Experimental study of the effects of flameholder geometry on emissions and performance of lean premixed combustors

Emissions of NOx, CO, and unburned hydrocarbons (UHC) are reported for a lean premixed propane-air system at inlet conditions of 800K and 1MPa using twelve flameholder designs. The flameholders tested represent six design concepts with two values of blockage for each concept. Data were obtained at reference velocities of 35 m/s, 25 m/s and 20 m/s at combustor stations 10 cm and 30 cm downstream of the flameholders. Flameholder pressure drop was found to be a principal determinant of emissions performance. Designs producing larger pressure drops also produced less NOx, CO, and UHC emissions. The lean stability limit equivalence ratio was found to be approximately 0.35 for all designs. Flashback velocities (axial components in the flameholder passages) varied between 30 m/s and 40 m/s. A perforated plate flameholder was operated with a velocity as low as 23 m/s through the perforations at equivalence ratio 0.7 without producing flashback

Experimental study of the effect of cycle pressure on lean combustion emissions

Experiments were conducted in which a stream of premixed propane and air was burned under conditions representative of gas turbine operation. Emissions of NOx, CO, and unburned hydrocarbons (UHC) were measured over a range of combustor inlet temperature, pressure, and residence time at equivalence ratios from 0.7 down to the lean stability limit. At an inlet temperature of 600 K, observed NOx levels dropped markedly with decreasing pressure for pressures below 20 atm. The NOx levels are proportional to combustor residence time and formation rates were principally a function of adiabatic flame temperature. For adiabatic flame temperatures of 2050 K and higher, CO reached chemical equilibrium within 2 msec. Unburned hydrocarbon species dropped to a negligible level within 2 msec regardless of inlet temperature, pressure, or equivalence ratio. For a combustor residence time of 2.5 msec, combustion inefficiency became less than 0.01% at an adiabatic flame temperature of 2050 K. The maximum combustion inefficiency observed was on the order of 1% and corresponded to conditions near the lean stability limit. Using a perforated plate flameholder, this limit is well represented by the condition of 1800 K adiabatic flame temperature

Testing of felt-ceramic materials for combustor applications

The feasibility of using composite felt ceramic materials as combustor liners was experimentally studied. The material consists of a porous felt pad sandwiched between a layer of ceramic and one of solid metal. Flat, rectangular test panels, which encompassed several design variations of the basic composite material, were tested, two at a time, in a premixed gas turbine combustor as sections of the combustor wall. Tests were conducted at combustor inlet conditions of 0.5 MPa and 533 K with a reference velocity of 25 m/s. The panels were subjected to a hot gas temperature of 2170 K with 1% of the total airflow used to film cool the ceramic surface of the test panel. In general, thin ceramic layers yield low ceramic stress levels with high felt ceramic interface temperatures. On the other hand, thick ceramic layers result in low felt ceramic interface temperatures but high ceramic stress levels. Extensive thermal cycling appears to cause material degradation, but for a limited number of cycles, the survivability of felt ceramic materials, even under extremely severe combustor operating conditions, was conclusively demonstrated

Experimental study of the effects of secondary air on the emissions and stability of a lean premixed combustor

Tests were run using a perforated plate flameholder with a relatively short attached recirculation zone and a vee gutter flameholder with a relatively long attached recirculation zone. Combustor streamlines were traced in cold flow tests at ambient pressure. The amount of secondary air entrainment in the recirculation zones of the flameholders was determined by tracer gas testing at cold flow ambient pressure conditions. Combustion tests were caried out at entrance conditions of 0.5 MPa/630K and emission of NOx, CO and unburned hydrocarbons were measured along with lean stability and flashback limits. The degree of entrainment increases as dilution air injection decreases. Flashback appears to be a function of overall equivalence ratio and resistance to flashback increases with increasing combustor entrance velocity. Lean stability limit appears to be a function of both primary zone and flameholder recirculation zone equivalence ratios and resistance to lean blowout increases with increasing combustor entrance velocity

Numerical program for analysis of three-dimensional supersonic exhaust flow fields (CHAR 3D)

Choice of reference plane orientation depends on specific nozzle geometry, with different configurations requiring different reference plane systems. In addition, for given configuration several reference systems may be used in different regions of flow field, so each system is locally aligned with flow

