Direct Extraction of Platinum Nanoparticles from Fuel Cells with Ionic Liquids: Part 2. Impact of the Nafion Ionomer Swelling

International audienc

Propeline: a green alternative to Ethaline for electrochemical recovery of precious metals

Ionometallurgy can be considered as an alternative to conventional hydrometallurgy for precious metals recovery, reducing process hazards and toxic waste production. More specifically, ionic solvents are of particular interest for electrometallurgy processes, since being intrinsically conductive and stable in a broad range of potentials.At the edge of ionic solvents, Deep Eutectic Solvents (DES) are better candidates than regular ionic liquids, being much less expensive and greener, since they are often partially bio-sourced and they exhibit a higher biodegradability, as for betaine, choline-based DES. We recently demonstrated that palladium (Pd) and gold (Au) can be quantitatively leached and recovered in a single electrochemical reactor using Ethaline, a DES composed of choline chloride (ChCl) as hydrogen bond acceptor and ethylene glycol (EG) as hydrogen bond donor, typically in a 1:2 molar ratio. However, if ChCl can be considered as a “green” reactant, this is not the case for EG. Comparable DES with a lower toxic nature than Ethaline can be obtained by replacing EG by other glycols e.g. propylene glycol (PG), widely used in cosmetics and pharmacology: the resulting DES with PG is Propeline. The present paper deals with the potential of this less known DES in the recovery of precious metals.Because the change in the hydrogen bond donor with PG leads to a modification of the DES bulk properties, the first part of this work deals with the determination of Propeline density, viscosity, conductivity and electrochemical stability, which are properties of interest for electrochemical processes. The influence of water content on these properties was thoroughly investigated. Values of the above property parameters are compared to those obtained with Ethaline as a reference DES. In a second part, we present the performances of Propeline for the selective electrochemical leaching of Ag, Pd and Au. The performance of Propeline in leaching was evaluated in ambient atmosphere, i.e. in the presence of water at percent levels. Leaching efficiencies could be studied after thorough development of analytical procedures dedicated to elemental analysis e.g. ICP-EOS in DES. The speciation of leached metals was determined by use of cross-linked analysis, namely UV-vis, and EXAFS/XANES spectroscopic techniques, in both cases with comparison with those in Ethaline. Systems (leached metal species-DES) were then thoroughly studied by electrochemical methods. In particular, diffusion coefficients of the solvated metal species were determined by electrochemical transient and stationary techniques, in the aim of leached metal recovery by electrochemical deposition

Propeline: a green alternative to Ethaline for electrochemical recovery of precious metals

Ionometallurgy can be considered as an alternative to conventional hydrometallurgy for precious metals recovery, reducing process hazards and toxic waste production. More specifically, ionic solvents are of particular interest for electrometallurgy processes, since being intrinsically conductive and stable in a broad range of potentials.At the edge of ionic solvents, Deep Eutectic Solvents (DES) are better candidates than regular ionic liquids, being much less expensive and greener, since they are often partially bio-sourced and they exhibit a higher biodegradability, as for betaine, choline-based DES. We recently demonstrated that palladium (Pd) and gold (Au) can be quantitatively leached and recovered in a single electrochemical reactor using Ethaline, a DES composed of choline chloride (ChCl) as hydrogen bond acceptor and ethylene glycol (EG) as hydrogen bond donor, typically in a 1:2 molar ratio. However, if ChCl can be considered as a “green” reactant, this is not the case for EG. Comparable DES with a lower toxic nature than Ethaline can be obtained by replacing EG by other glycols e.g. propylene glycol (PG), widely used in cosmetics and pharmacology: the resulting DES with PG is Propeline. The present paper deals with the potential of this less known DES in the recovery of precious metals.Because the change in the hydrogen bond donor with PG leads to a modification of the DES bulk properties, the first part of this work deals with the determination of Propeline density, viscosity, conductivity and electrochemical stability, which are properties of interest for electrochemical processes. The influence of water content on these properties was thoroughly investigated. Values of the above property parameters are compared to those obtained with Ethaline as a reference DES. In a second part, we present the performances of Propeline for the selective electrochemical leaching of Ag, Pd and Au. The performance of Propeline in leaching was evaluated in ambient atmosphere, i.e. in the presence of water at percent levels. Leaching efficiencies could be studied after thorough development of analytical procedures dedicated to elemental analysis e.g. ICP-EOS in DES. The speciation of leached metals was determined by use of cross-linked analysis, namely UV-vis, and EXAFS/XANES spectroscopic techniques, in both cases with comparison with those in Ethaline. Systems (leached metal species-DES) were then thoroughly studied by electrochemical methods. In particular, diffusion coefficients of the solvated metal species were determined by electrochemical transient and stationary techniques, in the aim of leached metal recovery by electrochemical deposition

Dynamic Recrystallization During High-Strain-Rate Tension of Copper

Discontinuous dynamic recrystallization can occur during dynamic tensile extrusion of copper, which is subjected to uniaxial tensile strains of ~5 and strain rates up to 10^6 s^-1 in the extruded section. Through high-resolution transmission Kikuchi diffraction, we show that nucleation occurs through subgrain rotation and grain boundary bulging at boundaries between and oriented grains. The observed nuclei consist of subgrains with a size of approximately 200 to 400 nm

Local structure and photocatalytic property of sol-gel synthesized ZnO doped with transition metal oxides

ZnO nanoparticles doped with up to 5 at% of Co and Mn were prepared using a co-precipitation method. The location of dopant ions and the effect of doping on the photocatalytic activity were investigated. The crystal structure of nanoparticles and local atomic arrangements around dopant ions were analyzed by X-ray absorption spectroscopy. The results showed that the Co ions substituted the Zn ions in the ZnO wurtzite phase structure and induced lattice shrinkage, while Mn ions were not completely incorporated in the crystal lattice. The photocatalytic activity under simulated sunlight was characterized by the decomposition of Rhodamine B dye molecules. It was revealed that Co-doping strongly reduced the photocatalytic activity but Mn-doping showed a weaker effect on the reduction of the photoactivity.<br /