15 research outputs found
Open sodium channel properties of single canine cardiac Purkinje cells.
Open channel properties of canine cardiac Purkinje cell Na+ channels were studied with single channel cell-attached recording and with whole cell macroscopic current recording in internally perfused cells. Single channel currents and membrane currents increased with an increase in Na+ concentration, but showed evidence of saturation. Assuming first-order binding, the Km for Na+ was 370 mM. PCs/PNa was 0.020 and PK/PNa was 0.094. The current-voltage relationship for single channels showed prominent flattening in the hyperpolarizing direction. This flattening was accentuated by 10 mM Ca2+ and was greatly reduced in O mM Ca2+, indicating that the rectification was a consequence of Ca2+ block of the Na+ channels. A similar instantaneous current-voltage relationship was seen for the whole cell membrane currents. These results demonstrate that the cardiac channel shows substantial Ca2+ block, although it is relatively insensitive to tetrodotoxin. The Na+ and Ca2+ binding properties could be modeled by the four-barrier Eyring rate theory model, with similar values to those reported for the neuroblastoma Na+ channel (Yamamoto, D.,J.Z. Yeh, and T. Narahashi, 1984, Biophys J., 45:337-344)
Use of the Gabor Filter for Edge Detection in the Analysis of Zinc Oxide Nanowire Images
Waste Citrus reticulata Assisted Preparation of Cobalt Oxide Nanoparticles for Supercapacitors
The green, sustainable, and inexpensive creation of novel materials, primarily nanoparticles, with effective energy-storing properties, is key to addressing both the rising demand for energy storage and the mounting environmental concerns throughout the world. Here, an orange peel extract is used to make cobalt oxide nanoparticles from cobalt nitrate hexahydrate. The orange peel extract has Citrus reticulata, which is a key biological component that acts as a ligand and a reducing agent during the formation of nanoparticles. Additionally, the same nanoparticles were also obtained from various precursors for phase and electrochemical behavior comparisons. The prepared Co-nanoparticles were also sulfurized and phosphorized to enhance the electrochemical properties. The synthesized samples were characterized using scanning electron microscopic and X-ray diffraction techniques. The cobalt oxide nanoparticle showed a specific capacitance of 90 F/g at 1 A/g, whereas the cobalt sulfide and phosphide samples delivered an improved specific capacitance of 98 F/g and 185 F/g at 1 A/g. The phosphide-based nanoparticles offer more than 85% capacitance retention after 5000 cycles. This study offers a green strategy to prepare nanostructured materials for energy applications
Recommended from our members
Determination of critical cooling rates in metallic glass forming alloy libraries through laser spike annealing
The glass forming ability (GFA) of metallic glasses (MGs) is quantified by the critical cooling rate (R C). Despite its key role in MG research, experimental challenges have limited measured R C to a minute fraction of known glass formers. We present a combinatorial approach to directly measure R C for large compositional ranges. This is realized through the use of compositionally-graded alloy libraries, which were photo-thermally heated by scanning laser spike annealing of an absorbing layer, then melted and cooled at various rates. Coupled with X-ray diffraction mapping, GFA is determined from direct R C measurements. We exemplify this technique for the Au-Cu-Si system, where we identify Au56Cu27Si17 as the alloy with the highest GFA. In general, this method enables measurements of R C over large compositional areas, which is powerful for materials discovery and, when correlating with chemistry and other properties, for a deeper understanding of MG formation
Studies of reduced graphene oxide (rGO)/CuS nanocomposite for supercapacitor applications
We have prepared CuS and CuS-rGO nanocomposites via the hydrothermal method. The physical properties of the synthesized materials were studied through x-ray diffraction and scanning electron microscopy. The supercapacitor characteristics were evaluated by cyclic voltammetric and galvanostatic charge–discharge studies. The cyclic voltammetric studies conform the pseudocapacitive nature of CuS and CuS-rGO electrodes. The specific capacitance of CuS was obtained as 207, 150, and 97 F/g at a current density of 0.5, 5, and 20 A/g, respectively. The rGO-CuS nanocomposite showed improved specific capacitance of 350, 251, and 149 F/g at current densities of 0.5, 5, and 20 A/g, respectively