Correlation, evaluation, and extension of linearized theories for tire motion and wheel shimmy

An evaluation is made of the existing theories of a linearized tire motion and wheel shimmy. It is demonstrated that most of the previously published theories represent varying degrees of approximation to a summary theory developed in this report which is a minor modification of the basic theory of Von Schlippe and Dietrich. In most cases where strong differences exist between the previously published theories and summary theory, the previously published theories are shown to possess certain deficiencies. A series of systematic approximations to the summary theory is developed for the treatment of problems too simple to merit the use of the complete summary theory, and procedures are discussed for applying the summary theory and its systematic approximations to the shimmy of more complex landing-gear structures than have previously been considered. Comparisons of the existing experimental data with the predictions of the summary theory and the systematic approximations provide a fair substantiation of the more detailed approximate theories

A theoretical and experimental investigation of the effects of yaw on pressures, forces, and moments during seaplane landings and planing

A theory for the side force, rolling moment, yawing moment, and pressure distribution during yawed landings and planing of seaplanes was developed. For the special case of the straight-sided wedge without chine immersion, the results of the theoretical analysis are presented in the form of generalized curves covering all step landing conditions. Experimental impact and planing data are presented for a prismatic wedge having an angle of dead rise of 22.5 degrees and are shown to be in reasonable agreement with the theoretical predictions

Determine Liming Needs on Tobacco Land This Fall

There have been far too many reports of manganese toxicity in tobacco this season for a condition which is so easily corrected. Manganese is one of the minor elements necessary for plant growth, but it is needed in very small amounts. When large amounts are taken up by a tobacco plant, light green or yellowish areas appear between the larger veins of the leaf. In severe cases the plant may be stunted or even die

Comparison of Water-Load Distributions Obtained during Seaplane Landings with Bureau of Aeronautics Specifications. TED No. NACA 2413

Bureau of Aeronautics Design Specifications SS-IC-2 for water loads in sheltered water are compared with experimental water loads obtained during a full--scale landing investigation. This investigation was conducted with a JRS-1 flying boat which has a 20 degrees dead-rise V-bottom with a partial chine flare. The range of landing conditions included airspeeds between 88 and 126 feet per second, sinking speeds between 1.6 and 9.1 feet per second, flight angles less than 6 degrees, and trims between 2 degrees and 12 degrees. Landings were moderate and were made in calm water. Measurements were obtained of maximum over-all loads, maximum pitching moments, and pressure distributions. Maximum experimental loads include over-all load factors of 2g, moments of 128,000 pound-feet, and maximum local pressures greater than 40 pounds per square inch. Experimental over-all loads are approximately one-half the design values, while local pressures are of the same order as or larger than pressures calculated from specifications for plating, stringer, floor, and frame design. The value of this comparison is limited, to some extent, by the moderate conditions of the test and by the necessary simplifying assumptions used in comparing the specifications with the experimental loads