MSFC Skylab attitude and pointing control system mission evaluation

The results of detailed performance analyses of the attitude and pointing control system in-orbit hardware and software on Skylab are reported. Performance is compared with requirements, test results, and prelaunch predictions. A brief history of the altitude and pointing control system evolution leading to the launch configuration is presented. The report states that the attitude and pointing system satisfied all requirements

Stabilization and control of the Apollo Telescope Mount

Apollo Telescope Mount stabilization and control, with control moment gyro and experiment pointing control subsystem

AN EVALUATION OF DATA ON NUCLEAR CARBIDES

Data on the properties, constitution, compatibility, radiation behavior, fabrication, preparation, storage, and handling of uranium, thorium, and plutonium carbides are reviewed. 187 references. (C.J.G.

Assessment of disk MHD generators for a base load powerplant

Results from a study of the disk MHD generator are presented. Both open and closed cycle disk systems were investigated. Costing of the open cycle disk components (nozzle, channel, diffuser, radiant boiler, magnet and power management) was done. However, no detailed costing was done for the closed cycle systems. Preliminary plant design for the open cycle systems was also completed. Based on the system study results, an economic assessment of the open cycle systems is presented. Costs of the open cycle disk conponents are less than comparable linear generator components. Also, costs of electricity for the open cycle disk systems are competitive with comparable linear systems. Advantages of the disk design simplicity are considered. Improvements in the channel availability or a reduction in the channel lifetime requirement are possible as a result of the disk design

Polarization and wavelength diversities of Gulf Stream fronts imaged by AIRSAR

During the 1990 Gulf Stream Experiment, NASA/JPL AIRSAR imaged the north edge of the Gulf Stream near the coast of Virginia. Simultaneous in-situ measurements of currents, temperatures, salinities, etc. were made for several crossings of the north edge by the R/V Cape Henlopen. Measurements identified two fronts with shearing and converging flows. The polarimetric SAR images from the fronts showed two bright linear features. One of them corresponds to the temperature front, which separated the warm Gulf Stream water to the south from a cool, freshwater filament to the north. The other line, located about 8 km north of the temperature front, is believed to correspond to the velocity front between the filament and the slope water. At these fronts, wave-current interactions produced narrow bands of steep and breaking waves manifesting higher radar returns in polarimetric SAR images. In general, our AIRSAR imagery shows that the signal-to-clutter ratio of radar cross sections for the temperature front is higher than that of the velocity front. In this paper, we study the polarization and wavelength diversities of radar response of these two fronts using the P-, L-, and C-Band Polarimetric SAR data. The north-south flight path of the AIRSAR crossed the temperature front several times and provided valuable data for analysis. Three individual passes are investigated. We found that for the temperature front, the cross-pol (HV) responses are much higher than co-pol responses (VV and HH), and that P-Band HV has the highest signal to clutter ratio. For the velocity front, the ratio is the strongest in P-Band VV, and it is indistinguishable for all polarizations in C-Band. The radar cross sections for all three polarization (HH, HV, and VV) and for all three bands are modelled using an ocean wave model and a composite Bragg scattering model. In our initial investigations, the theoretical model agrees qualitatively with the AIRSAR observations

Stability of Thin Liquid Sheet Flows

A two-dimensional, linear stability analysis of a thin nonplanar liquid sheet flow in vacuum is carried out. A sheet flow created by a narrow slit of W and tau attains a nonplanar cross section as a consequence of cylinders forming on the sheet edge under the influence of surface tension forces. The region where these edge cylinders join the sheet is one of high curvature, and this is found to be the location where instability is most likely to occur. The sheet flow is found to be unstable, but with low growth rates for symmetric wave disturbances and high growth rates for antisymmetric disturbances. By combining the symmetric and antisymmetric disturbance modes, a wide range of stability characteristics is obtained. The product of unstable growth rate and flow time is proportional to the width-to-thickness ratio of the sift generating the sheet Three-dimensional effects can alter these results, particularly when the sheet length-to-width ratio is not much greater than unity

Preoperative Imaging for Perforator Flaps in Reconstructive Surgery

Background: Although preoperative imaging of perforator vasculature in planning microvascular reconstruction is commonplace, there has not been any clear demonstration of the evidence for this practice, or data comparing the many available modalities in an evidence-based approach. This article aims to provide an objective, evidence-based review of the literature on this subject.\ud \ud Methods: The evidence supporting the use of various modalities of imaging was investigated by performing focused searches of the PubMed and Medline databases. The articles were ranked according to the criteria set out in March 2009 Oxford Centre for Evidence-Based Medicine definitions. Endpoints comprised objective outcome data supporting the use of imaging, including flap loss, unplanned returns to theater, operative time reduction, and surgeon-reported stress.\ud \ud Results: The objective high level of evidence for any form of preoperative perforator imaging is low with only small number of comparative studies or case series investigating computed tomographic angiography (CTA), magnetic resonance angiography, handheld Doppler, color duplex, and classic angiography. Of all modalities, there is a growing body of level 2b evidence supporting the use of CTA.\ud \ud Conclusion: While further multicenter trials testing hard outcomes are needed to conclusively validate preoperative imaging in reconstructive surgery, sufficient evidence exists to demonstrate that preoperative imaging can statistically improve outcomes, and that CTA is the current gold standard for perforator mapping

A study of thin liquid sheet flows

This study was a theoretical and experimental investigation of thin liquid sheet flows in vacuum. A sheet flow created by a narrow slit of width, W, coalesces to a point at a distance, L, as a result of surface tension forces acting at the sheet edges. As the flow coalesces, the fluid accumulates in the sheet edges. The observed triangular shape of the sheet agrees with the calculated triangular result. Experimental results for L/W as a function of Weber number, We, agree with the calculated result, L/W = the sq. root of 8We. The edge cross sectional shape is found to oscillate from elliptic to 'cigar' like to 'peanut' like and then back to elliptic in the flow direction. A theoretical one-dimensional model was developed that yielded only elliptic solutions for the edge cross section. At the points where the elliptic shapes occur, there is agreement between theory and experiment