Spectre infrarouge des borosilicates cristallins et vitreux M1BSi2O6

peer reviewe

Influence of the shaping effect on hardness homogeneity by Vickers indentation analysis

In this study, indentation technique (Vickers indentation) has been unconventionally used to evaluate the homogeneity of barium zirconate ceramic samples which have been shaped through different routes. Statistical tools have been used to estimate the con-elation which can be established between heterogeneities within the samples and their shaping ways. (c) 2005 Elsevier Ltd. All rights reserved

Magnetotransport properties of a single grain boundary in a bulk La-Ca-Mn-O material

peer reviewedBesides the "intrinsic" colossal magnetoresistance effect observed in single crystals, the polycrystalline manganate compounds also exhibit an "extrinsic" magnetoresistance related to the presence of grain boundaries. We report electrical transport and magnetic measurements carried out on a bigrain sample extracted from a floating zone method-grown rod of calcium doped lanthanum manganate. Electrical resistance was measured both within a grain and across the grain boundary, between 20 and 300 K and from 0 to 8 T. Magnetoresistance values up to 99% are reached within the grain. The temperature dependence of the resistance across the grain boundary displays a "foot-like" feature towards the bottom of the transition. Low field and high field magnetoresistance effects are examined. We compare our results for a "bulk" grain boundary to those obtained by other authors for bicrystal thin films and bulk polycrystalline materials. (C) 2001 American Institute of Physics

Cu doping as a tool for understanding CMR

Doping at the Mn-site in CMR manganate-based perovskites has been shown to affect strongly the physical properties of those compounds. We study here the effect of copper substitution in the low doping range on the electrical transport properties of La0.7Ca0.3MnO3. It turns out that the transition temperature decrease observed in doped samples can be drastically reduced by addition of silicon dioxide SiO2. It is shown that copper is trapped in a secondary phase composed of La,Ca,Si,Cu and O. The resultant Mn-site vacancies appear to be less detrimental to the electronic conduction than the likely antiferromagnetic clusters induced by the copper ions in the Mn-O network

Study of the morphology of copper hydroxynitrate nanoplatelets obtained by controlled double jet precipitation and urea hydrolysis

A copper hydroxynitrate of stoichiometry Cu-2(OH)(3)NO3, analogous to the layered double hydroxide family, was synthesized by the so-called controlled double jet precipitation technique, and by hydrolysis of urea in the presence of copper nitrate. Special attention has been focused on the size, morphology and agglomeration tendency of the particles. The aim of this work is to define the optimum precipitation conditions in terms of quality and dispersability of the recovered product. Such platelet-like particles Can be used as anisotropic fillers in nanocomposite materials. Several reaction parameters such as flow and concentration of the reactant solutions, design of the reactor and addition of a growth modifier were studied. (C) 2003 Elsevier -Science B.V. All rights reserved

Structural and electrical properties of tellurovanadate glasses containing Li2O

Glassy materials are promising intercalation compounds, due to their open network structure and absence of grain boundaries. Some glasses containing alkali ions and a high concentration of transition metal ions can present mixed ionic-electronic conductivity and are therefore potential candidates for application as cathode material in Li-ion batteries. The present work is devoted to the ternary system xLi(2)O-(1-x)[0.3V(2)O(5)-0.7TeO(2)] with 0 <= x <= 0.4. These compounds were prepared by heat treatment in air at 800 degrees C followed by traditional quenching. Raman spectroscopy and V-51 nuclear magnetic resonance measurements were performed in order to highlight the structural short range order modifications induced by the introduction of the Li2O network modifier. These structural effects can be related to the electrical behaviour, as studied by complex impedance spectroscopy measurements. (c) 2006 Elsevier B.V. All rights reserved

Electrical transport and magnetic properties of Mn3O4-La0.7Ca0.3MnO3 ceramic composites prepared by a one-step spray-drying technique

peer reviewedLa0.7Ca0.3MnO3/Mn3O4 composites can be synthesized in one step by thermal treatment of a spray-dried precursor, instead of mixing pre-synthesized powders. Another advantage of this composite system is that a long sintering step can be used without leading to significant modification of the manganite composition. The percolation threshold is reached at ~ 20 vol% of manganite phase. The 77 K low field magnetoresistance is enhanced to ~ 11 % at 0.15 T when the composition is close to the percolation threshold. (c) 2007 Elsevier Ltd. All rights reserved

Low-field magnetoresistance in La0.7Ca0.3MnO3 manganite compounds prepared by the spray drying technique

peer reviewedCalcium-substituted lanthanum manganite compounds were synthesized by the spray drying technique. This method - whose main advantages are versatility, high reproducibility and scalability - yields small grain materials of high homogeneity and displaying low-field magnetoresistance effects. We report about the physical and chemical characterizations of these samples in order to investigate the potential interest of spray drying for the production of materials for low-field magnetoresistance applications. We have studied the dependence of the low-field magnetoresistance on the temperature and duration of the thermal treatment applied to the pelletized powders. The issue of the shape anisotropy (demagnetisation effects) influence on the magnetoresistance properties has also been dealt with. (C) 2005 Springer Science + Business Media, Inc

Physicochemical And Biochemical Characterization Of Non-Biodegradable Cellulose In Miocene Gymnosperm Wood From The Entre-Sambre-Et-Meuse, Southern Belgium

Specimens of Miocene fossil wood from the Entre-Sambre-et-Meuse karsts (southern Belgium) were examined using physicochemical and biochemical techniques in order to understand the reasons for the exceptional preservation of these fossilized remains after 15 million years. Structural and chemical changes were assessed by comparing the structural features of the fossil samples with those of their modern counterpart, Metaseguoia. Solid state C-13 nuclear magnetic resonance (NMR) and microscopic analysis showed good preservation of the cellulose structure in the fossil wood from the Florennes peat deposit. Despite the substantial cellulose fraction available in the fossil tissue, an enzymatic degradation test and a biochemical methane potential assay showed that the fossil cellulose could not be degraded by cellulases and anaerobic microorganisms usually involved in the biodegradation of organic matter. Moreover, the cellulose structure (crystallinity and surface area) seemed to have no effect on cellulose biodegradability in these Miocene fossil wood samples. On the basis of our observations, we suggest that the presence of a modified lignin structure could greatly influence cellulose preservation/biodegradability

Synthesis and characterization of inorganic, lamellar nanofillers with high aspect ratio

Mesostructured silica phases with lamellar structure were prepared by the liquid crystal templating (LCT) technique, from double chain alkylammonium surfactant and sodium silicate or tetraethylorthosilicate (TEOS) silica precursors. The structural characterization of these phases is presented and compared. Surface modification of the silica layers, together with elimination of the organic template, is considered. Finally, a representative model of the microstructural organization is proposed. (c) 2006 Elsevier Ltd. All rights reserved