7 research outputs found
Impact of storage time on characteristics of synthetic greywater for two different pollutant strengths to be treated or recycled
Storage of greywater is controversial for environmental and health reasons. Artificial greywater was assessed after 2 and 7 days of storage time. Two different greywater pollutant strengths were statistically compared at each storage time. A negative significant (p < 0.05) correlation was evident with increasing storage time for the 5-day biochemical oxygen demand for more than 2 days. However, the concentrations of 5-day biochemical oxygen and chemical oxygen demands reduced significantly at 2 days of storage when compared with freshly prepared greywater. Biodegradability (5-day biochemical oxygen demand/chemical oxygen demand ratio) decreased significantly after storage to between 0.14 and 0.39. The nitrification process was improved significantly with increasing storage time concerning low strength greywater with a significant increase in the removal of ammonia-nitrogen and a non-significant decrease in the removal of nitrate-nitrogen. The correlation was significantly positive between ammonia-nitrogen and 5-day biochemical oxygen demand for stored greywater, while it was significantly negative between total suspended solids and both 5-day biochemical oxygen demand and dissolved oxygen. Significant reductions in colour, total suspended solids and turbidity were correlated positively with storage time. Precipitation of dissolved metals was suspected to occur in storing greywater by binding the inorganic components with the sediment and collide surfaces through adsorption, allowing a significant drop in concentrations of dissolved and undissolved metals with increasing storage time through sedimentation. Synthetic greywater of low mineral pollution had significantly higher removals for almost all concentrations compared with those for high concentrations. More advanced technologies for high trace element removal are required
Biochemical performance modelling of non-vegetated and vegetated vertical subsurface-flow constructed wetlands treating municipal wastewater in hot and dry climate
Wastewater treatment and subsequent effluent recycling for non-drinking purposes such as irrigation contributes to the mitigation of the pressure on freshwater resources. In this study, two vertical sub-surface flow constructed wetland (VSSF-CW) pilot plants were operated to treat municipal wastewater and their effluents were reused for irrigation purposes. One of the wetlands was vegetated with Phragmites australis (Cav.) Trin. ex Steud. (common reed) to compare its efficiency of pollutant removals with the non-vegetated system, which had the same design. COMSOL Multiphysics 3.5a was operated for the Activated Sludge Model 2 (ASM2) to predict the chemical oxygen demand (COD) and ammonia-nitrogen (NH4-N) concentrations. The effluent quality of both treatment systems was assessed for several parameters. Computer simulations show a good compliance between the measured and predicted values of COD and NH4-N for the vegetated system. The calibrated model could be effectively used to predict the behaviours of those parameters as a function of time. Moreover, the effluents of both vegetated (VFp) and non-vegetated (VF) VSSF-CW were significantly (p <  0.05) improved compared to influent. Significant (p <  0.05) effects due to the presence of P. australis were observed for removals of total suspended solids (TSS), 5-day biochemical oxygen demand (BOD5), COD, NH4-N and ortho-phosphate-phosphorus (PO4-P). However, significant increases (p <  0.05) were noted for electrical conductivity (EC), total dissolved solids (TDS), nitrate-nitrogen (NO3-N) and sulphate (SO4) of both effluents compared to the raw wastewater. Except for EC, NH4-N and SO4, all water quality parameters complied with irrigation water standards
Wetlands for wastewater treatment and subsequent recycling of treated effluent : a review
Due to water scarcity challenges around the world, it is essential to think about non-conventional water resources to address the increased demand in clean freshwater. Environmental and public health problems may result from insufficient provision of sanitation and wastewater disposal facilities. Because of this, wastewater treatment and recycling methods will be vital to provide sufficient freshwater in the coming decades, since water resources are limited and more than 70% of water are consumed for irrigation purposes. Therefore, the application of treated wastewater for agricultural irrigation has much potential, especially when incorporating the reuse of nutrients like nitrogen and phosphorous, which are essential for plant production. Among the current treatment technologies applied in urban wastewater reuse for irrigation, wetlands were concluded to be the one of the most suitable ones in terms of pollutant removal and have advantages due to both low maintenance costs and required energy. Wetland behavior and efficiency concerning wastewater treatment is mainly linked to macrophyte composition, substrate, hydrology, surface loading rate, influent feeding mode, microorganism availability, and temperature. Constructed wetlands are very effective in removing organics and suspended solids, whereas the removal of nitrogen is relatively low, but could be improved by using a combination of various types of constructed wetlands meeting the irrigation reuse standards. The removal of phosphorus is usually low, unless special media with high sorption capacity are used. Pathogen removal from wetland effluent to meet irrigation reuse standards is a challenge unless supplementary lagoons or hybrid wetland systems are used
Treatment of contaminated greywater using pelletised mine water sludge
Precipitated sludge (ochre) obtained from a mine water treatment plant was considered as an adsorbent substance for pollutants, since ochre is relatively free from problematic levels of toxic elements, which could impair on the quality of water to be treated. Artificially created ochre pellets from mixing Portland cement with raw ochre sludge were utilised to remediate either high (HC) or low (LC) contaminated synthetic greywater (SGW) in mesocosm–scale stabilisation ponds at 2–day and 7–day contact times under real weather conditions in Salford. After a specific retention time, treated SGW was agitated before sampling to evaluate pollutant removal mechanisms (other than sedimentation) such as adsorption by ochre pellets, before replacing the treated water with new inflow SGW. The results showed that cement–ochre pellets have a high ability to adsorb ortho–phosphate–phosphorous (PO4–P) significantly (p < 0.05) by 70.7% and 56.0% at 7–day contact time for HC–SGW and LC–SGW, respectively. After the experiment, an analysis revealed that elements such as boron (B), cadmium (Cd), magnesium (Mg), manganese (Mn), nickel (Ni) and zinc (Zn) accumulated significantly (p < 0.05) within the ochre pellets. The notable accumulation of Cd within ochre pellets reflects the significant (p < 0.05) remediation of greywater during the first 35 and 20 successive times of treatment for HC–SGW at 2– and 7–day contact times, respectively. Cadmium was still adsorbed significantly (p < 0.05) during the treatment of LC–SGW. However, the calcium (Ca) content decreased significantly (p < 0.05) within ochre pellets treating both types of greywaters due to mobilisation. The corresponding increases of Ca in greywater were significant (p < 0.05)