheme of the Wolfenstein parametrization. Using the results for the mixing of the fourth generation, we discuss predictions of the $D^0-\bar{D^0}$ mixing ($\Delta m_D$) and the branching ratio of directly CP-violating decay process $K_L\to\pi^0\nu\bar{\nu}$, and the effects on the CP asymmetry in neutral B meson decays and the unitarity triangle.Comment: 29 pages written in LaTex. 6 figures(drawn on LaTeX). Revised from "$K^+\to\pi^+\nu\bar{\nu}$ in the four-generation model" of the same Authors(TOKUSHIMA 99-1, January 1999). A minor chang

Final State Interactions and CP Violation in KL→π+π−e+e−K_L \to \pi^+ \pi^- e^+ e^-

Using chiral perturbation theory we calculate the imaginary parts of the $K_L \rightarrow \pi^+ \pi^- e^+ e^-$ form factors that arise from $\pi \pi \rightarrow \pi^+ \pi^-$ and $\pi \pi \rightarrow \pi^+ \pi^- \gamma^*$ rescattering. We discuss their influence on CP violating variables in $K_L \rightarrow \pi^+ \pi^- e^+ e^-$.Comment: ; 12 pages, 2 figures, TeX format; uses epsf.tex, tables.tex, and phyzzx.te

Nonfactorizable QCD and Electroweak Corrections to the Hadronic Z Boson Decay Rate

We present an analysis of two-loop mixed QCD and electroweak corrections to the decay of the Z boson into light quarks. We find that the naive factorization of QCD and electroweak corrections does not describe correctly the two-loop effects. The nonfactorizable corrections shift the width of the Z boson by approximately -0.55(3) MeV and increase the central value of the strong coupling constant determined at LEP by 0.001.Comment: 9 pages, Revte

Deposition of fluoride on enamel surfaces released from varnishes is limited to vicinity of fluoridation site

The aim of the in-situ study was to determine fluoride uptake in non-fluoridated, demineralized enamel after application of fluoride varnishes on enamel samples located at various distances from the non-fluoridated samples. All enamel samples used were demineralized with acidic hydroxyethylcellulose before the experiment. Intra-oral appliances were worn by ten volunteers in three series: (1, Mirafluorid, 0.15% F; 2, Duraphat, 2.3% F and 3, unfluoridated controls) of 6days each. Each two enamel samples were prepared from 30 bovine incisors. One sample was used for the determination of baseline fluoride content (BFC); the other was treated according to the respective series and fixed in the intra-oral appliance for 6days. Additionally, from 120 incisors, each four enamel samples were prepared (one for BFC). Three samples (a-c) were placed into each appliance at different sites: (a) directly neighboured to the fluoridated specimen (=next), (b) at 1-cm distance (=1cm) and (c) in the opposite buccal aspect of the appliance (=opposite). At these sites, new unfluoridated samples were placed at days 1, 3 and 5, which were left in place for 1day. The volunteers brushed their teeth and the samples with fluoridated toothpaste twice per day. Both the KOH-soluble and structurally bound fluoride were determined in all samples to determine fluoride uptake and were statistically analyzed. One day, after fluoridation with Duraphat, KOH-soluble fluoride uptake in specimen a (=next) was significantly higher compared to the corresponding samples of both the control and Mirafluorid series, which in turn were not significantly different from each other. At all other sites and time points, fluoride uptake in the enamel samples were not different from controls for both fluoride varnishes. Within the first day after application, intra-oral-fluoride release from the tested fluoride varnish Duraphat leads to KOH-soluble fluoride uptake only in enamel samples located in close vicinity to the fluoridation sit

Precision Flavour Physics with B→KννˉB\to K\nu\bar\nu and B→Kl+l−B\to Kl^+l^-

We show that a combined analysis of $B\to K\nu\bar\nu$ and $B\to Kl^+l^-$ allows for new physics tests practically free of form factor uncertainties. Residual theory errors are at the level of several percent. Our study underlines the excellent motivation for measuring these modes at a Super Flavour Factory.Comment: 26 pages, 2 figure

Ultrasonic activation of irrigants increases growth factor release from human dentine.

OBJECTIVES Bioactive proteins are sequestered in human dentine and play a decisive role in dental pulp regeneration and repair. They can be released and exposed on the dentine surface by acids, but also chelators, such as ethylenediaminetetraacetic acid (EDTA). The objectives of this study were (i) to evaluate whether ultrasonic activation of irrigants in the root canal will promote growth factor release from dentine and (ii) to collect bioactive proteins in a physiological solution. MATERIALS AND METHODS Human dentine disks underwent irrigation with and without ultrasonic activation. The protocols included treatment by either a single or two consecutive steps with 10 % EDTA and phosphate-buffered saline (PBS), where each sample was treated three times. To mimic clinical conditions, selected irrigation regimens were applied to root canals of extracted human teeth after preparation. Amounts of transforming growth factor β1 (TGF-β1) in solution were quantified using enzyme-linked immunosorbent assays. Nonparametric statistical analysis was performed to compare different groups as well as repetitions within a group (Mann-Whitney U test, α = 0.05). Additionally, morphological changes of dentine surfaces were visualized by scanning electron microscopy (SEM). RESULTS TGF-β1 was not detectable after irrigation of dentine with PBS, neither with nor without ultrasonic activation. Irrigation with EDTA released TGF-β1, and ultrasonic activation of EDTA enhanced this effect. However, preceding EDTA conditioning enabled the release of bioactive proteins into PBS solution. Similar results were observed in dentine disks and root canals. Visualization of dentine surfaces after different treatment revealed superficial erosion after ultrasonic activation irrespective of the irrigant solution, but different degrees of exposure of organic substance. CONCLUSIONS Ultrasonic activation enhances growth factor release from human dentine. Bioactive proteins can be isolated in physiological solvents and may act as autologous supplements for regenerative endodontic treatment or pulp tissue engineering. CLINICAL RELEVANCE Autologous growth factors from human dentine can advance treatment strategies in dental pulp tissue engineering