The SOS Pilot Study: a RCT of routine oxygen supplementation early after acute stroke—effect on recovery of neurological function at one week

Mild hypoxia is common after stroke and associated with poor long-term outcome. Oxygen supplementation could prevent hypoxia and improve recovery. A previous study of routine oxygen supplementation showed no significant benefit at 7 and 12 months. This pilot study reports the effects of routine oxygen supplementation for 72 hours on oxygen saturation and neurological outcomes at 1 week after a stroke

Land Used Mapping using Unmanned Aerial Vehicle (UAV) along Parit Rasipan Drainage System

Excess nutrients accelerate the growth of plants and algae in water sources, leading to environmental issues like flow retardation (flood), a decrease in the amount of oxygen in the water, and a decline in the quality of the water. Therefore, the goal of this study is to identify the quality Parit Rasipan drainage system's eutrophic level in terms of temperature, dissolved oxygen, pH, and turbidity; and to analyse an NDVI (Normalized Difference Vegetation Index) image taken by unmanned aerial vehicle (UAV) and using Agisoft photoscan software. As a result, four sampling locations—residential (S1), industrial (S2), agricultural (S3), and farming (S4)—have been chosen for water quality sampling and analysis along the Parit Rasipan drainage system. The HACH method was used to analyse water samples that have been obtained according to the Standard Methods for Water and Wastewater Examinations. It was found that agricultural zone was poor water quality compared residential, industrial and farming zones with measurements of 3.82 mg/L, 3.09, 25.57 °C, and 14.6 NTU, respectively, the agricultural zone has the highest values for the four metrics of dissolved oxygen, pH, temperature, and turbidity. This scenario could be due to the usage of the fertilizer to cultivate the oil palm contributed to Parit rasipan drainage system (S3) which resulted in a substantial amount of eutrophication. Hence, the use of UAVs and the agisoft photoscan programme has considerably improved the mapping of the water quality metrics and eutrophic level

Correcting non-independent and non-identically distributed errors with surface codes

A common approach to studying the performance of quantum error correcting codes is to assume independent and identically distributed single-qubit errors. However, the available experimental data shows that realistic errors in modern multi-qubit devices are typically neither independent nor identical across qubits. In this work, we develop and investigate the properties of topological surface codes adapted to a known noise structure by Clifford conjugations. We show that the surface code locally tailored to non-uniform single-qubit noise in conjunction with a scalable matching decoder yields an increase in error thresholds and exponential suppression of sub-threshold failure rates when compared to the standard surface code. Furthermore, we study the behaviour of the tailored surface code under local two-qubit noise and show the role that code degeneracy plays in correcting such noise. The proposed methods do not require additional overhead in terms of the number of qubits or gates and use a standard matching decoder, hence come at no extra cost compared to the standard surface-code error correction

Principles of practice parameters for the treatment of sleep disordered breathing in the elderly and frail elderly: the consensus of the International Geriatric Sleep Medicine Task Force

Sleep disordered breathing (SDB) is a leading cause of morbidity worldwide. Its prevalence increases with age. Due to the demographic changes in industrial societies, pulmonologists and sleep physicians are confronted with a rapidly growing number of elderly SDB patients. For many physicians, it remains unclear how current guidelines for SDB management apply to elderly and frail elderly patients. The goal of this consensus statement is to provide guidance based on published evidence for SDB treatment in this specific patient group. Clinicians and researchers with expertise in geriatric sleep medicine representing several countries were invited to participate in a task force. A literature search of PubMed from the past 12 years and a systematic review of evidence of studies deemed relevant was performed. Recommendations for treatment management of elderly and frail elderly SDB patients based on published evidence were formulated via discussion and consensus. In the last 12 years, there have been surprisingly few studies examining treatment of SDB in older adults and even fewer in frail older adults. Studies that have been conducted on the management of SDB in the older patient population were rarely stratified for age. Studies in SDB treatment that did include age stratification mainly focused on middle-aged and younger patient groups. Based on the evidence that is available, this consensus statement highlights the treatment forms that can be recommended for elderly SDB patients and encourages treatment of SDB in this large patient group