Impact of water vapor on 1.51 μm ammonia absorption features used in trace gas sensing applications

Water-vapor-induced pressure broadening is reported for two NH3 absorption features at 6612.7 and 6596.4cm−1 that are exploitable for gas sensing applications at atmospheric pressure. Absorption spectra of different NH3-H2O-N2 mixtures were measured at an elevated temperature of 70°C to enable high H2O concentrations to be reached. Line parameters were determined from a fitting procedure. The significantly greater values obtained for the H2O-broadening coefficients of the two lines compared to N2-broadening leads to cross-sensitivity effects in NH3 trace gas sensors based on spectroscopic techniques that are sensitive to the width of the analyzed absorption line, as is the case in a simple implementation of wavelength modulation spectroscopy or in photoacoustic spectroscopy. In such a case, cross-sensitivity results in inaccurate gas concentration retrieval when the composition of the diluting gas changes. H2O represents a potentially significant cross-sensitivity source as its concentration may be subject to large variations, especially in high-temperature applications where concentrations up to a couple of tens of percent may be encountered. In contrast to interference which can be minimized by an appropriate choice of the analyzed transitions, cross-sensitivity affects the entire spectrum of the analyte and is thus unavoidable in the mentioned type of gas sensor

Self-mixing interference effects in tunable diode laser absorption spectroscopy

We report the effects of self-mixing interference on gas detection using tunable diode laser spectroscopy. For very weak feedback, the laser diode output intensity gains a sinusoidal modulation analogous to that caused by low finesse etalons in the optical path. Our experiments show that self-mixing interference can arise from both specular reflections (e.g. cell windows) and diffuse reflections (e.g. Spectralon™ and retroreflective tape), potentially in a wider range of circumstances than etalon-induced interference. The form and magnitude of the modulation is shown to agree with theory. We have quantified the effect of these spurious signals on methane detection using wavelength modulation spectroscopy and discuss the implications for real gas detecto

Molecular relaxation effects in hydrogen chloride photoacoustic detection

A photoacoustic (PA) sensor has been developed to monitor hydrogen chloride at sub-ppm level in the 1740-nm region. The system was designed to control the process in the novel low-water-peak optical fiber manufacturing process. Relaxation effects in hydrogen chloride PA detection in oxygen-helium and nitrogen-helium gas mixtures are presented, showing that the generation of the PA signal is strongly affected by the ratio of these substances. In addition, the role of water vapor in the PA signal is investigate

Near-infrared laser photoacoustic detection of methane: the impact of molecular relaxation

A photoacoustic sensor has been developed for trace-gas monitoring using a near-infrared semiconductor laser emitting in the 2ν3 band of methane at 1.65μm. The apparatus was designed for on-line process control in the manufacturing of the novel low-water-peak fibres developed for optical telecommunications. The importance of collisional relaxation processes in the generation of the photoacoustic signal is reported in the particular case of CH4 detection in dry O2 and O2-N2 mixtures. The negative influence of these effects results in a strongly reduced and phase-shifted photoacoustic signal, induced by a fast resonant coupling between the vibrational states of methane and oxygen, associated with the slow relaxation of the excited oxygen molecules. An unusual parabolic response of the sensor with respect to the methane concentration has been observed and is discussed. Finally, the beneficial effect of several species, including water vapour and helium, acting as a catalyst to hasten the relaxation of the CH4-O2 system, is demonstrate

Ammonia trace measurements at ppb level based on near-IR photoacoustic spectroscopy

A photoacoustic sensor using a laser diode emitting near 1532nm in combination with an erbium-doped fibre amplifier has been developed for ammonia trace gas analysis at atmospheric pressure. NH3 concentration measurements down to 6ppb and a noise-equivalent detection limit below 3ppb in dry air are demonstrated. Two wavelength-modulation schemes with 1f and 2f detection using a lock-in amplifier were investigated and compared to maximise the signal-to-noise ratio. A quantitative analysis of CO2 and H2O interference with NH3 is presented. Typical concentrations present in ambient air of 400ppm CO2 and 1.15% H2O (50% relative humidity at 20°C) result in a NH3 equivalent concentration of 36ppb and 100ppb, respectivel

Experimental method based on wavelength-modulation spectroscopy for the characterization of semiconductor lasers under direct modulation

An experimental method is presented for characterization of the combined intensity and frequency modulation produced when the injection current of a laser diode is modulated. The reported technique is based on the analysis of the harmonic signals produced when a modulated laser is used to probe a gas absorption line by the so-called wavelength-modulation spectroscopy method. Based on a theoretical model of this technique, we present two methods that facilitate the determination of (i) the deviation in laser frequency and (ii) the phase shift between intensity and frequency modulation. These methods are illustrated experimentally by measurement of the modulation parameters of a 2-μm distributed-feedback laser by use of a CO2 absorption line. The experimental results have been compared with those obtained with another traditional method and have shown full agreement in the frequency range (400 Hz-30 kHz) considere

Antibody capture radioimmunoassay for anti-rubella IgM

An M-antibody capture radioimmunoassay (MACRIA) for anti-rubella IgM was developed. Under optimum conditions positive serum specimens bound up to 20 times as much radioactivity as negative specimens. Positive reactions were expressed in arbitrary units/ml by comparison with a calibration curve derived from results obtained with dilutions of a standard serum. The specificity of the assay was confirmed by testing IgM and IgG rich fractions of positive sera. One hundred and forty specimens from blood donors, patients whose sera contained rheumatoid factor and patients with acute, non-rubella, virus infections were tested by MACRIA. No significant non-specific reactions were detected. Paired sera from acute rubella (25 patients) and individual sera from suspected rubella (69 patients) were tested for anti-rubella IgM by MACRIA and by haemagglutination inhibition following sucrose-density-gradient fractionation. There was close agreement between the two methods. The capture assay was more sensitive and could be used to detect the weak IgM response in women given RA 27/3 vaccine. After the natural infection, the MACRIA was strongly positive for two months and remained weakly so for a further two months. Repeat testing of sera demonstrated good reproducibility of the assay. MACRIA proved a simple, sensitive and specific test for anti-rubella IgM and compared favourably with currently used technique