2 research outputs found
The CT-Based Patient Specific Hip Joint 3D-Modeling; Potential to Correct the Alignment
Background: The salvage proximal femoral osteotomy is performed in mild or moderate osteoarthritis when the articulating surfaces are normal and relieves the subject’s pain. Because the importance of angular mal-alignment of the femur bone at the hip junction accurate pre-op planning based on patient specific anatomy is required to prevent any lower limb misalignment and joint problem pre-operative.Methods: In this study a CT-Based modeling technique was used to generate a 3D model of the patient’s hip and proximal femur. The registration stage using angio-fluoroscopy was performed to calculate the proximal femur kinematic and input it into a finite element model to achieve the stress distribution pattern of femuroacetabular joint.Results:From finite element model the stress distribution on the articulating surface at the contact zone was analyzed. The result was showing the maximum stress of 1.1 MPa at the contact surface where femur contact the acetabulum. The maximum stress is found in line with mechanical loading of the lower limb.Conclusion: Use of a non-invasive 3D modeling method will remediate the surgical approach in pre-op stage. The in-vivo modeling and assessment of the patient femoroacetabular contact has performed. It has been shown that the accuracy of the proposed model is comparable with the existing surgical pre-op planning
The Spine Vertebral Bodies 3D Modeling and its Biomechanical Advantages
To perform an accurate approach to the spine specially for fracture stabilization a 3D model of spine surgical region may improve this mechanism and it can help the surgeon to have a deeper glance to this scenario. The pre-op planning facility is another advantage of the patient spine specific model to take a chance of making guides to direct pedicle screws safely and increase the pathomechanics of volumes of interest stability factor parallel with its mobility restoration. There are some algorithms for making 3D-reconstruction from CT or MR data-set but the main goal of in-vivo component 3D making is right component extraction from its peripheral segments to achieve the best judgment especially about the surgical approach. Here is a cervical vertebral bodies segmentation and 3D-reconstruction of two cervical adjacent levels combined with the registration process that is shown the intervertebral degree regarding to range of motion percent