Dielectric Properties of Glass Beads with Talc as a Reference Material for Calibration and Verification of Dielectric Methods and Devices for Measuring Soil Moisture

This paper presents dielectric measurements of talc, glass beads, and their mixtures under different moisture and salinity levels. The measurements were conducted using a prototype seven-rod probe (15 mm long central rod) connected to a single port of vector network analyzer. The samples were moistened with distilled water and KCl solutions in order to obtain six different moisture content levels. The complex dielectric permittivity was determined from vector network analyzer reflection-coefficient measurements based on the open-water-liquid calibration procedure. Next, the fitting of volumetric water content–real part of dielectric permittivity calibration curves was performed for each material at selected frequencies, and the obtained relations were compared with well-known calibration equations. Additionally, a salinity index for the tested materials was calculated. It was concluded that pure talc is not an optimal material for the calibration and verification of dielectric methods. The calibration curves obtained for glass beads and the mixtures of glass beads with talc gave results close to well-known reference calibration functions. Additionally, the addition of talc caused the data points to be less scattered. Moreover, the values of the salinity index for the tested materials were in a good agreement with literature data for sand. The obtained results indicated that glass beads with the addition of talc can be used as a reference material for the calibration and verification of dielectric methods and devices for soil moisture measurement

Restoration of soils contaminated with PAHs by the mixture of zeolite composites mixed with exogenous organic matter and mineral salts

Abstract The major cause of soil degradation (contamination, erosion, compaction) is closely linked to agriculture, i.e., unsustainable agriculture practices, which are reflected in the depletion of the soil organic carbon pool, loss in soil biodiversity, and reduction of C sink capacity in soils. Therefore, the agricultural practice of applying carbon-rich materials into the soil is an attractive solution for climate change mitigation and soil ecosystem sustainability. The paper aimed to evaluate the effectiveness of the addition of organic-mineral mixtures to the mineral salts (NPK), including the exogenous organic matter (lignite) mixed with zeolite-carbon (NaX-C) or zeolite-vermiculite (NaX-Ver) composites in the restoration of soils contaminated with PAHs. The addition of zeolite composites to fertilizer resulted in a significant reduction in soil PAH levels and a corresponding reduction in plant tissue content, without compromising yields, compared to the control and separate application of NPK. A Significant correlation between PAHs and pHH2O, pHKCl, EC and dehydrogenase activity (DhA) was found in soils. The addition of zeolite composites with lignite significantly reduced the content of PAHs in straws, especially following the application of NaX-C. However, in the case of grains, the highest percentage reduction in comparison to NPK was observed for the highest dose of NaX-Ver

Soil Dielectric-Spectrum Characterization Based on One-Port VNA Measurement System

The output of soil moisture and salinity dielectric sensors may significantly depend on soil [...

A Seven-Rod Dielectric Sensor for Determination of Soil Moisture in Well-Defined Sample Volumes

This paper presents a novel seven-rod sensor used for time-domain reflectometry (TDR) and frequency-domain reflectometry (FDR) measurements of soil water content in a well-defined sample volume. The probe directly measures the complex dielectric permittivity spectrum and for this purpose requires three calibration media: air, water, and ethanol. Firstly, electromagnetic simulations were used to study the influence of the diameter of a container on the sensitivity zone of the probe with respect to the measured calibration media and isopropanol as a verification liquid. Next, the probe was tested in three soils—sandy loam and two silt loams—with six water contents from air-dry to saturation. The conversion from S 11 parameters to complex dielectric permittivity from vector network analyzer (VNA) measurements was obtained using an open-ended liquid procedure. The simulation and measurement results for the real part of the isopropanol dielectric permittivity obtained from four containers with different diameters were in good agreement with literature data up to 200 MHz. The real part of the dielectric permittivity was extracted and related to the moisture of the tested soil samples. Relations between the volumetric water content and the real part of the dielectric permittivity (by FDR) and apparent dielectric permittivity (by TDR) were compared with Topp’s equation. It was concluded that the best fit to Topp’s equation was observed in the case of a sandy loam. Data calculated according to the equation proposed by Malicki, Plagge, and Roth gave results closer to Topp’s calibration. The obtained results indicated that the seven-rod probe can be used to accurately measure of the dielectric permittivity spectrum in a well-defined sample volume of about 8 cm3 in the frequency range from 20 MHz to 200 MHz

Novel TDT Sensor for Soil Moisture Profile Probe

The aim of the work was to experimentally determine the sensitivity and resolution of a single sensor installed in a profile probe for moisture measurement at various soil profile depths. [...

Impact of soil salinity, texture and measurement frequency on the relations between soil moisture and 20 MHz–3 GHz dielectric permittivity spectrum for soils of medium texture

International audienc