Spiral and Interlocking Grain in Eucalyptus Dunnii

Spiral grain in 181 trees from a 9-year-old plantation-grown Eucalyptus dunnii was normally distributed with mean 0.33 degrees (to the left) and standard deviation 1.7 degrees, and was affected by family and by crown asymmetry. Interlocking grain was common, exhibiting a mean amplitude of 3.4 degrees (standard deviation 1.5 degrees) and a mean wavelength of 39 mm (standard deviation 12 mm). The relatively large amplitude of interlocking grain means that most trees will have spiral grain that alternates between left and right during each year. The wavelength of interlocking grain is influenced by tree size, but amplitude of interlocking is under genetic control. Both spiral grain and the amplitude of any interlocking were heritable (h2 = 0.99 and 0.63 respectively)

Temporal, spatial, and structural patterns of adult trembling aspen and white spruce mortality in Quebec's boreal forest

Temporal, spatial, and structural patterns of adult trembling aspen (Populus tremuloides Michx.) and white spruce (Picea glauca (Moench) Voss) mortality were studied in intact 150-year-old stands in the southwestern boreal forest of Quebec. For both species, mortality decreases (number of dead trees/total number of trees) with distance from the lake edge until 100-150 m, from which point it slightly increases. Strong peaks in mortality were found for 40- to 60-year-old aspen mainly between 1974 and 1992. Such mortality in relatively young aspen is likely related to competition for light from the dominant canopy trees. Also, the recruitment of this young aspen cohort is presumably the result of a stand breakup that occurred when the initial aspen-dominated stand was between 90 and 110 years old. For spruce, strong peaks in mortality were found in 110- to 150-year-old trees and they occurred mainly after 1980. No clear explanation could be found for these peaks, but we suggest that they may be related to senescence or weakening of the trees following the last spruce budworm outbreak. Suppressed and codominant aspen had a much higher mortality ratio than spruce in the same height class, while more surprisingly, no difference in mortality rate was found between dominant trees of the two species. Most spruce trees were found as standing dead, which leads us to reject the hypothesis that windthrow is an important cause of mortality for spruce in our forests

Finite element study of growth stress formation in wood and related distortion of sawn timber

Lack of straightness in timber is the most frequent complaint regarding solid (and laminated) timber products worldwide. Nowadays, customers demand higher quality in the shape stability of wood products than they did earlier. The final distortion of timber boards is mostly caused by moisture-related stresses in wood (drying distortions) and growth-related stresses (distortions appearing when logs are split up to timber boards by sawing). To get more knowledge on how these distortions can be reduced in wooden products, there is a need for improved understanding of this material behaviour through good numerical tools developed from empirical data. A three-dimensional finite element board distortion model developed by Ormarsson (Doctoral thesis, Publ. 99:7, 1999) has been extended to include the influence of growth stresses by incorporating a one-dimensional finite element growth stress model developed here. The growth stress model is formulated as an axisymmetric general plane strain model where material for all new annual rings is progressively added to the tree during the analysis. The simulation results presented include how stresses are progressively generated during the tree growth, distortions related to the redistribution of growth stresses during log sawing, and distortions and stresses in drying reflecting the effects of growth stresses. The results show that growth stresses clearly vary during tree growth and also form a large stress gradient from pith to bark. This in itself can result in significant bow and crook deformations when logs are sawn into timber boards. The distortion results from the simulations match well with the results observed in reality. The parametric study also showed that the radial growth stress distribution is highly influenced by parameters such as modulus of elasticity, micro fibril angle and maturation strain