High-energy threshold reaction rates on 0.8 GeV proton-irradiated thick Pb-target

This works presents results of activation-aided determination of threshold reaction rates in 92 209Bi, natPb, 197Au, 181Ta, 169Tm, natIn, 93Nb, 64Zn, 65Cu, 63Cu, 59Co, 19F, and 12C samples and in 121 27Al samples. All the samples were aligned with the proton beam axis inside and outside the demountable 92-cm thick Pb target of 15-cm diameter assembled of 23 4-cm thick discs. The samples were placed on 12 target disks to reproduce the long axis distribution of protons and neutrons. In June 2006, the target was exposed for 18 hours to a 800-MeV proton beam extracted from the ITEP U-10 accelerator. The proton fluence and the proton beam shape were determined using the 27Al(p,x)7Be monitor reaction. The reaction rates were determined by the direct gamma-spectrometry techniques. In total, 1196 gamma-spectra have been measured, and about 1500 reaction rates determined. The measured reaction rates were simulated by the MCNPX code using the following databases: ENDF/B6 for neutrons below 20 MeV, MENDL2 for 20-100 MeV neutrons, and MENDL2P for proton cross sections up to 200 MeV. An acceptable agreement of simulations with experimental data has been found.Comment: 4 pages, 5 figures, 3 tables, only pdf file, to be published in Proc. Int. Conf. on Nucl. Data for Sci. and Technology (ND2007), Nice, France, April 22-27, 200

Residual nuclide formation in 206,207,208,nat-Pb and 209-Bi induced by 0.04-2.6 GeV Protons as well as in 56-Fe induced by 0.3-2.6 GeV Protons

5972 independent and cumulative yields of radioactive residuals nuclei have been measured in 55 thin 206,207,208,nat-Pb and 209-Bi targets irradiated by 0.04, 0.07, 0.10, 0.15, 0.25, 0.6, 0.8, 1.2, 1.4, 1.6, and 2.6 GeV protons. Besides, 219 yields have been measured in 0.3, 0.5, 0.75, 1.0, 1.5, and 2.6 GeV proton-irradiated 56-Fe target. The protons were extracted from the ITEP U-10 synchrotron. The measured data are compared with experimental results obtained elsewhere and with theoretical calculations by LAHET, MCNPX, CEM03, LAQGSM03, CASCADE, CASCADO, and LAHETO codes. The predictive power was found to be different for each of the codes tested, but was satisfactory on the whole in the case of spallation products. At the same time, none of the codes can de-scribe well the product yields throughout the whole product mass range, and all codes must be further improved.Comment: 4 pages, 4 figures, 2 tables, only pdf file, to be published in Proc. Int. Conf. on Nucl. Data for Sci. and Technology (ND2007), Nice, France, April 22-27, 20

Verification of high-energy transport codes on the basis of activation data

Nuclide production cross sections measured at ITEP for the targets of nat-Cr, 56-Fe, nat-Ni, 93-Nb, 181-Ta, nat-W, nat-Pb, 209-Bi irradiated by protons with energies from 40 to 2600 MeV were used to estimate the predictive accuracy of several popular high-energy transport codes. A general agreement of the ITEP data with the data obtained by other groups, including the numerous GSI data measured by the inverse kinematics method was found. Simulations of the measured data were performed with the MCNPX (Bertini and ISABEL options), CEM03.02, INCL4.2+ABLA, INCL4.5+ABLA07, PHITS, and CASCADE.07 codes. Deviation factors between the calculated and experimental cross sections have been estimated for each target and for the whole energy range covered by our measurements. Two-dimensional diagrams of deviation factor values were produced for estimating the predictive power of every code for intermediate, not measured masses of nuclei-targets and bombarding energies of protons. Further improvements of all tested here codes are recommended. In addition, new measurements at ITEP of nuclide yields from a 208-Pb target irradiated by 500 MeV protons are presented. A good agreement between these new data and the GSI measurements obtained by the inverse kinematics method was foundComment: 31 pages, 18 figures, 6 tables, only pdf, LANL Report LA-UR-11-02704, Los Alamos (2011), submitted to Phys. Rev.

Peculiarities of phonon spectra and lattice heat capacity in Ir and Rh

A simple pseudopotential model is proposed, which allows the phonon spectra and temperature dependence of the lattice heat capacity of Ir and Rh be described with a high enough accuracy. A careful comparison of the calculated and experimental values of the lattice heat capacity is carried out, with the procedure of the identification of the phonon contribution to the heat capacity and determination of the characteristics (momenta) of the phonon density of states from the experimental values of the total heat capacity of metal at a constant pressure being described in detail. The results of the theoretical calculations explain, in particular, such peculiar feature of Ir and Rh, unusual for cubic metals, as a sharp (more than by a factor of 1.5) decrease in the effective Debye temperature with increasing termperature. The temperature dependence of the mean square amplitude of atomic displacements in Ir and Rh has been calculated. Basing on the band calculations the manifestation of the Kohn singularities in the phonon spectra of Ir are discussed.Comment: 15 pages, LaTeX2e, 12 figures in postscrip