Static pressure correction in high Reynolds number fully developed turbulent pipe flow

Measurements are reported of the error in wall static pressure reading due to the finite size of the pressure tapping. The experiments were performed in incompressible turbulent pipe flow over a wide range of Reynolds numbers, and the results indicate that the correction term (as a fraction of the wall stress) continues to increase as the hole Reynolds number $d^+=u_\tau d/\nu$ increases, contrary to previous studies. For small holes relative to the pipe diameter the results follow a single curve, but for larger holes the data diverge from this universal behaviour at a point that depends on the ratio of the hole diameter to the pipe diameter

Turbulence modeling in shock wave/turbulent boundary layer interactions

The research performed was an experimental program to help develop turbulence models for shock wave boundary layer interactions. The measurements were taken in a Mach 3, 16 deg compression corner interaction, at a unit Reynolds number of 63 x 10(exp 6)/m. The data consisted of heat transfer data taken upstream and downstream of the interaction, hot wire measurements of the instantaneous temperature and velocity fluctuations to verify the Strong Reynolds Analogy, and single- and double-pulsed Rayleigh scattering images to study the development of the instantaneous shock/turbulence interaction

The dynamics and control of fluctuating pressure loads in the reattachment region of a supersonic free shear layer

The primary aim is to investigate the mechanisms which cause the unsteady wall-pressure fluctuations in shock wave turbulent shear layer interactions. The secondary aim is to find means to reduce the magnitude of the fluctuating pressure loads by controlling the unsteady shock motion. The particular flow proposed for study is the unsteady shock wave interaction formed in the reattachment zone of a separated supersonic flow. Similar flows are encountered in many practical situations, and they are associated with high levels of fluctuating wall pressure. Wall pressure fluctuations were measured in the reattachment region of the supersonic free shear layer. The free shear layer was formed by the separation of a Mach 2.9 turbulent boundary layer from a backward facing step. Reattachment occurred on a 20 deg ramp. By adjusting the position of the ramp, the base pressure was set equal to the freestream pressure, and the free shear layer formed in the absence of a separation shock. An array of flush-mounted, miniature, high-frequency pressure transducers was used to make multichannel measurements of the fluctuating wall pressure in the vicinity of the reattachment region. Contrary to previous observations of this flow, the reattachment region was found to be highly unsteady, and the pressure fluctuations were found to be significant. The overall behavior of the wall pressure loading is similar in scale and magnitude to the unsteadiness of the wall pressure field in compression ramp flows at the same Mach number. Rayleigh scattering was used to visualize the instantaneous shock structure in the streamwise and spanwise direction. Spanwise wrinkles on the order of half the boundary layer thickness were observed

Adaptation of WASH Services Delivery to Climate Change and Other Sources of Risk and Uncertainty

This report urges WASH sector practitioners to take more seriously the threat of climate change and the consequences it could have on their work. By considering climate change within a risk and uncertainty framework, the field can use the multitude of approaches laid out here to adequately protect itself against a range of direct and indirect impacts. Eleven methods and tools for this specific type of risk management are described, including practical advice on how to implement them successfully

A new friction factor relationship for fully developed pipe flow

The friction factor relationship for high-Reynolds-number fully developed turbulent pipe flow is investigated using two sets of data from the Princeton Superpipe in the range 31×10^3 ≤ ReD ≤ 35×10^6. The constants of Prandtl’s ‘universal’ friction factor relationship are shown to be accurate over only a limited Reynolds-number range and unsuitable for extrapolation to high Reynolds numbers. New constants, based on a logarithmic overlap in the mean velocity, are found to represent the high-Reynolds-number data to within 0.5%, and yield a value for the von Kármán constant that is consistent with the mean velocity profiles themselves. The use of a generalized logarithmic law in the mean velocity is also examined. A general friction factor relationship is proposed that predicts all the data to within 1.4% and agrees with the Blasius relationship for low Reynolds numbers to within 2.0%

Non-equilibrium noise in the (non-)Abelian fractional quantum Hall effect

We analyse the noise of the edge current of a generic fractional quantum Hall state in a tunnelling point contact system. We show that the non-symmetrized noise in the edge current for the system out-of-equilibrium is completely determined by the noise in the tunnelling current and the Nyquist-Johnson (equilibrium) noise of the edge current. Simply put, the noise in the tunnelling current does not simply add up the equilibrium noise of the edge current. A correction term arises associated with the correlation between the tunnelling current and the edge current. We show, using a non-equilibrium Ward identity, that this correction term is determined by the anti-symmetric part of the noise in the tunnelling current. This leads to a non-equilibrium fluctuation-dissipation theorem and related expressions for the excess and shot noise of the noise in the edge current. Our approach makes use of simple properties of the edge, such as charge conservation and chirality, and applies to generic constructions of the edge theory which includes edges of non-Abelian states and edges with multiple charged channels. Two important tools we make use of are the non-equilibrium Kubo formula and the non-equilibrium Ward identity. We discuss these identities in the appendix.Comment: 20 pages, 5 figure

Reynolds number dependence of streamwise velocity spectra in turbulent pipe flow

Spectra of the streamwise velocity component in fully developed turbulent pipe flow are presented for Reynolds numbers up to 5.7×10^6. Even at the highest Reynolds number, streamwise velocity spectra exhibit incomplete similarity only: while spectra collapse with both classical inner and outer scaling for limited ranges of wave number, these ranges do not overlap. Thus similarity may not be described as complete, and a region varying with the inverse of the streamwise wave number, k1, is not expected, and any apparent k1-1 range does not attract any special significance and does not involve a universal constant. Reasons for this are suggested

Study of the structure of turbulent shear flows at supersonic speeds and high Reynolds number

A major effort to improve the accuracies of turbulence measurement techniques is described including the development and testing of constant temperature hot-wire anemometers which automatically compensate for frequency responses. Calibration and data acquisition techniques for normal and inclined wires operated in the constant temperature mode, flow geometries, and physical models to explain the observed behavior of flows are discussed, as well as cooperation with computational groups in the calculation of compression corner flows