Equation of motion for dislocations with inertial effects

An approximate equation of motion is proposed for screw and edge dislocations, which accounts for retardation and for relativistic effects in the subsonic range. Good quantitative agreement is found, in accelerated or in decelerated regimes, with numerical results of a more fundamental nature.Comment: 6 pages, 4 figures, LaTe

Magnetostimulated Chandges of Microhardness in Potassium Acid Phthalate Crystals

A decrease in microhardness along the (010) cleavage in potassium acid phthalate single crystals by 15--18% after the application of a permanent magnetic field was revealed for the first time. It is shown that the effect revealed is of the volume character. The role of interlayer water in the processes stimulated by a magnetic field is studied., Interlayer water plays does not cause the observed changes it only plays the part of an indicator of these changes in potassium acid phthalate crystals in a magnetic field. It is established that microhardness in the (100) plane of the crystal in an applied a magnetic field first increases by 12--15% and then remains constant in time within the accuracy of the experiment. The possibility of varying the crystal structure of potassium acid phthalate crystals by applying magnetic fields inducing rearrangement in the system of hydrogen bonds or in the defect structure is discussed.Comment: 6 pages, 7 figure

Lattice Resistance to Dislocation Motion at the Nanoscale

In this letter we propose a model that demonstrates the effect of free surface on the lattice resistance experienced by a moving dislocation in nanodimensional systems. This effect manifests in an enhanced velocity of dislocation due to the proximity of the dislocation line to the surface. To verify this finding, molecular dynamics simulations for an edge dislocation in bcc molybdenum are performed and the results are found to be in agreement with the numerical implementations of this model. The reduction in this effect at higher stresses and temperatures, as revealed by the simulations, confirms the role of lattice resistance behind the observed change in the dislocation velocity.Comment: 4 Figure

Magnetic structural effect in nonequilibrium defective solids

Scientific study of the effect of structural memory of nonequilibrium defective solids about the processing in magnetic field (the magnetic structural effect (MSE) was continued in this paper. The study was aimed to reveal the universal nature of the MSE, which was investigated in several new nonequilibrium defective solids. The results of investigation of the processing in the vortical magnetic field (PVMF) and its effect on the structure of the natural magnetite Fe3O4 and the SnO2 films were presented. The methods of Mössbauer and X-ray spectroscopy were used. The PVMF reduction of a defectiveness of Fe3O4 structure in the magnetite was detected. The MSE was also observed in the Mössbauer spectra of diamagnetic tin oxide SnO2 films after the PVMF. One of the possible explanations of the MSE was given in the paper.Comment: 6 pages, 6 figures, 3 table

Atomistic simulations of dislocation mobility in Al, Ni and Al/Mg alloys

Dislocation velocities and mobilities are studied by Molecular Dynamics simulations for edge and screw dislocations in pure aluminum and nickel, and edge dislocations in Al-2.5%Mg and Al-5.0%Mg random substitutional alloys using EAM potentials. In the pure materials, the velocities of all dislocations are close to linear with the ratio of (applied stress)/(temperature) at low velocities, consistent with phonon drag models and quantitative agreement with experiment is obtained for the mobility in Al. At higher velocities, different behavior is observed. The edge dislocation velocity remains dependent solely on (applied stress)/(temperature) up to approximately 1.0 MPa/K, and approaches a plateau velocity that is lower than the smallest "forbidden" speed predicted by continuum models. In contrast, above a velocity around half of the smallest continuum wave speed, the screw dislocation damping has a contribution dependent solely on stress with a functional form close to that predicted by a radiation damping model of Eshelby. At the highest applied stresses, there are several regimes of nearly constant (transonic or supersonic) velocity separated by velocity gaps in the vicinity of forbidden velocities; various modes of dislocation disintegration and destabilization were also encountered in this regime. In the alloy systems, there is a temperature- and concentration-dependent pinning regime where the velocity drops sharply below the pure metal velocity. Above the pinning regime but at moderate stresses, the velocity is again linear in (applied stress)/(temperature) but with a lower mobility than in the pure metal.Comment: PDF, 30 pages including figures, submitted to Modelling Simul. Mater. Sci. En